Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
NBSN95 is a Long-Range NB-IoT Sensor Node. It is designed for outdoor data logging and powered by 8500mAh Li/SOCl2 battery for long term use and secure data transmission. System Integrator can use NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution. NBSN95 is easy to program, create and connect things everywhere.
Narrowband-Internet of Things (NB-IoT) is a standards-based low power wide area (LPWA) technology developed to enable a wide range of new IoT devices and services. NB-IoT significantly improves the power consumption of user devices, system capacity and spectrum efficiency, especially in deep coverage.
To use NBSN95, user needs to check if there is NB-IoT coverage in local area and with the bands NBSN95 supports. If the local operate support it, user needs to get a NB-IoT SIM card from local operator and install NBSN95 to get NB-IoT network connection.
NBSN95 is an open-source project. It is based on the STM32L072CZT6 ultra-low-power ARM® Cortex®-M0+ micro controller. Developers can get completely software and hardware design files and adapter for their projects.
STM32L072CZT6 MCU
NB-IoT Bands: B1/B3/B8/B5/B20/B28 @H-FDD
Pre-load bootloader on USART1/USART2
MDK-ARM Version 5.24a IDE
I2C, LPUSART1, USB, SPI2
3x12bit ADC, 1x12bit DAC
20xDigital I/O
Open-source hardware / software
IP66 Waterproof Enclosure
Ultra-Low Power consumption
AT Commands to change parameters
Micro SIM card slot for NB-IoT SIM
8.5 Ah Battery for long term use
Wireless Alarm and Security Systems
Home and Building Automation
Automated Meter Reading
Industrial Monitoring and Control
Long range Irrigation Systems,etc.
Module: Quectel BC95-G
Support Bands
- B1 @H-FDD: 2100MHz
- B3 @H-FDD: 1800MHz
- B8 @H-FDD: 900MHz
- B5 @H-FDD: 850MHz
- B20 @H-FDD: 800MHz
- B28 @H-FDD: 700MHz
Protocol: CoAP, UDP, MQTT
MCU: STM32L072CZT6
Flash:192KB
SRAM:20KB
EEPROM:6KB
Clock Speed: 32Mhz
Absolute Maximum Ratings:
VCC: 0.5v ~ 3.9v
Operating Temperature: -40 ~ 85°C
I/O pins: 0.5v ~ VCC+0.5V
Supply Voltage: 1.8v ~ 3.6v
Operating Temperature: -40 ~ 85°C
I/O pins: Refer STM32L072CZT6 datasheet
STOP Mode: 10 μA @ 3.3v
See Power Analyze Document for more.
Li/SOCI2 unchargable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuously current: 500mA
Max boost current: 2A, 1 second
1 x NBSN95 NB-IoT Sensor Node
1 x External NB-IoT antenna
Device Size: Device Size: 10 x 4.0 x 4.2 cm
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM20022602
The Dragino RS485-LN is a RS485 to LoRaWAN Converter. It converts the RS485 devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM20072901
The DLOS8 Outdoor LoRaWAN Gateway includes 1pcs SX1301 and 2pcs SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM22092601
WSS-06 is Total Radiation Sensor can be used to measure the total solar radiation in the spectral range of 0.3 to 3 μm (300 to 3000 nm).
Reference: DWM25022201
The DDS45-LS solar-powered LoRaWAN Distance Detection Sensor can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity, and presence detection, intelligent trash can management system, etc.
Reference: DWM22092702
ASR6601SE is a general LPWAN Wireless Communication SoC, with integrated RF Transceiver, Modem and a 32-bit RISC MCU. The MCU uses ARM Cortex M4, with 48 MHz operation frequency.
Reference: DWM23101801
WSC2-LB is the Main Process Unit for Weather Station solution which is full compatible with LoRaWAN Class C protocol, it can work with standard LoRaWAN gateway.
Reference: DWM22092804
WSS-04 is a RS485 rain / snow detect sensor. It can monitor Rain or Snow event. RS485 interface to WSC1-L. which can detect and upload the SNOW/Rain Event to the IoT Server via wireless LoRaWAN protocol.
Reference: DWM18122002
Free Shipping LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM23070201
S31-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
Reference: DWM23041801
The LHT65N-E2 is a Long Range LoRaWAN Sensor node with a Temperature & Humidity sensor which external sensor connector can be used for more than 10 years.
Reference: DWM24081201
PB01 LoRaWAN Button is a LoRaWAN wireless device with one push button. PB01 transfers the signal to IoT server via Long Range LoRaWAN wireless protocol. PB01 also senses the environment temperature & humidity and will also uplink these data to IoT Server.
Reference: DWM23072201
The SW3L-LB is a new LoRaWAN Outdoor water Flow Sensor that supports BLE configuration and wireless OTA update which is used to detect water flow volume and uplink to the IoT server via the LoRaWAN network it can be used for indoor and outdoor use.
Reference: DWM22071802
The LSN50v2-D23 is a LoRaWAN Temperature Sensor nodes with two sensor cable which are waterproof, moisture-proof and anti-rust for long-term usage . It can be used to measure the temperature of air, liquid or object.
Reference: DWM23070202
S31B-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
Reference: DWM23122603
The WL03A-NB is a NB-IoT None-Position Rope Type Water Leak Controller. User can lay the WL03A-NB + Water Leak Cable on the ground to detect water leakage supports BLE configure and OTA update.
Reference: DWM19090601
The LM502 use the newest LoRa Modem SX1262 which provide high transmit power for ultra long range, ultra low power communication for LPWAN application.
Reference: DWM25022501
The LDS12-LS is a Solar-powered LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor that can measure the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m).
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
