Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The Dragino RS485-LN is a RS485 / UART to LoRaWAN Converter. It converts the RS485 and UART devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
The Dragino RS485-BL is a RS485 / UART to LoRaWAN Converter for Internet of Things solutions.User can connect RS485 or UART sensor to RS485-BL converter, and configure RS485-BL to periodically read sensor data and upload via LoRaWAN network to IoT server.
RS485-BL can interface to RS485 sensor , 3.3v/5v UART sensor or interrupt sensor. RS485-BL provides a 3.3v output and a 5v output to power external sensors. Both output voltage are controllable
to minimize the total system power consumption.
RS485-BL is IP67 waterproof and powered by 8500mAh Li-SOCI2 battery, It is designed for long term use for several years.
RS485-BL runs standard LoRaWAN 1.0.3 in Class A. It can reach long transfer range and easy to intergrate with LoRaWAN compatible gateway and IoT server.
Each RS485-BL pre-loads with a set of unique keys for LoRaWAN registration, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN v1.0.3 Class A
Ultra low power consumption
RS485 interface for RS485/ Modbus sensor
3.3 / 5v UART interface for sensor
High capacity 8500 mAh Li-SOCI2 battery
Bands: CN470/EU433/KR920/US915
EU868/AS923/AU915/IN865
AT Commands to change parameters
Uplink on periodically or Interrupt
Downlink to change configure
Smart Buildings & Home Automation
Logistics and Supply Chain Management
Smart Metering
Smart Agriculture
Smart Cities
Smart Factory
Package Includes:
1 x RS485-LN LoRaWAN RS485/UART Converter
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
12: With M12 IP68 waterproof cable hole(default version)
16: With M16 IP68 waterproof cable hole
Device Size:13.0x 5 x 4.5 cm
Device Weight: 150g
Package Size / pcs:14.0x 8x 5 cm
Weight / pcs: 180g
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM20022602
The Dragino RS485-LN is a RS485 to LoRaWAN Converter. It converts the RS485 devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM23090801
The AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM22091302
NSPH01 NB-IoT Soil PH Sensor designed to measure the soil pH and soil temperature which include TCP, MQTT, UDP and CoAP for different application requirement for IoT of Agriculture.
Reference: DWM23122603
The WL03A-NB is a NB-IoT None-Position Rope Type Water Leak Controller. User can lay the WL03A-NB + Water Leak Cable on the ground to detect water leakage supports BLE configure and OTA update.
Reference: DWM23122503
TrackerD-LS is an Open Source LoRaWAN Asset Tracker based on ESP32 MCU get the location data via GPS and set it to IoT server via LoRaWAN network. supports Motion Detection this feature will save power when no motion is detected.
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM22082506
The LDDS04 is a LoRaWAN 4-Channels Distance Sensor for Internet of Things solution. It is capable to add up to four Ultrasonic Sensors to measure four distances at the same time.
Reference: DWM24011402
The SPH01-NB is NB-IoT Soil pH Sensor for IoT of Agriculture. It is designed to measure the soil PH and soil temperature, so to send to the platform to analyze the soil acid or alkali level.
Reference: DWM23072204
The DDS45-LB is a LoRaWAN Distance Detection Sensor supports BLE configure and wireless OTA update which is usedultrasonic sensing technology for distance measurement for Internet of Things solution.
Reference: DWM19090601
The LM502 use the newest LoRa Modem SX1262 which provide high transmit power for ultra long range, ultra low power communication for LPWAN application.
Reference: DWM22122902
LG01v2 uses Open Source Linux system design for peer to peer single channel LoRa protocol instead of LoRaWAN protocol,lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet or Cellular Network (via Optional 4G module).
Reference: DWM22051403
HP0D is Outdoor LoRaWAN gateway it supports the miner feature from Helium and has a built-in ATECC608 encryption chip. It can be used as a Helium Full Hotspot for the project.
Reference: DWM22092801
WSS-01 RS485 Rain Gauge is a weather monitor instrument to monitor rainfall.
Reference: DWM22091402
Dragino NDS01 is a NB-IOT Door Sensor for Internet of Things solution. It is used to detect the open/close event for door and uplink the event to IoT server via NB-IoT network.
Reference: DWM18110901
Setting up a LoRa peer-2-peer communication by using CY8CKIT-062-BLE with Arduino Shield (Dragino LoRa, RFM95W).
The Dragino RS485-LN is a RS485 / UART to LoRaWAN Converter. It converts the RS485 and UART devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
