Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
The Dragino LDS12-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor for Internet of Things solution. It is capable to measure the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m)! The LiDAR probe uses laser induction technology for distance measurement.
The LDS12-LB can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
It detects the distance between the measured object and the sensor, and uploads the value via wireless to LoRaWAN IoT Server.
The LoRa wireless technology used in LDS12-LB allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
LDS12-LB supports BLE configure and wireless OTA update which make user easy to use.
LDS12-LB is powered by 8500mAh Li-SOCI2 battery, it is designed for long term use up to 5 years.
Each LDS12-LB is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN 1.0.3 Class A
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
Ultra-low power consumption
Laser technology for distance detection
Measure Distance: 0.1m~12m @ 90% Reflectivity
Accuracy : ±5cm@(0.1-6m), ±1%@(6m-12m)
FOV : 3.6°
Monitor Battery Level
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
AT Commands to change parameters
Downlink to change configure
8500mAh Battery for long term use
Supply Voltage: built in 8500mAh Li-SOCI2 battery , 2.5v ~ 3.6v
Operating Temperature: -40 ~ 85°C
Storage temperature：-20℃~75℃
Operating temperature : -20℃~60℃
0.1m ~ 12m @ 90% Reflectivity
0.1m ~ 4m @ 10% Reflectivity
Accuracy : ±5cm@(0.1-6m), ±1%@(6m-12m)
Distance resolution : 5mm
Ambient light immunity : 70klux
Enclosure rating : IP65
Light source : LED
Central wavelength : 850nm
FOV : 3.6°
Material of enclosure : ABS+PC
Wire length : 25cm
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuously current: 130mA
Max boost current: 2A, 1 second
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
Horizontal distance measurement
Parking management syste
Object proximity and presence detection
Intelligent trash can management system
Robot obstacle avoidance
Automatic control
Sewer
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Datasheet
Decoder
Firmware
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM21051607
The Dragino RS485-LN is a RS485 / UART to LoRaWAN Converter. It converts the RS485 and UART devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM24011401
The CPL03-NB is a NB-IoT Contact Sensor for Internet of Things solution. it detects dry contact status, open time, open counts, and then upload to IoT server via NB-IoT network supports BLE configure and OTA update.
Reference: DWM22051403
HP0D is Outdoor LoRaWAN gateway it supports the miner feature from Helium and has a built-in ATECC608 encryption chip. It can be used as a Helium Full Hotspot for the project.
Reference: DWM22092201
WSS-05 is a 4 in 1 RS485 sensor which can monitor Temperature, Humidity, Illuminance and Pressure at the same time which can work with WSC1-L or WSC2-LB weather station main processor.
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM23041802
The LHT65S-E2 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor. It includes a built-in Temperature & Humidity sensor and has an external sensor connector to connect to an external Temperature Sensor.
Reference: DWM19090403
The PG1301 build by SX1301 and SX1257 which is The 10 channels - LoRaWAN GPS Concentrator for Raspberry Pi can connect to 5000 nodes.
Reference: DWM23072207
The MDS200-LB is a LoRaWAN Microwave Radar distance sensor supports BLE configure and wireless OTA update which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: DWM23021002
The NDS03A is an Open/Close NB-IoT Door Sensor. It detects door open/close status and uplinks to IoT server via NB-IoT network. NDS03A can connect two door sensors. user can see the door status, open duration, open counts in the IoT Server.
Reference: DWM22051404
LoRaWAN Helium HNT miner Indoor networking antenna available with 433MHz,868MHz and 915MHz.
Reference: DWM24011203
The SE01-NB uses the FDR method to calculate the soil moisture with the compensation from soil temperature and conductivity detects Soil Moisture, Soil Temperature and Soil Conductivity, and uploads the value via wireless to the NB-IoT IoT Server.
Reference: DWM23101803
The S31-NB and S31B-NB are NB-IoT Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via NB-IoT network.
Reference: DWM24011901
The LMS01-NB is a NB-IoT Leaf Moisture Sensor It is designed to measure the leaf moisture and temperature, so to send to the platform to analyze the leaf status such as: watering, moisturizing, dew, frozen.
Reference: DWM20041401
ER14250+SPC1520 Super Pulse Cap 1200mAh Li/SOCI2 unchargable battery for IOT Sensor nodes.
Reference: DWM23070201
S31-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
