Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.It is designed to measure the soil moisture of saline-alkali soil and loamy soil. The soil sensor uses FDR method to calculate the soil moisture with the compensation from soil temperature and conductivity. It also has been calibrated in factory for Mineral soil type.
The LoRa wireless technology used in LSE01 allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
LSE01 is powered by 4000mA Li-SOCI2 battery, It is designed for long term use up to 10 years.
Each LES01 is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
Features:
* LoRaWAN 1.0.3 Class A
* Ultro low power consumption
* Monitor Soil Moisture
* Monitor Soil Temperature
* Monitor Soil Conductivity Temperature Compensation
* AT Commands to change parameters
* Uplink on periodically
* Downlink to change configure
* IP66 Waterproof Enclosure
* 4000mAh Battery for long term use
Package Content:
* LSE01 Soil Moisture & EC Sensor
Dimension and Weight:
Package:
Size: 195 x 125 x 55 mm
Weight: 420g
LSE01-XXX
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Reference: DWM21051603
The LSNPK01 is a LoRaWAN Soil NPK Sensor for IoT of Agriculturebase. detects soil's Nitrogen, Phosphorus, and Potassium use TDR method, and uploads these values via wireless to LoRaWAN IoT Server.
Reference: DWM21051604
The LLMS01 LoRaWAN Leaf Moisture Sensor for IoT of Agriculture it is designed to measure the leaf moisture and temperature to analyze the leaf status such as : watering, moisturizing, dew, frozen.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM21010104
The LSN50v2-S31 is a LoRaWAN Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM25011303
WSS-09 9 in 1 Sensors Weather Station Kit measures the below values: Wind Speed, Wind Direction, Temperature, Humidity, Air Pressure, Illumination, PM2.5, PM10, Noise & Rain Gauge.
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM22101701
DWM-M702 seven-in-one sensor module is a cost-effective digital serial port output sensor module, which adopts 485/UART output mode and integrates CO2, HCHO, TVOC,PM2.5,PM10, temperature and humidity.
Reference: DWM22082509
The LDS03A is an Open/Close LoRaWAN Door Sensor. It detects door open/close status and uplinks to IoT server via LoRaWAN network. user can see the door status, open duration, open counts in the IoT Server.
Reference: DWM25022601
The MDS200-LS is a solar-powered LoRaWAN Microwave Radar distance sensor. It uses a 24Ghz Microwave to detect the distance between the sensor and different objects. Microwave Radars supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: DWM25101701
The WSC2-Compact-LS is Dragino's 3rd generation Weather Station Kit which includes a LoRaWAN transmitter, a 3 in 1 sensor for temperature/humidity/air pressure , Illuminance sensor and rain gauge .
Reference: DWM18011503
LGT-92 LoRaWAN GPS Tracker with 9-axis accelerometer is an open source GPS tracker base on Ultra Low Power STM32L072 MCU and SX1276/1278 LoRa Module.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM25021901
The TC01/TC11-LB is a LoRaWAN Thermocouple Converter that measures the industrial environment temperature and then uploads it to the IoT server via the LoRaWAN network.
Reference: DWM25063001
The CS01-LS is a solar-powered 4-channel current Sensor Converter. It can be used to monitor the machine's running status and analyze power consumption trends.
Reference: DWM23101802
The RS485-LB is an RS-485 / UART to LoRaWAN Converter for Internet of Things solutions. The user can connect an RS485 or UART sensor to the RS485-LB converter, and configure RS485-LB to periodically read sensor data and upload it via the LoRaWAN network to the IoT server.
Reference: DWM20030401
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: DWM23030701
MH-Z19E NDIR infrared gas module Built-in temperature compensation; and it has UART output and PWM output It uses the principle of non-dispersive infrared (NDIR) to detect CO2 in the air and has good selectivity. No oxygen dependence, long life, etc.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
