Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
DWM-RAK4260 LPWAN Evaluation Board is a WisBlock product that consists of DWM-RAK4260 (DWM-RAK4260 LPWAN Module + Breakout board) and the RAK5005 WisBase
DWM-RAK4260 LPWAN Evaluation Board is a WisBlock product that consists of DWM-RAK4260 (DWM-RAK4260 LPWAN Module + Breakout board) and the RAK5005 WisBase. This development board allows access to all serial and GPIO ports for easy configuration. The DWM-RAK4260 core module includes RAK Unified Interface (RUI) to help you quickly and easily develop and test your firmware.
High-quality Low power LoRa® device (Microchip ATSAMR34J18 SiP)
Fully supported 862 to 1020 MHz frequency coverage (all LoRaWAN® bands)
High level of accuracy and stability (32MHz TXCO)
Max Tx Power: 20dBm
Max Sensitivity (SF12 BW125kHz):-136dBm
Rx Current: 17mA (typical)
A rich selection of interfaces: I2C, SPI, ADC, UART, GPIOs
To properly use this product, make sure to purchase a compatible Emulator Kit. We recommend that you directly buy from SEGGER Microcontroller's site to ensure that you get a genuine product.
1pc DWM-RAK4260 EVB
1pc Micro USB Cable
1pc SubG Antenna (iPEX)
2pcs 4-pin Header
9pcs Dupont Lines
Reference: DWM20053001
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM20053001
Brand: Semtech
The DWM-RAK4260 LPWAN Module is based on Microchip’s ATSAMR34J18B integrating a 32-bit ARM Cortex -M0+ MCU with a LoRa Transceive, provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM20053104
Brand: Semtech
DWM-RAK4260 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.
Reference: DWM23010901
RAK7268V2 8 channels WisGate Edge Lite 2 LoRaWAN Indoor Gateway OpenWRT software supports Can integrate with both private (ChirpStack) and public (TTN) network servers.
Reference: DWM20053001
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM18042701
LoRa Antenna-433MHz /470MHz /868MHz /915MHz 8dBi Glass Fiber Antenna with N Female Connector. Out Door Waterproof Fiberglass Antenna which is designed for Lora application required for high gain outdoor waterproof.
Reference: DWM20053103
Brand: Semtech
The DWM-RAK4600 development board allows access to all serial and GPIO ports for easy configuration. The RAK4600 core module includes nRF52832 MCU and SX1276 LoRa® chip to help you quickly and easily develop/test your firmware.
Reference: DWM18050301
DWM-RAK813 LoRa and Bluetooth Module nRF52832 and LoRa SX1276 core chip which is a combination of the BLE and LoRa of the relay node module.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
Reference: DWM19070802
LoRa Antenna-433MHz /470MHz /868MHz /915MHz 3dBi Glass Fiber Antenna with N Female Connector. Out Door Waterproof Fiberglass Antenna which is designed for Lora application required for high gain outdoor waterproof.
Reference: DWM20053102
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM20061601
Brand: Semtech
DWM-RAK4200 LPWAN Evaluation Board is a WisBlock product consisting of RAK4200 LPWAN Module and RAK5005 WisBase includes an STM32L071 MCU and SX1276 LoRa® chip that complies with the LoRaWAN® 1.0.2 protocols.
Reference: DWM19022802
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM21030102
LoRa Antenna-868MHz /915MHz 8dBi Glass Fiber Antenna with N Female Connector. Out Door Waterproof Fiberglass Antenna which is designed for Lora application required for high gain outdoor waterproof.
Reference: DWM22061601
RAK10700 is a GNSS Tracker device with a GNSS modem providing LPWAN and BLE communication using the nRF52 MCU and SX1262 LoRa transceiver of the RAK4631 Core module.
Reference: DWM22052402
RAK2011 is Arduino shield board powered by the Quectel BG96 modem chipset. It supports 2G/EGPRS, 4G/LTE Cat-M1 (eMTC), Cat-NB1 (Nb-IoT), as well as GPS.
Reference: DWM18011601
RAK8211-NB iTracker combines NB-IoT+BLE+GPS+ 5 Sensors Development Board has BLE GPRS GPS three in one module perfectly solves the problem of data interaction and control in the outdoor environment and the three party platform.
Reference: DWM24092501
RAK8213 is a multi-band LTE Cat M1/Cat NB1/EGPRS module based on the Quectel EG95 with a standard PCI Express® form factor (Mini PCIe). It offers a maximum data rate of 375Kbps downlink and 375Kbps uplink.
Reference: DWM20052801
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.
Reference: DWM18050801
RAK811 WisNode LoRa Module development board is compatible with Arduino Development Board. It can also be used as an extension board development with Arduino.
DWM-RAK4260 LPWAN Evaluation Board is a WisBlock product that consists of DWM-RAK4260 (DWM-RAK4260 LPWAN Module + Breakout board) and the RAK5005 WisBase
