Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The LDS40-LS is Powered by a solar panel + li-on battery with a LiDAR ToF (Time of Flight) Distance Sensor that supports BLE configuration and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity, and presence detection.
The LDS40-LS is Powered by a solar panel + li-on battery with a LiDAR ToF (Time of Flight) Distance Sensor for the Internet of Things solution. It is capable of measuring the distance to objects as close as 0m to 40m. The LiDAR probe uses laser induction technology for distance measurement.
The LDS40-LS can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
It detects the distance between the measured object and the sensor and uploads the value via wireless to the LoRaWAN IoT Server.
The LoRa wireless technology used in LDS40-LS allows the device to send data and reach extremely long ranges at low data rates. It provides ultra-long-range spread spectrum communication and high interference immunity while minimizing current consumption.
LDS40-LS supports BLE configuration and wireless OTA update makes users easy to use.
LDS40-LS is powered by a solar panel + 3000mAh li-on battery, it is designed for long-term use up to 5 years.
Each LDS40-LS is pre-loaded with a set of unique keys for LoRaWAN registrations, register these keys to the local LoRaWAN server and it will auto-connect after powering on.
LoRaWAN 1.0.3 Class A
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
Ultra-low power consumption
Laser technology for distance detection
Measure Distance: 0.1m~40m @ 90% Reflectivity
FOV : 3°
Monitor Battery Level
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
AT Commands to change parameters
Downlink to change configure
Powered by a solar panel + 3000mAh li-on battery
Operating Temperature: -40 ~ 85°C
Storage temperature：-30°C~80°C
Operating temperature: -20°C~60°C
0.1m ~ 40m @ 90% Reflectivity
0.1m ~ 13.5m @ 10% Reflectivity
Distance resolution: 1cm
Ambient light immunity: 100klux
Enclosure rating: IP65
Light source: VCSEL
Central wavelength: 850nm
FOV : 3°
Material of enclosure: ABS+PC
Wire length: 75cm
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
solar panel + 3000mAh li-on battery
Self-Discharge: <1% / Year @ 25°C
Max continuous current: 130mA
Max boost current: 2A, 1 second
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
Horizontal distance measurement
Parking management system
Object proximity and presence detection
Intelligent trash can management system
Robot obstacle avoidance
Automatic control
Sewer
Part Number: LDS40-LS-XXX
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
LDS40-LS LoRaWAN LiDAR Distance Sensor x 1
Package Dimension:150*120*55mm
Weight: 220g
Reference: DWM21051602
The LDS02 is a LoRaWAN Door Sensor. It detects door open/close status build in a sx1262 Lora chipset and 2 x AAA batteries and target for long time use.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM23072208
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: DWM23072305
The LDS40-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor supports BLE configure and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: DWM24090202
The PS-LS-D sensors are powered by solar power + li-on battery with a Differential Pressure Sensor which can measure Air, Water pressure, and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM23070102
D23-LB is a LoRaWAN Temperature Sensor with 3 x DS18B20 supports BLE configure and wireless OTA update.
Reference: DWM24022601
The PS-LS-T sensors is powered by solar power + li-on battery with an Thread Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM23122501
TS01-LB is an outdoor LoRaWAN Tilting Sensor which is specially designed for detecting the angle of trees, buildings or large scale equipment measures pitch and roll angle and converts to LoRaWAN wireless data and sends to IoT platform via LoRaWAN network.
Reference: DWM24030101
RS485-LS is a Solar Powered RS485/ UART to LoRaWAN Converter Users can connect the RS485 or UART sensor to the RS485-LS converter Supports BLE configuration and wireless OTA update.
Reference: DWM24030201
SN50V3-LS Solar Powered LoRaWAN Sensor Node It is designed for outdoor use and powered by a solar panel + li-on battery for long-term use and Supports BLE configuration and wireless OTA update .
Reference: DWM24030103
The SE01-LS LoRaWAN Soil Moisture & EC Sensor is powered by Solar for IoT of Agriculture and supports BLE configuration and wireless OTA update.
Reference: DWM24011902
The AQS01-L is an Indoor LoRaWAN Air Quality Sensor is designed to measure the surrounding environment parameters include: CO2, Temperature , Relative Air Humidity and Air pressure, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM24030105
The SPH01-LS is a LoRaWAN Soil pH Sensor powered by Solar for IoT of Agriculture that supports BLE configuration and wireless OTA update.
Reference: DWM23072303
The DDS04-LB is a LoRaWAN 4-Channels Distance Sensor upports BLE configure and wireless OTA update for Internet of Things solution. It is capable to add up to four Ultrasonic Sensors to measure four distances at the same time.
Reference: DWM24081201
PB01 LoRaWAN Button is a LoRaWAN wireless device with one push button. PB01 transfers the signal to IoT server via Long Range LoRaWAN wireless protocol. PB01 also senses the environment temperature & humidity and will also uplink these data to IoT Server.
Reference: DWM23101801
WSC2-LB is the Main Process Unit for Weather Station solution which is full compatible with LoRaWAN Class C protocol, it can work with standard LoRaWAN gateway.
Reference: DWM24030102
TS01-LS is powered by a solar panel LoRaWAN Tilting Sensor for detecting large-scale equipment and supports BLE configuration and wireless OTA update.
Reference: DWM23122503
TrackerD-LS is an Open Source LoRaWAN Asset Tracker based on ESP32 MCU get the location data via GPS and set it to IoT server via LoRaWAN network. supports Motion Detection this feature will save power when no motion is detected.
Reference: DWM24030104
LMS01-LS is a LoRaWAN Leaf Moisture Sensor for IoT of Agriculture Powered by a solar panel Supports BLE configuration and wireless OTA update which makes users easy to use.
The LDS40-LS is Powered by a solar panel + li-on battery with a LiDAR ToF (Time of Flight) Distance Sensor that supports BLE configuration and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity, and presence detection.
