Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
PS-NB-I with an Immersion Installation Type Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
The PS-NB-I sensors are LoRaWAN Pressure Sensors for Internet of Things solutions. PS-NB-I can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
The PS-NB series sensors include Immersion Type and Thread Installation Type (PS-NB-T), which support different pressure ranges that can be used for different measurement requirements.
The LoRa wireless technology used in PS-NB-I allows the device to send data and reach extremely long ranges at low data rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
PS-NB-I supports BLE configure and wireless OTA update which make users easy to use.
PS-NB-I is powered by an 8500mAh Li-SOCI2 battery, it is designed for long-term use up to 5 years.
Each PS-NB-I is pre-loaded with a set of unique keys for LoRaWAN registrations, register these keys to the local LoRaWAN server and it will auto-connect after power on.
NB-IoT Bands: B1/B2/B3/B4/B5/B8/B12/B13/B17/B18/B19/B20/B25/B28/B66/B70/B85 @H-FDD
Ultra-low power consumption
Measure the Differential Pressure of two input
Different pressure ranges available ( from 100Pa to 10KPa )
Monitor Battery Level
Multiply Sampling and one uplink
Support Bluetooth v5.1 remote configure and update firmware
Uplink on periodically or Alarm Input
Downlink to change configure
8500mAh Battery for long-term use
IP66 Waterproof Enclosure
Uplink via MQTT, MQTTs, TCP, or UDP
Nano SIM card slot for NB-IoT SIM
Supply Voltage: 2.5v ~ 3.6v
Operating Temperature: -40 ~ 80°C
NB-IoT Module: BC660K-GL
B1 @H-FDD: 2100MHz
B2 @H-FDD: 1900MHz
B3 @H-FDD: 1800MHz
B4 @H-FDD: 2100MHz
B5 @H-FDD: 860MHz
B8 @H-FDD: 900MHz
B12 @H-FDD: 720MHz
B13 @H-FDD: 740MHz
B17 @H-FDD: 730MHz
B18 @H-FDD: 870MHz
B19 @H-FDD: 870MHz
B20 @H-FDD: 790MHz
B25 @H-FDD: 1900MHz
B28 @H-FDD: 750MHz
B66 @H-FDD: 2000MHz
B70 @H-FDD: 2000MHz
B85 @H-FDD: 700MHz
Range: 0 ~ 20mA
Accuracy: 0.02mA
Resolution: 0.001mA
Range: 0 ~ 30v
Accuracy: 0.02v
Resolution: 0.001v
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuous current: 130mA
Max boost current: 2A, 1 second
Power Consumption:
STOP Mode: 10uA @ 3.3v
Max transmit power: 350mA@3.3v
Indoor Air Control
Filter Clogging Detect
Part Number: PS-NB-Ixx-YY
Ixx: immersion Version -xx meter cable
Pls Leave a message or send a note to sales@dwmzone.com with the cable length which is out of the options.
YY: The default frequency band
GE: General version ( Exclude SIM card)
1T: with 1NCE * 10 years 500MB SIM card and Pre-configure to ThingsEye server
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM23061502
The Dragino PS-LB-T or PS-LB-I sensors are LoRaWAN Pressure Sensor for Internet of Things solution. PS-LB can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM25030201
PS-NB-D NB-IoT Differential Pressure Sensor uses Differential Pressure Sensor includes various models to cover NB-IoT wireless transmission and different ranges of pressure measurements.
Reference: DWM23072205
DDS20-LB is a LoRaWAN Ultrasonic liquid level sensor supports BLE configure and wireless OTA update uses none-contact method to measure the height of liquid in a container without opening the container, and send the value via LoRaWAN network to IoT Server.
Reference: DWM24030201
SN50V3-LS Solar Powered LoRaWAN Sensor Node It is designed for outdoor use and powered by a solar panel + li-on battery for long-term use and Supports BLE configuration and wireless OTA update .
Reference: DWM23072204
The DDS45-LB is a LoRaWAN Distance Detection Sensor supports BLE configure and wireless OTA update which is usedultrasonic sensing technology for distance measurement for Internet of Things solution.
Reference: DWM23072201
The SW3L-LB is a new LoRaWAN Outdoor water Flow Sensor that supports BLE configuration and wireless OTA update which is used to detect water flow volume and uplink to the IoT server via the LoRaWAN network it can be used for indoor and outdoor use.
Reference: DWM25011301
DS20L LoRaWAN smart distance detector works with a standard LoRaWAN gateway which measures a range between 3cm ~ 200cm targets the applications such as smart cities, and building automation.
Reference: DWM25021902
The SDI-12-LS is a solar-powered SDI-12 to LoRaWAN Converter designed for Smart Agriculture solutions.
Reference: DWM25022001
DDS75-LS is powered by a solar-powered LoRaWAN Distance Detection Sensor that can be applied to scenarios such as horizontal distance measurement, liquid level measurement, parking management system, object proximity, and presence detection, etc.
Reference: DWM23122503
TrackerD-LS is an Open Source LoRaWAN Asset Tracker based on ESP32 MCU get the location data via GPS and set it to IoT server via LoRaWAN network. supports Motion Detection this feature will save power when no motion is detected.
Reference: DWM24030101
RS485-LS is a Solar Powered RS485/ UART to LoRaWAN Converter Users can connect the RS485 or UART sensor to the RS485-LS converter Supports BLE configuration and wireless OTA update.
Reference: DWM25021601
The S31B-LS is a solar-powered LoRaWAN Temperature and Humidity Sensor for the Internet of Things solution that supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: DWM23122501
TS01-LB is an outdoor LoRaWAN Tilting Sensor which is specially designed for detecting the angle of trees, buildings or large scale equipment measures pitch and roll angle and converts to LoRaWAN wireless data and sends to IoT platform via LoRaWAN network.
Reference: DWM24030102
TS01-LS is powered by a solar panel LoRaWAN Tilting Sensor for detecting large-scale equipment and supports BLE configuration and wireless OTA update.
Reference: DWM23122602
LA66 USB LoRaWAN Adapter v2 is designed to fast turn USB devices to support LoRaWAN wireless features which can easy to add LoRaWAN wireless feature to PC / Mobile phone or an embedded device that has USB Interface.
Reference: DWM25030401
WL03A-LS is a Solar-Powered LoRaWAN Rope Type Water Leak Controller with the WL03A-LS + Water Leak Cable on the ground to detect water leakage. The water leak cable is sensitive, when there is water over the leak cable.
Reference: DWM25030402
The CPL03-LB is a Solar-Powered LoRaWAN Contact Sensor that detects open/close status and uplinks to the IoT server via the LoRaWAN network. Users can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM24090202
The PS-LS-D sensors are powered by solar power + li-on battery with a Differential Pressure Sensor which can measure Air, Water pressure, and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
PS-NB-I with an Immersion Installation Type Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
