Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
The DWM-RAK4270 LoRa Module includes an STM32L071 MCU and an SX1262 LoRa chip, which supports 8 spreading factors (SF5 ~ SF12) and signal bandwidth that can be adjusted between 7.8 kHz to 500 kHz. It has an ultra-low power consumption of 1.5uA in Sleep mode, but during the Transmit mode, it can reach the maximum output power of 22 dBm. As a receiver, it can achieve a sensitivity of -138 dBm
The module complies with the LoRaWAN®1.0.2 protocol, so it can be used for implementing LoRa® networks or LoRa® point to point communications. The module is suitable for various applications that require long-range data acquisition and low power consumption, such as smart meters, supply chain and logistics tracking, agricultural sensors, smart cities, etc.
This module is expected to be controlled by an external controller through its UART interface by sending a set of AT commands. These AT commands control not only the state of this module but also set the LoRaWan® communication parameters and payloads (see RAK AT Command Manual).
LoRa module is suitable for applications in Smart City, Smart Agriculture, Smart Industry.
LoRa bandwidth range of 7.8 kHz to 500 kHz, SF5 to SF12, BR=0.018～62.5 kb/s
Compact form factor:15x 15.5 x 2.5 mm (LxWxH)
20 pin stamp pad for PCB SMT board-to-board soldering
I/O ports: UART/I2C/GPIO
AT commands control interface
Temperature range:-40°C to +85°C
Supply voltage:2.0to 3.6V
Arm Cortex-M0+ 32-bit RISC core
128kb flash memory with ECC
20kb RAM
6kb of data EEPROM with ECC
Product Dimension:15x 15.5 x 2.5mm
Product Weight:1.08g
Breakout Board
Evaluation Board
Reference: DWM18011701
RAK811 LoRa module complies with the latest LoRaWAN Class A & C protocol specifications, it is simple to access LWPA IOT platforms integrates SX1276 and stm32L with TELEC CE FCC KCC certification.
Reference: DWM20033001
433Mhz built-in LoRa Antenna-straight Spring antenna.
Reference: DWM20053001
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM20053101
Brand: Semtech
DWM-RAK4200 LPWAN Module includes an STM32L071 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 1.5uA in sleep mode and high LoRa® output power up to 19dBm max in work mode.
Reference: DWM19091602
DWM-RAK7243 Pilot LoRas Gateway Pro Kit with GPS modules for PoC Raspberry Pi 3B+, RAK2245 Pi HAT.
Reference: DWM22082501
RAK5010 is a tracker with integrated LTE CAT M1 & NB1, GPS, BLE, and sensors. It is built on the Quectel BG96 LTE CAT M1 & NB1 module, which has an integrated GPS receiver. The MCU running the board is a Nordic nRF52840 controller.
Reference: DWM19091701
DWM-RAK2245 SX1301 8 Channels Stamp Edition is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gatewayOS.
Reference: DWM20060101
Brand: Semtech
DWM-RAK4260 LPWAN Evaluation Board is a WisBlock product that consists of DWM-RAK4260 (DWM-RAK4260 LPWAN Module + Breakout board) and the RAK5005 WisBase
Reference: DWM19022401
DWM-RAK2245 SX1301 8 Channels Stamp Edition is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM24060501
The RAK5148 Semtech SX1280 LPWAN 2.4 GHz Concentrator Module with a ZOE-M8Q GPS chip onboard allows for easy integration into existing routers or other network equipment with LPWAN gateway capabilities.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM22052403
RAK8213 is a multi-band LTE Cat M1/Cat NB1/EGPRS module based on the Quectel BG96 with a standard PCI Express® form factor (Mini PCIe). It offers a maximum data rate of 375Kbps downlink and 375Kbps uplink.
Reference: DWM24012601
The Meshtastic starter Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
Reference: DWM22062302
This Kit consists of a Sensor Node to measures air temperature, air humidity, barometric pressure, and environment luminosity values. Transmitting data periodically to a LoRaWan® server.
Reference: DWM19022803
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora tracker start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
Reference: DWM20092102
DWM-RAK7240 8 channels OpenWRT OS DIY Enterprise LoRa Gateway Builtin OpenWRT OS support 16 channels LoRa/4G/WIFI/GPS .
Reference: DWM19091702
RAK2247 LoRa Gateway mPCIE Board-RAK833 Concentrator Module is the evolution of RAK833 is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM18011601
RAK8211-NB iTracker combines NB-IoT+BLE+GPS+ 5 Sensors Development Board has BLE GPRS GPS three in one module perfectly solves the problem of data interaction and control in the outdoor environment and the three party platform.
Reference: DWM20060102
Brand: Semtech
DWM-RAK4200 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.it's utilized is of an Xbee form factor.
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
