Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
RAK811 Development Kit WisDuo LoRa Module is a combination of the RAK811 chipset and the RAK811 Breakout Board.
RAK811 WisDuo LoRa Module is a combination of the RAK811 chipset and the RAK811 Breakout Board. It is a barebone LoRa Node solution which is a balance between small size and access to GPIOs via a header.
With Semtech SX1276 at its core, the RAK811 WisDuo Module takes advantage of all LoRa features. Long range, low power consumption is at its core.
Its setup is easy and straightforward. The firmware fully supports the LoRaWAN 1.0.2 stack. The node can work in a number of modes, with different data rates and read data from the attached sensors. This is all configurable via AT commands.
Based on Semtech SX1276
Full LoRaWAN 1.0.2 stack support
Supported bands: (EU433, CN470, IN865, EU868, AU915, US915, KR920, AS920 and AS923)
Output power: 5－20dBm adjustable
Max sensitivity: -130dBm@0.3kps
Open source firmware with built-in AT command functionality for easy setup
Theoretical max range of 2km in Urban and 15km in open areas
Integrates both SMA and iPEX antenna connectors
Operating temperature: -40°C ~ 85°C (industrial grade)
Storage temperature: -40°C ~ 85°C (non-condensing)
Breakout Board Dimensions: 42mm x 25mm
Product Weight: 0.2kg
Inclusions:
1pc RAK811 WisDuo LoRa Module (chipset pre-soldered on the board)
1pc LoRa Antenna
5pcs Dupont Line
Useful Link：
Datasheet
RAK811-N Lora Module Datasheet V1.1.pdf
Application Notes
Firmware upgrade
Hardware Design
Software Development
Tools
Reference: DWM17102702
LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM17111202
LoRaST 433MHz /470MHz /868MHz /915MHz Open Source Long Range Wireless LoRa Transceiver is a small wireless transceiver module offers a very compelling mix of long range, low power consumption and secure data transmission.
Reference: DWM18011701
RAK811 LoRa module complies with the latest LoRaWAN Class A & C protocol specifications, it is simple to access LWPA IOT platforms integrates SX1276 and stm32L with TELEC CE FCC KCC certification.
Reference: DWM20060102
Brand: Semtech
DWM-RAK4200 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.it's utilized is of an Xbee form factor.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM20060101
Brand: Semtech
DWM-RAK4260 LPWAN Evaluation Board is a WisBlock product that consists of DWM-RAK4260 (DWM-RAK4260 LPWAN Module + Breakout board) and the RAK5005 WisBase
Reference: DWM19022802
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM20053104
Brand: Semtech
DWM-RAK4260 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.
Reference: DWM22052401
RAK2247 Pi HAT is a converter board with a Raspberry Pi form factor that enables the RAK2247 LPWAN concentrator module to be mounted on the top of the Raspberry Pi.
Reference: DWM21030102
LoRa Antenna-868MHz /915MHz 8dBi Glass Fiber Antenna with N Female Connector. Out Door Waterproof Fiberglass Antenna which is designed for Lora application required for high gain outdoor waterproof.
Reference: DWM20053102
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM19022001
DWM-RAK7249 is The Enterprise DIY outdoor LoRaWan GATEWAY Builtin OpenWRT OS support 16 channel LoRa/4G/WIFI/GPS .
Reference: DWM19091602
DWM-RAK7243 Pilot LoRas Gateway Pro Kit with GPS modules for PoC Raspberry Pi 3B+, RAK2245 Pi HAT.
Reference: DWM19022803
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora tracker start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
Reference: DWM21031002
Brand: Semtech
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM20052801
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.
Reference: DWM19070803
RAK7258 Micro Gateway is a full 8-channel LoRa Gateway with built-in Ethernet connectivity for a straightforward setup. Additionally, there is an onboard Wi-Fi setup that allows it to be easily configured via the default Wi-Fi AP mode.
Reference: DWM18011601
RAK8211-NB iTracker combines NB-IoT+BLE+GPS+ 5 Sensors Development Board has BLE GPRS GPS three in one module perfectly solves the problem of data interaction and control in the outdoor environment and the three party platform.
RAK811 Development Kit WisDuo LoRa Module is a combination of the RAK811 chipset and the RAK811 Breakout Board.
