Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
The Dragino LDS12-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor for Internet of Things solution. It is capable to measure the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m)! The LiDAR probe uses laser induction technology for distance measurement.
The LDS12-LB can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
It detects the distance between the measured object and the sensor, and uploads the value via wireless to LoRaWAN IoT Server.
The LoRa wireless technology used in LDS12-LB allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
LDS12-LB supports BLE configure and wireless OTA update which make user easy to use.
LDS12-LB is powered by 8500mAh Li-SOCI2 battery, it is designed for long term use up to 5 years.
Each LDS12-LB is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN 1.0.3 Class A
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
Ultra-low power consumption
Laser technology for distance detection
Measure Distance: 0.1m~12m @ 90% Reflectivity
Accuracy : ±5cm@(0.1-6m), ±1%@(6m-12m)
FOV : 3.6°
Monitor Battery Level
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
AT Commands to change parameters
Downlink to change configure
8500mAh Battery for long term use
Supply Voltage: built in 8500mAh Li-SOCI2 battery , 2.5v ~ 3.6v
Operating Temperature: -40 ~ 85°C
Storage temperature：-20℃~75℃
Operating temperature : -20℃~60℃
0.1m ~ 12m @ 90% Reflectivity
0.1m ~ 4m @ 10% Reflectivity
Accuracy : ±5cm@(0.1-6m), ±1%@(6m-12m)
Distance resolution : 5mm
Ambient light immunity : 70klux
Enclosure rating : IP65
Light source : LED
Central wavelength : 850nm
FOV : 3.6°
Material of enclosure : ABS+PC
Wire length : 25cm
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuously current: 130mA
Max boost current: 2A, 1 second
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
Horizontal distance measurement
Parking management syste
Object proximity and presence detection
Intelligent trash can management system
Robot obstacle avoidance
Automatic control
Sewer
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Datasheet
Decoder
Firmware
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM23122501
TS01-LB is an outdoor LoRaWAN Tilting Sensor which is specially designed for detecting the angle of trees, buildings or large scale equipment measures pitch and roll angle and converts to LoRaWAN wireless data and sends to IoT platform via LoRaWAN network.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20033101
ER18505+SPC1520 Super Pulse Cap 4000mAh Li/SOCI2 unchargable battery for LSN50 Sensor nodes.
Reference: DWM18110901
Setting up a LoRa peer-2-peer communication by using CY8CKIT-062-BLE with Arduino Shield (Dragino LoRa, RFM95W).
Reference: DWM25020701
The RS485-NB is an RS485 / UART to NB-IoT Converter for IOT applications that can read sensor data and upload via the NB-IoT network to the IoT server supports BLE configuration and OTA update which makes it users easy to use.
Reference: DWM23021003
The MDS200-NB is an NB-IoT Microwave Radar distance sensor. It uses a 24Ghz Microwave to detect the distance between the sensor and different objects. It can sense the correct distance even if there is water or thick dust on the sensor.
Reference: DWM22101701
DWM-M702 seven-in-one sensor module is a cost-effective digital serial port output sensor module, which adopts 485/UART output mode and integrates CO2, HCHO, TVOC,PM2.5,PM10, temperature and humidity.
Reference: DWM25022001
DDS75-LS is powered by a solar-powered LoRaWAN Distance Detection Sensor that can be applied to scenarios such as horizontal distance measurement, liquid level measurement, parking management system, object proximity, and presence detection, etc.
Reference: DWM21010102
BCN01 is designed for the use together with LBT1 LoRaWAN Indoor Position Solution base on NORDIC NRF52832 IC and support Bluetooth 4.2 protocol.
Reference: DWM23072301
The CPL03-LB is a LoRaWAN Contact Sensor supports BLE configure and wireless OTA update. It detects open/close status and uplinks to IoT server via LoRaWAN network. user can see the dry contact status, open time, open counts in the IoT Server.
Reference: DWM23072205
DDS20-LB is a LoRaWAN Ultrasonic liquid level sensor supports BLE configure and wireless OTA update uses none-contact method to measure the height of liquid in a container without opening the container, and send the value via LoRaWAN network to IoT Server.
Reference: DWM25011502
D22-NB is an NB-IoT Temperature Sensor that supports two Temperature Sensor probes which are based on DS18B20 convert the Temperature reading to upload the sensor data sent to the IoT platform via the NB-IoT network.
Reference: DWM21010103
The LSN50v2-D20 is a LoRaWAN Temperature Sensor for Internet of Things solution. It can be used to measure the temperature of air, liquid or object, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM17111202
LoRaST 433MHz /470MHz /868MHz /915MHz Open Source Long Range Wireless LoRa Transceiver is a small wireless transceiver module offers a very compelling mix of long range, low power consumption and secure data transmission.
Reference: DWM22092804
WSS-04 is a RS485 rain / snow detect sensor. It can monitor Rain or Snow event. RS485 interface to WSC1-L. which can detect and upload the SNOW/Rain Event to the IoT Server via wireless LoRaWAN protocol.
Reference: DWM23070103
LHT65N-PIR built-in Temperature & Humidity sensor and has an external PIR Probe it can detect environment Temperature & Humdity also detects People Activity via PIR probe and them send these info to LoRaWAN IoT Server.
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
