Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Dragino NDS01 is a NB-IOT Door Sensor for Internet of Things solution. It is used to detect the open/close event for door and uplink the event to IoT server via NB-IoT network.
The Dragino NDS01 is a NB-IOT Door Sensor for Internet of Things solution. It is used to detect the open/close event for door and uplink the event to IoT server via NB-IoT network.
Besides open/close event, NDS01 also has an internal temperature and humidity sensor which can detect the temperature and humidity inside the sensor.
Narrowband-Internet of Things (NB-IoT) is a standards-based low power wide area (LPWA) technology developed to enable a wide range of new IoT devices and services. NB-IoT significantly improves the power consumption of user devices, system capacity and spectrum efficiency, especially in deep coverage.
NDS01 is powered by 2 x AAA batteries for long term use.
NB-IoT Bands: B1/B3/B5/B8/B20/B28 @H-FDD
Ultra-low power consumption
Door Open / Close Detect
Device remove alarm
Uplink Protocol: TCP or UDP
Uplink on periodically
Micro SIM card slot for NB-IoT SIM
2 x AAA LR03 Batteries
Smart Buildings & Home Automation
Logistics and Supply Chain Management
Smart Cities
Smart Factory
Supply Voltage: 2.1v ~ 3.6v
Operating Temperature: -10 ~ 50°C
- B1 @H-FDD: 2100MHz
- B3 @H-FDD: 1800MHz
- B8 @H-FDD: 900MHz
- B5 @H-FDD: 850MHz
- B20 @H-FDD: 800MHz
- B28 @H-FDD: 700MHz
IDEL Mode: 10uA @ 3.3v
Max transmits power: < 500mA@3.3v
Reference: DWM21051602
The LDS02 is a LoRaWAN Door Sensor. It detects door open/close status build in a sx1262 Lora chipset and 2 x AAA batteries and target for long time use.
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM22082509
The LDS03A is an Open/Close LoRaWAN Door Sensor. It detects door open/close status and uplinks to IoT server via LoRaWAN network. user can see the door status, open duration, open counts in the IoT Server.
Reference: DWM21010102
BCN01 is designed for the use together with LBT1 LoRaWAN Indoor Position Solution base on NORDIC NRF52832 IC and support Bluetooth 4.2 protocol.
Reference: DWM22100804
Wireless configuration tool is for the LoRaWAN sensor nodes parameter wireless setting which is t necessary for LoRaWAN sever access.
Reference: DWM23072303
The DDS04-LB is a LoRaWAN 4-Channels Distance Sensor upports BLE configure and wireless OTA update for Internet of Things solution. It is capable to add up to four Ultrasonic Sensors to measure four distances at the same time.
Reference: DWM25021902
The SDI-12-LS is a solar-powered SDI-12 to LoRaWAN Converter designed for Smart Agriculture solutions.
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22122301
The BCN02 is a Bluetooth BLE iBeacon designed for indoor positioning solution. BCN02 is base on Diglog IC and support Bluetooth 5.1 protocol. BCN02 is low power consumption and with 1200mAh battery. With a 500ms broadcast interval, BCN02 can works for 4～5 years.
Reference: DWM23060101
The Dragino D20-LB is a LoRaWAN Temperature Sensor for Internet of Things solution. D20S-LB is designed for used in Soil or Road. D20-LB/ D20S-LB will convert the Temperature reading to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway.
Reference: DWM23030701
MH-Z19E NDIR infrared gas module Built-in temperature compensation; and it has UART output and PWM output It uses the principle of non-dispersive infrared (NDIR) to detect CO2 in the air and has good selectivity. No oxygen dependence, long life, etc.
Reference: DWM22101701
DWM-M702 seven-in-one sensor module is a cost-effective digital serial port output sensor module, which adopts 485/UART output mode and integrates CO2, HCHO, TVOC,PM2.5,PM10, temperature and humidity.
Reference: DWM22051401
Dragino SW3L LoRaWAN Outdoor water Flow Sensor detects water flow volume and uplink to IoT server via LoRaWAN network it can be used at indoor and outdoor use. It has a weatherproof enclosure and industrial level battery to work in low to high temperatures.
Reference: DWM22051301
LT-W208 LoraWAN Soil NPK Sensor node is Suitable for applications with obstacles. Products are widely used in the field of smart agriculture which is based on LoraWAN global free wireless radio frequency.
Reference: DWM20022603
LT-22222-L is The Dragino LT series I/O Modules are Long Range LoRa I/O Controller designed to simplify the installation of I/O monitoring.
Reference: DWM22092803
WSS-07 photosynthetically active radiation sensor is mainly used to measure the photosynthetically active radiation of natural light in the wavelength range of 400-700nm.
Reference: DWM22110603
Recharge PCB Kit is Li-Ion Battery Charger which can be used for LSN50v2 & RS485-BL to replace the default one time battery and connect to solar panel.
Dragino NDS01 is a NB-IOT Door Sensor for Internet of Things solution. It is used to detect the open/close event for door and uplink the event to IoT server via NB-IoT network.
