Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
The module complies with LoRaWAN®1.0.2 protocols. It also supports Lora® Point-to-Point communications. The Module supports BLE 5.0 in addition to LoRa®。 Its RF communication capabilities (LoRa® + BLE) make it suitable for a variety of applications in the IoT field.
Complete documentation of this product can be found on our website documentation page.
You can find a comparison table of our LPWAN modules here.
LoRa® module for Smart City, Smart Agriculture, Smart Industry
I/O ports: UART/I2C/GPIO (optional NFC interface)
Frequency range:863–923 MHz (entire LoRa® high band spectrum)
Low-Power Wireless Systems with 7.8kHz to 500KHz Bandwidth
LoRa® Tx power up to 20dBm
BLE5.0 (Tx power -20 to +4 dBm in 4dB steps)
Serial Wire Debug (SWD) interface
Ultra-Low Power Consumption 2.0µA in sleep mode
512 KB Flash,64KB RAM
Supply voltage:2.0～3.6V
Temperature range:-40°C to +85°C
1pc DWM-RAK4600 Breakout Board
1pc LoRa® Antenna (with Ipex connector)
1pc Bluetooth Antenna (with Ipex connector)
18pc Dupont Lines
Reference: DWM18011701
RAK811 LoRa module complies with the latest LoRaWAN Class A & C protocol specifications, it is simple to access LWPA IOT platforms integrates SX1276 and stm32L with TELEC CE FCC KCC certification.
Reference: DWM20033001
433Mhz built-in LoRa Antenna-straight Spring antenna.
Reference: DWM20053001
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM20053103
Brand: Semtech
The DWM-RAK4600 development board allows access to all serial and GPIO ports for easy configuration. The RAK4600 core module includes nRF52832 MCU and SX1276 LoRa® chip to help you quickly and easily develop/test your firmware.
Reference: DWM24011501
The Raspberry Pi 4 LoRaWAN Kit is Based on RAK2287 Concentrator and Raspberry Pi 4 Model B use it to Build your developer gateway for LoRaWAN application.
Reference: DWM22052401
RAK2247 Pi HAT is a converter board with a Raspberry Pi form factor that enables the RAK2247 LPWAN concentrator module to be mounted on the top of the Raspberry Pi.
Reference: DWM19030101
DWM-RAK7243 Pilot Gateway Pro Kit with Cellular & GPS modules for PoC Raspberry Pi 3B+, RAK2245 Pi HAT,RAK2013 Cellular Pi HAT.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
Reference: DWM24012601
The Meshtastic starter Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
Reference: DWM21031002
Brand: Semtech
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM22022502
RAK2287 /RAK5146 Pi HAT is a converter board with a Raspberry Pi form factor that enables the RAK2287 and RAK5146 LPWAN concentrator module to be mounted on the top of the Raspberry Pi.
Reference: DWM22022501
RAK7268 WisGate Edge Lite 2 Sx1302 Openwrt 8-channel indoor LoRaWAN gateway with built-in Ethernet and Wi-Fi connectivity supports LTE uplink communication connections (optional).
Reference: DWM20052801
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.
Reference: DWM20092102
DWM-RAK7240 8 channels OpenWRT OS DIY Enterprise LoRa Gateway Builtin OpenWRT OS support 16 channels LoRa/4G/WIFI/GPS .
Reference: DWM19022803
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora tracker start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM20053001
Brand: Semtech
The DWM-RAK4260 LPWAN Module is based on Microchip’s ATSAMR34J18B integrating a 32-bit ARM Cortex -M0+ MCU with a LoRa Transceive, provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM20053104
Brand: Semtech
DWM-RAK4260 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.
Reference: DWM20053103
Brand: Semtech
The DWM-RAK4600 development board allows access to all serial and GPIO ports for easy configuration. The RAK4600 core module includes nRF52832 MCU and SX1276 LoRa® chip to help you quickly and easily develop/test your firmware.
Reference: DWM19091702
RAK2247 LoRa Gateway mPCIE Board-RAK833 Concentrator Module is the evolution of RAK833 is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM18050801
RAK811 WisNode LoRa Module development board is compatible with Arduino Development Board. It can also be used as an extension board development with Arduino.
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
