- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular. The LoRa wireless allows users to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity.
LG02-S has Rich Internet Connection method such as WiFi interface, Ethernet port and USB host port. These Interfaces provide flexible methods for users to connect their sensor networks to Internet.
LG02-S can support the LoRaWAN protocol in single frequency and customized LoRa transmit protocol. The design of LG02-S is use the Linux to directly control two sx1276/sx1278 LoRa modules which lets the LoRa can works in full duplex LoRa mode and increase the communication efficiency.
LG02-S can be used to provide a low cost IoT wireless solution to support 50~300 sensor nodes.
Except LoRaWAN mode, LG02-S can support mutiply working mode such as: LoRa repeater mode, MQTT mode, TCP/IP Client mode, TCP/IP Server mode to fit different requirement for IoT connection. Click this link for more info about the modes.
LG02-S base on sx1276 solution which provide a low cost for your IoT network connection. Compare to the cost with normal SX1301 LoRaWAN solution. the LG02-S is only of its 1/4 or less cost. This make the LG02 very suitable to set up small scale LoRa network or use it to extend the coverage of current LoRaWAN network.
Linux Side:
Cellular 4G LTE (optional):
Indoor Version: LG02-XXX-YY.
Outdoor Version: OLG02-XXX-YY.
-XXX:
433: Best Tuned at 433Mhz
868: Best Tuned at 868Mhz
915: Best Tuned at 915Mhz
-YY:
EC25-AU: with Quectel EC25-AU for Latin America, New Zeland, Taiwan
EC25-E:with Quectel EC25-E for EMEA, Korea, Thailand, India.
EC25-A: with Quectel EC25-A for North America/ Rogers/AT&T/T-Mobile.
EC25-J: with Quectek EC25-J for Japan, DOCOMO/SoftBank/ KDDI
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14033102
Brand: Semtech
The RFM96W / RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM16092702
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM18110502
LT-33222-L is The Dragino LT series I/O Modules are Long Range LoRa I/O Controller designed to simplify the installation of I/O monitoring.
Reference: DWM22110603
Recharge PCB Kit is Li-Ion Battery Charger which can be used for LSN50v2 & RS485-BL to replace the default one time battery and connect to solar panel.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM20090101
LoRa Antenna-BLG-AN-040-868MHz /915MHz Glass Fiber antenna for LoRaWAN Gateway LoRa IoT Application.
Reference: DWM24011201
The LDS12-NB is an NB-IoT LiDAR ToF (Time of Flight) Distance Sensor It is capable of measuring the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m) can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection,...
Reference: DWM24030102
TS01-LS is powered by a solar panel LoRaWAN Tilting Sensor for detecting large-scale equipment and supports BLE configuration and wireless OTA update.
Reference: DWM18011503
LGT-92 LoRaWAN GPS Tracker with 9-axis accelerometer is an open source GPS tracker base on Ultra Low Power STM32L072 MCU and SX1276/1278 LoRa Module.
Reference: DWM25022801
The DDS04-LS is a Solar-powered LoRaWAN 4-Channels Distance Sensor that can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
Reference: DWM23041801
The LHT65N-E2 is a Long Range LoRaWAN Sensor node with a Temperature & Humidity sensor which external sensor connector can be used for more than 10 years.
Reference: DWM23072203
DDS75-LB LoRaWAN Distance Detection Sensor, which supports BLE configuration and wireless OTA update, is a distance detection sensor that uses ultrasonic sensing technology for distance measurement, and temperature compensation is performed internally to improve the reliability of data.
Reference: DWM23070101
D22-LB is a LoRaWAN Temperature Sensor with 2 x DS18B20 supports BLE configure and wireless OTA update.
Reference: DWM23072207
The MDS200-LB is a LoRaWAN Microwave Radar distance sensor supports BLE configure and wireless OTA update which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: DWM23050801
SN50V3-LB is the 3rd generation of the LSN50 series generic sensor node built with BLE support, OTA upgrade, and private LoRa protocol for easy maintenance.
Reference: DWM23070204
UV254-LB is a LoRaWAN UVC Radiation Sensor is designed for detecting the intensity of ultraviolet lamps UVC is harmful to human health and to know UVC lamp is operate efficacy and make sure it won't work in unexpected time.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM23072301
The CPL03-LB is a LoRaWAN Contact Sensor supports BLE configure and wireless OTA update. It detects open/close status and uplinks to IoT server via LoRaWAN network. user can see the dry contact status, open time, open counts in the IoT Server.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.