Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
PS-NB-T NB-IOT Thread Installation LoRaWAN Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
The PS-NB-T sensors are LoRaWAN Pressure Sensors for Internet of Things solutions. PS-NB-T can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
The PS-NB series sensors include Immersion Type and Thread Installation Type (PS-NB-I), which support different pressure ranges that can be used for different measurement requirements.
The LoRa wireless technology used in PS-NB-T allows the device to send data and reach extremely long ranges at low data rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
PS-NB-I supports BLE configure and wireless OTA update which make users easy to use.
PS-NB-I is powered by an 8500mAh Li-SOCI2 battery, it is designed for long-term use up to 5 years.
Each PS-NB-I is pre-loaded with a set of unique keys for LoRaWAN registrations, register these keys to the local LoRaWAN server and it will auto-connect after power on.
NB-IoT Bands: B1/B2/B3/B4/B5/B8/B12/B13/B17/B18/B19/B20/B25/B28/B66/B70/B85 @H-FDD
Ultra-low power consumption
Measure the Differential Pressure of two input
Different pressure ranges available ( from 100Pa to 10KPa )
Monitor Battery Level
Multiply Sampling and one uplink
Support Bluetooth v5.1 remote configure and update firmware
Uplink on periodically or Alarm Input
Downlink to change configure
8500mAh Battery for long-term use
IP66 Waterproof Enclosure
Uplink via MQTT, MQTTs, TCP, or UDP
Nano SIM card slot for NB-IoT SIM
Supply Voltage: 2.5v ~ 3.6v
Operating Temperature: -40 ~ 80°C
NB-IoT Module: BC660K-GL
B1 @H-FDD: 2100MHz
B2 @H-FDD: 1900MHz
B3 @H-FDD: 1800MHz
B4 @H-FDD: 2100MHz
B5 @H-FDD: 860MHz
B8 @H-FDD: 900MHz
B12 @H-FDD: 720MHz
B13 @H-FDD: 740MHz
B17 @H-FDD: 730MHz
B18 @H-FDD: 870MHz
B19 @H-FDD: 870MHz
B20 @H-FDD: 790MHz
B25 @H-FDD: 1900MHz
B28 @H-FDD: 750MHz
B66 @H-FDD: 2000MHz
B70 @H-FDD: 2000MHz
B85 @H-FDD: 700MHz
Range: 0 ~ 20mA
Accuracy: 0.02mA
Resolution: 0.001mA
Range: 0 ~ 30v
Accuracy: 0.02v
Resolution: 0.001v
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuous current: 130mA
Max boost current: 2A, 1 second
Power Consumption:
STOP Mode: 10uA @ 3.3v
Max transmit power: 350mA@3.3v
Hersman Pressure Transmitter
Measuring Range:-0.1～0~ 60MPa, see order info.
Accuracy: 0.2% F.S
Long-Term Stability: 0.2% F.S ±0.05%
Overload 200% F.S
Zero Temperature Drift: 0.03% FS/℃(≤100Kpa), 0.02%FS/℃(＞100Kpa)
FS Temperature Drift: 0.003% FS/℃(≤100Kpa), 0.002%FS/℃(＞100Kpa)
Storage temperature: -30℃~80℃
Operating temperature: -20℃~60℃
Connector Type: Various Types, see order info
Hydraulic Pressure
Petrochemical Industry
Health and Medical
Food & Beverage Processing
Auto-controlling house
Constant Pressure Water Supply
Liquid Pressure measuring
Order the suitable thread size and install it to measure the air/liquid pressure
PS-NB-Txx-YY
TXX:
Probe Type:
T20: Thread Type -M20x1.5
T14: Thread Type -M14x1.5
T27: Thread Type -M27x2
TG2: Thread Type -G1/2
TG4: Thread Type -G1/4
TN4: Thread Type -NPT1/4
TP4: Thread Type -PT1/4
PRESSURE RANGE:
A: 0-06MPa
B: 0-1MPa
C: 0-1.6MPa
D: 0-2.5MPa
E: 0-10MPa
F: 0-40MPa
G: 0-60MPa
H: -0.1-0MPa
I: -0.1-0.1MPa
J: 0-5KPa
K: 0-50KPa
L: 0-100KPa
The Pressure sensor has: A,B,C,D,E,F,G,H,I,J,K,L types of sensors which have different ranges as options.
