Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Features:
Ultra-Low Power: 0.9 to 3.6 V Operation
-Typical sleep mode current < 0.1 μA; retains state and RAM contents over full supply range; fast wakeup of < 2 μs
-Less than 600 nA with RTC running
-Less than 1 μA with RTC running and radio state retained
-On-chip dc-dc converter allows operation down to 0.9 V.
-Two built-in brown-out detectors cover sleep and active modes
10-Bit Analog to Digital Converter
-Up to 300 ksps
-Up to 18 external inputs
-External pin or internal VREF (no external capacitor required)
-Built-in temperature sensor
-External conversion start input option
-Autonomous burst mode with 16-bit automatic averaging accumulator
Dual Comparators
-Programmable hysteresis and response time
-Configurable as interrupt or reset source
-Low current (< 0.5 μA)
On-Chip Debug
-On-chip debug circuitry facilitates full-speed, non-intrusive in-system debug (No emulator required)
-Provides breakpoints, single stepping
-Inspect/modify memory and registers
-Complete development kit
High-Speed 8051 μC Core
-Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
-Up to 25 MIPS throughput with 25 MHz clock
-Expanded interrupt handler
Memory
-4352 bytes internal data RAM (256 + 4096)
-64 kB Flash; In-system programmable in 1024-byte sectors—1024 bytes are reserved in the 64 kB devices
Transceiver
-Frequency range = 433,470,868,915 MHz ISM Band
-Sensitivity = –121 dBm
-FSK, GFSK, and OOK modulation
-Max output power = +20 dBm
-RF power consumption
- 18.5mA receive
-18 mA @+1 dBm transmit
- 40mA @+13 dBm transmit
- 100mA @+20 dBm transmit
-Data rate = 0.123 to 256 kbps
-Auto-frequency calibration (AFC)
- transmit/receive switch control
-Programmable packet handler
-TX and RX 64 byte FIFOs
-Frequency hopping capability
-On-chip crystal tuning
Digital Peripherals
-19 or 16 port I/O plus 3 GPIO pins; Hardware enhanced UART, SPI, and I2C serial ports available concurrently
-Low power 32-bit SmaRTClock
-Four general purpose 16-bit counter/timers; six channel programmable counter array (PCA)
Clock Sources
-Precision internal oscillators: 24.5 MHz with ±2% accuracy supports UART operation; spread-spectrum mode for reduced EMI; Low power 20 MHz internal oscillator
-External oscillator: Crystal, RC, C, CMOS clock
-SmaRTClock oscillator: 32.768 kHz crystal or self-oscillate
-Can switch between clock sources on-the-fly; useful in power saving modes and in implementing various power saving modes
I/O Port
-19 or 20 port I/O (5 V tolerant except for GPIO_2)
Package
-30-pin SMD (11x25X2.0 mm)
Useful Link:
Click here to view RFM50 datasheet
HopeRF RFDK_RFMxx_DEMO_V2.1 operation manual
2014 ROHS Verification Report for RF Module
ETSI test report for RFM50-868M rf modules
ETSI test report for RFM50-434M rf modules
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM14070801
HopeRF DK / EVB RFduino board which is compatible with Arduino UNO R3 and Arduino IDE.
Reference: DWM15080803
Customized 315MHz /433MHz /868MHz /915MHz Wire antenna.
Reference: DWM17111902
HP206F is 24Bit Barometer sensor, employs a MEMS pressure sensor with an I2C interface to provide accurate temperature, pressure or altitude data.
Reference: DWM15011202
Brand: Semtech
The RFM68W is an ultra-low-cost, fully integrated FSK or OOK transmitter suitable for operation between 310 and 450 MHz, 860 and 870 MHz, as well as 902 and 928 MHz..The RFM68W offers integrated radio performance with cost efficiency and is suited for operation in North America FCC part 15.231, FCC part 15.247 DTS and FHSS modes, 15.249, and Europe EN 300...
Reference: DWM17111901
The TH06W is a digital relative humidity and temperature sensor. This monolithic CMOS IC integrates temperature and humidity sensor elements, an analog-to-digital converter, signal processing, calibration data, and an I2C host interface.
Reference: DWM14032104
RFM22B /RFM23B is Low cost and have 433MHz /868MHz /915MHZ three versions wireless transceivers HopeRFmodule.it's popular used remoter controller,Tag readers,UAV RF Modems,the core chipset is SI4432 and it's from the Silicon labs.
Reference: DWM17081603
The RFM119W is a high performance, highly flexible, low-cost, single-chip (G)FSK/OOK transmitter for various,240 to 960 MHz wireless applications.
Reference: DWM15011303
The RFM65W is a highly integrated RF receiver capable of operation over a wide frequency range, including the 433MHz,868MHz and 915 MHz license-free ISM (Industry Scientific and Medical) frequency bands.TrueRF™ technology enables a lowcost external component count (elimination of the SAW filter) whilst still satisfying ETSI and FCC regulations.
Reference: DWM16050801
HM-TRP series module is one of the hopeRF data link rf module with operating at 433MHz/868MHz/915 MHz and TTL/RS232/RS485 UI is a low cost, high performance transparent FSK transceiver.
Reference: DWM17081602
RFM119ACW is a high performance, highly flexible, low-cost, single-chip (G)FSK/OOK Wireless rf transmitter module for various,240to 960 MHz wireless applications.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15081804
The CMT2250AW is HopeRF CMT single-chip, ultra low power and high performance device that consists of an OOK RF receiver, with 1920, 1527 and 2262 embedded data Decoder and 4 data output pins for various 300 to 480 MHz wireless applications.
Reference: DWM23013001
RFM119B is a RF module with which +20dBm high power and high performance thus to support 127 to 1020 MHz frequency, OOK, (G) FSK modulation.
Reference: DWM19072203
HP5806 is a miniaturized Digital Barometric Air Pressure Sensor with a high accuracy and a low current consumption, capable of measuring both pressure and temperature.
Reference: DWM15081901
The USB Programmer is the configuration interface for the user to program the configuration to CMOSTEK RF procducts with the RFPDK. It connects the module containing RF products via EM-Connector and connects the PC via USB cable. 3 LEDs are available to indicate the working status of the USB programmer.
Reference: DWM19072202
HP203N is 24Bit Barometer sensor, employs a MEMS pressure sensor with an I2C interface to provide accurate temperature, pressure or altitude data.
Reference: DWM15081807
The CMT2257AW is HopeRF CMT single-chip, ultra low power and high performance device that consists of an OOK/(G)FSK RF receiver, with 1920, 1527 and 2262 embedded data Decoder and 4 data output pins for various 300 to 960 MHz wireless applications.
Reference: DWM15123001
Brand: Semtech
HM-TRLR-S series are operating at 433MHz, 868MHz, 915MHz low cost, high performance transparent transceiver with LoRa/FSK/ GFSK/OOK modulation variety.It's mainly use for uav controller and drone data link.
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
