Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.It is designed to measure the soil moisture of saline-alkali soil and loamy soil. The soil sensor uses FDR method to calculate the soil moisture with the compensation from soil temperature and conductivity. It also has been calibrated in factory for Mineral soil type.
The LoRa wireless technology used in LSE01 allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
LSE01 is powered by 4000mA Li-SOCI2 battery, It is designed for long term use up to 10 years.
Each LES01 is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
Features:
* LoRaWAN 1.0.3 Class A
* Ultro low power consumption
* Monitor Soil Moisture
* Monitor Soil Temperature
* Monitor Soil Conductivity Temperature Compensation
* AT Commands to change parameters
* Uplink on periodically
* Downlink to change configure
* IP66 Waterproof Enclosure
* 4000mAh Battery for long term use
Package Content:
* LSE01 Soil Moisture & EC Sensor
Dimension and Weight:
Package:
Size: 195 x 125 x 55 mm
Weight: 420g
LSE01-XXX
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Reference: DWM21051603
The LSNPK01 is a LoRaWAN Soil NPK Sensor for IoT of Agriculturebase. detects soil's Nitrogen, Phosphorus, and Potassium use TDR method, and uploads these values via wireless to LoRaWAN IoT Server.
Reference: DWM21051604
The LLMS01 LoRaWAN Leaf Moisture Sensor for IoT of Agriculture it is designed to measure the leaf moisture and temperature to analyze the leaf status such as : watering, moisturizing, dew, frozen.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM25021502
The D23-LS is a solar-powered LoRaWAN Temperature Sensor designed for waterproofing/Outdoor use and supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: DWM25102901
The SCT013G-D-100 Current Sensor work as the sensor of dragino CS01-LB,CS01-LS,CS01-LB2 Current Sensor Converter.
Reference: DWM22072103
LA66 is a ready-to-use module that includesLoRaWAN v1.0.4 protocol and also supports open-source peer-to-peer LoRa Protocol for the none-LoRaWAN application.
Reference: DWM23072303
The DDS04-LB is a LoRaWAN 4-Channels Distance Sensor upports BLE configure and wireless OTA update for Internet of Things solution. It is capable to add up to four Ultrasonic Sensors to measure four distances at the same time.
Reference: DWM24022601
The PS-LS-T sensors is powered by solar power + li-on battery with an Thread Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM24011402
The SPH01-NB is NB-IoT Soil pH Sensor for IoT of Agriculture. It is designed to measure the soil PH and soil temperature, so to send to the platform to analyze the soil acid or alkali level.
Reference: DWM25022101
The DDS75-NB is an NB-IoT Distance Detection Sensor that uses BC660K-GL that detect the distance between the measured object and the sensor and sends the IoT platform via the NB-IoT network.
Reference: DWM23021008
The LHT65S Temperature & Humidity sensor is a Long Range LoRaWAN Sensor. It includes a built-in Temperature & Humidity sensor and has an external sensor connector to connect to an external Temperature Sensor.
Reference: DWM23030701
MH-Z19E NDIR infrared gas module Built-in temperature compensation; and it has UART output and PWM output It uses the principle of non-dispersive infrared (NDIR) to detect CO2 in the air and has good selectivity. No oxygen dependence, long life, etc.
Reference: DWM22082511
The Dragino CPL01 is a LoRaWAN Contact Sensor. It detects open/close status and uplinks to IoT server via LoRaWAN network. user can see the dry contact status, open time, open counts in the IoT Server.
Reference: DWM18110901
Setting up a LoRa peer-2-peer communication by using CY8CKIT-062-BLE with Arduino Shield (Dragino LoRa, RFM95W).
Reference: DWM25030401
WL03A-LS is a Solar-Powered LoRaWAN Rope Type Water Leak Controller with the WL03A-LS + Water Leak Cable on the ground to detect water leakage. The water leak cable is sensitive, when there is water over the leak cable.
Reference: DWM17111202
LoRaST 433MHz /470MHz /868MHz /915MHz Open Source Long Range Wireless LoRa Transceiver is a small wireless transceiver module offers a very compelling mix of long range, low power consumption and secure data transmission.
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM21072702
The LSN50V2-S31B is LoRaWAN Temperature & Humidity Sensor node be used to measure the surrounding environment temperature and relative air humidity for IoT solution.
Reference: DWM21010103
The LSN50v2-D20 is a LoRaWAN Temperature Sensor for Internet of Things solution. It can be used to measure the temperature of air, liquid or object, and then upload to IoT server via LoRaWAN wireless protocol.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