Pls leave a message or send a note to sales@dwmzone.com with the Pressure Range types.
YY: The default frequency band
GE: General version ( Exclude SIM card)
1T: with 1NCE * 10 years 500MB SIM card and Pre-configure to ThingsEye server
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM25030201
PS-NB-D NB-IoT Differential Pressure Sensor uses Differential Pressure Sensor includes various models to cover NB-IoT wireless transmission and different ranges of pressure measurements.
Reference: DWM25030202
PS-NB-I with an Immersion Installation Type Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
Reference: DWM25022402
The DDS20-NB is an NB-IoT Ultrasonic liquid level sensor for the Internet of Things solution. It uses a non-contact method to measure the height of liquid in a container without opening it and send the IoT platform via the NB-IoT network.
Reference: DWM23122601
SDI-12-NB is an SDI-12 to NB-IoT Converter that supports BLE configuration and OTA update and is designed for Smart Agriculture sensors and Weather Station.
Reference: DWM25022101
The DDS75-NB is an NB-IoT Distance Detection Sensor that uses BC660K-GL that detect the distance between the measured object and the sensor and sends the IoT platform via the NB-IoT network.
Reference: DWM25030201
PS-NB-D NB-IoT Differential Pressure Sensor uses Differential Pressure Sensor includes various models to cover NB-IoT wireless transmission and different ranges of pressure measurements.
Reference: DWM23122603
The WL03A-NB is a NB-IoT None-Position Rope Type Water Leak Controller. User can lay the WL03A-NB + Water Leak Cable on the ground to detect water leakage supports BLE configure and OTA update.
Reference: DWM24011402
The SPH01-NB is NB-IoT Soil pH Sensor for IoT of Agriculture. It is designed to measure the soil PH and soil temperature, so to send to the platform to analyze the soil acid or alkali level.
Reference: DWM24011901
The LMS01-NB is a NB-IoT Leaf Moisture Sensor It is designed to measure the leaf moisture and temperature, so to send to the platform to analyze the leaf status such as: watering, moisturizing, dew, frozen.
Reference: DWM25011502
D22-NB is an NB-IoT Temperature Sensor that supports two Temperature Sensor probes which are based on DS18B20 convert the Temperature reading to upload the sensor data sent to the IoT platform via the NB-IoT network.
Reference: DWM25020701
The RS485-NB is an RS485 / UART to NB-IoT Converter for IOT applications that can read sensor data and upload via the NB-IoT network to the IoT server supports BLE configuration and OTA update which makes it users easy to use.
Reference: DWM24011201
The LDS12-NB is an NB-IoT LiDAR ToF (Time of Flight) Distance Sensor It is capable of measuring the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m) can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection,...
Reference: DWM25011504
D23-NB is an NB-IoT Temperature Sensor that supports three Temperature Sensor probes that support BLE configuration and OTA updates to convert the Temperature reading to upload the sensor data sent to the IoT platform via the NB-IoT network.
Reference: DWM25011501
The D20-NB and D20S-NB NB-IoT Temperature Sensors uplink methods including MQTT, MQTTs, UDP & TCP support BLE configure and OTA update, convert the Temperature reading to upload the sensor data sent to the IoT platform via the NB-IoT network.
Reference: DWM23122604
DDS04-NB is an NB-IoT 4-Channels Distance Sensor node that is capable of adding up to four Ultrasonic Sensors to measure four distances at the same time. the sensor needs to be bought separately.
Reference: DWM25011401
SN50v3-NB is a Long Range NB-IoT Sensor Node based on the BC660K-GL model that supports uplink methods including MQTT, MQTTs, UDP & TCP. supports BLE configuration and OTA update supports uplinks to various IoT Servers.
Reference: DWM25022702
The MDS120-NB is an NB-IoT Microwave Radar Distance Sensor that uses Microwave Radar to detect the distance between the sensor and different objects Measure Range: 15 ~ 1200cm.
Reference: DWM23021003
The MDS200-NB is an NB-IoT Microwave Radar distance sensor. It uses a 24Ghz Microwave to detect the distance between the sensor and different objects. It can sense the correct distance even if there is water or thick dust on the sensor.
PS-NB-T NB-IOT Thread Installation LoRaWAN Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
