Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
D23-LB is a LoRaWAN Temperature Sensor with 3 x DS18B20 supports BLE configure and wireless OTA update.
The D23-LB is a LoRaWAN Temperature Sensor for Internet of Things solution. D23-LB will convert the Temperature reading to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway.
The LoRa wireless technology used in D23-LB allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
The temperature sensor used in D23-LB can measure -55°C ~ 125°C with accuracy ±0.5°C (max ±2.0 °C).
D23-LB supports temperature alarm feature, user can set temperature alarm for instant notice. D23-LB supports Datalog feature, it can save the data when there is no LoRaWAN network and uplink when network recover.
D23-LB supports BLE configure and wireless OTA update which make user easy to use.
D23-LB is powered by 8500mAh Li-SOCI2 battery, it is designed for long term use up to 5 years.
Each D23-LB is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN 1.0.3 Class A
Ultra-low power consumption
2 x DS18B20 Temperature sensors
Measure range -55°C ~ 125°C
Temperature alarm
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
Uplink on periodically
Downlink to change configure
IP66 Waterproof Enclosur
8500mAh Battery for long term use
Supply Voltage: built in 8500mAh Li-SOCI2 battery , 2.5v ~ 3.6v
Operating Temperature: -40 ~ 85°C
Dallas DS18B20
Range: -55 to + 125°C
Accuracy ±0.5°C (max ±2.0 °C).
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuously current: 130mA
Max boost current: 2A, 1 second
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
1 x D22-LB LoRaWAN Waterproof /Outdoor Temperature Sensor
Device Size: 120 * 55 * 200 mm
Device Weight: 372g
D23-LB-XX:
XX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
KZ865: Default frequency band KZ865
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM23050801
SN50V3-LB is the 3rd generation of the LSN50 series generic sensor node built-in BLE support OTA upgrade private LoRa protocol for easy maintenance.
Reference: DWM23060101
The Dragino D20-LB is a LoRaWAN Temperature Sensor for Internet of Things solution. D20S-LB is designed for used in Soil or Road. D20-LB/ D20S-LB will convert the Temperature reading to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway.
Reference: DWM22092804
WSS-04 is a RS485 rain / snow detect sensor. It can monitor Rain or Snow event. RS485 interface to WSC1-L. which can detect and upload the SNOW/Rain Event to the IoT Server via wireless LoRaWAN protocol.
Reference: DWM25030402
The CPL03-LB is a Solar-Powered LoRaWAN Contact Sensor that detects open/close status and uplinks to the IoT server via the LoRaWAN network. Users can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM23021007
The LHT65S-NE117 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor use an external probe uses TI TMP117A NIST traceability temperature sensor, with 0.1°C accuracy in normal temperature range.
Reference: DWM22092802
WSS-03 is a RS485 Air Quality sensor. It can monitor CO2, PM2.5 and PM10 at the same time by RS485 interface to WSC1-L which can detect and upload the environment CO2, PM2.5 and PM10 to the IoT Server via wireless LoRaWAN protocol.
Reference: DWM24030104
LMS01-LS is a LoRaWAN Leaf Moisture Sensor for IoT of Agriculture Powered by a solar panel Supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: DWM24030201
SN50V3-LS Solar Powered LoRaWAN Sensor Node It is designed for outdoor use and powered by a solar panel + li-on battery for long-term use and Supports BLE configuration and wireless OTA update .
Reference: DWM22051403
HP0D is Outdoor LoRaWAN gateway it supports the miner feature from Helium and has a built-in ATECC608 encryption chip. It can be used as a Helium Full Hotspot for the project.
Reference: DWM25030501
The SW3L-LS is a LoRaWAN Flow Sensor. It detects water flow volume and uplinks to the IoT server via the LoRaWAN network. It can detect the water flow status and send an Alarm, to avoid waste from water usage such as a broken toilet case.
Reference: DWM20061503
The LDS01 is a LoRaWAN Door Sensor. It detects door open/close status and will send periodically data every day as well as for each door open/close action. It also count the door open times and calculate last door open duration.
Reference: DWM16092702
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM22092601
WSS-06 is Total Radiation Sensor can be used to measure the total solar radiation in the spectral range of 0.3 to 3 μm (300 to 3000 nm).
Reference: DWM22072103
LA66 is a ready-to-use module that includesLoRaWAN v1.0.4 protocol and also supports open-source peer-to-peer LoRa Protocol for the none-LoRaWAN application.
Reference: DWM18072401
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM25030201
PS-NB-D NB-IoT Differential Pressure Sensor uses Differential Pressure Sensor includes various models to cover NB-IoT wireless transmission and different ranges of pressure measurements.
Reference: DWM22110601
The CPN01 is an NB-IoT Dry Contact Sensor. It detects open/close status and uplinks the info to IoT server via NB-IoT network. User can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM23072203
DDS75-LB LoRaWAN Distance Detection Sensor which supports BLE configure and wireless OTA update is a distance detection sensor that uses ultrasonic sensing technology for distance measurement, and temperature compensation is performed internally to improve the reliability of data.
D23-LB is a LoRaWAN Temperature Sensor with 3 x DS18B20 supports BLE configure and wireless OTA update.
