Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
The PS-LS-I series sensors is powered by 8500mAh Li-SOCI2 battery or solar powered + li-on battery , it is designed for long term use up to 5 years. include a Immersion Type Type Pressure Sensor
The PS-LS-I can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
The LoRa wireless technology used in PS-LS-I allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
PS-LS-I supports BLE configure and wireless OTA update which make user easy to use.
Each PS-LS-I is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN 1.0.3 Class A
Ultra-low power consumption
Measure air / gas or water pressure
Different pressure range available
Thread Installation Type or Immersion Type
Monitor Battery Level
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
Uplink on periodically
Downlink to change configure
Solar panel + 3000mAh Li-on battery (PS-LS)
MCU: 48Mhz ARM
Flash: 256KB
RAM: 64KB
Supply Voltage: Built-in Battery, 2.5v ~ 3.6v
Operating Temperature: -40 ~ 85°C
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
Range: 0 ~ 20mA
Accuracy: 0.02mA
Resolution: 0.001mA
Range: 0 ~ 30v
Accuracy: 0.02v
Resolution: 0.001v
Solar panel + 3000mAh Li-on battery
Capacity: 3000mAh
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
Immersion Type, Probe IP Level: IP68
Measuring Range: Measure range can be customized, up to 100m.
Accuracy: 0.2% F.S
Long-Term Stability: ±0.2% F.S / Year
Storage temperature: -30℃~80℃
Operating temperature: 0℃~50℃
Material: 316 stainless steels
Liquid & Water Pressure / Level detect.
Ixx: lmmersion Version -xx meter cable
Pls Leave a message or send a note to sales@dwmzone.com with the cable length which out of the options.
YY: The default frequency band
AS923: LoRaWAN AS923 band
AU915: LoRaWAN AU915 band
EU433: LoRaWAN EU433 band
EU868: LoRaWAN EU868 band
KR920: LoRaWAN KR920 band
US915: LoRaWAN US915 band
IN865: LoRaWAN IN865 band
CN470: LoRaWAN CN470 band
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM23061502
The Dragino PS-LB-T or PS-LB-I sensors are LoRaWAN Pressure Sensor for Internet of Things solution. PS-LB can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM24022601
The PS-LS-T sensors is powered by solar power + li-on battery with an Thread Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM24022601
The PS-LS-T sensors is powered by solar power + li-on battery with an Thread Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM24081201
PB01 LoRaWAN Button is a LoRaWAN wireless device with one push button. PB01 transfers the signal to IoT server via Long Range LoRaWAN wireless protocol. PB01 also senses the environment temperature & humidity and will also uplink these data to IoT Server.
Reference: DWM24011902
The AQS01-L is an Indoor LoRaWAN Air Quality Sensor is designed to measure the surrounding environment parameters include: CO2, Temperature , Relative Air Humidity and Air pressure, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM24030102
TS01-LS is powered by a solar panel LoRaWAN Tilting Sensor for detecting large-scale equipment and supports BLE configuration and wireless OTA update.
Reference: DWM23072303
The DDS04-LB is a LoRaWAN 4-Channels Distance Sensor upports BLE configure and wireless OTA update for Internet of Things solution. It is capable to add up to four Ultrasonic Sensors to measure four distances at the same time.
Reference: DWM23101801
WSC2-LB is the Main Process Unit for Weather Station solution which is full compatible with LoRaWAN Class C protocol, it can work with standard LoRaWAN gateway.
Reference: DWM23122602
LA66 USB LoRaWAN Adapter v2 is designed to fast turn USB devices to support LoRaWAN wireless features which can easy to add LoRaWAN wireless feature to PC / Mobile phone or an embedded device that has USB Interface.
Reference: DWM24030105
The SPH01-LS is a LoRaWAN Soil pH Sensor powered by Solar for IoT of Agriculture that supports BLE configuration and wireless OTA update.
Reference: DWM24030201
SN50V3-LS Solar Powered LoRaWAN Sensor Node It is designed for outdoor use and powered by a solar panel + li-on battery for long-term use and Supports BLE configuration and wireless OTA update .
Reference: DWM24090202
The PS-LS-D sensors are powered by solar power + li-on battery with a Differential Pressure Sensor which can measure Air, Water pressure, and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM24030104
LMS01-LS is a LoRaWAN Leaf Moisture Sensor for IoT of Agriculture Powered by a solar panel Supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: DWM24090201
The PS-LB-D sensors with a Differential Pressure Type sensor which can measure Air, Water pressure, and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM23122501
TS01-LB is an outdoor LoRaWAN Tilting Sensor which is specially designed for detecting the angle of trees, buildings or large scale equipment measures pitch and roll angle and converts to LoRaWAN wireless data and sends to IoT platform via LoRaWAN network.
Reference: DWM23070102
D23-LB is a LoRaWAN Temperature Sensor with 3 x DS18B20 supports BLE configure and wireless OTA update.
Reference: DWM24090501
The LDS40-LS is Powered by a solar panel + li-on battery with a LiDAR ToF (Time of Flight) Distance Sensor that supports BLE configuration and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity, and presence detection.
Reference: DWM24030101
RS485-LS is a Solar Powered RS485/ UART to LoRaWAN Converter Users can connect the RS485 or UART sensor to the RS485-LS converter Supports BLE configuration and wireless OTA update.
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
