Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The Meshtastic starter Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
Meshtastic is an off-grid messaging system using inexpensive hardware to create your personal mesh. Radios forward messages to the next node to distribute them over the network. Communicate kilometers/miles between nodes. Internet-connected relay nodes enable the conversation to move online too.
The RAK WisBlock is a modular hardware system that can be used to build Meshtastic devices.The Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
Nordic nRF52840 ultra-low power MCU
32-bit ARM® Cortex™-M4 CPU
64 MHz CPU clock
1 MB Flash, 256 KB RAM
Semtech SX1262 low power high range LoRa transceiver
LoRaWAN 1.0.2 protocol stack
Bluetooth 5.0 protocol stack
I2C, SPI, Analog inputs, Digital inputs, and outputs
Low power consumption
Chipset: Nordic nRF52840, Semtech SX1262
1 WisBlock Core module
1 WisBlock compatible with IO slot
4 WisBlock modules compatible with slots A-D
1 Type-C USB port for programming and debugging
3.7 V Rechargeable battery connector
5 V Solar panel connector
Four 4-pin header with BOOT, I2C, and UART pins accessible with solder contacts
Additionally, it has two user-definable LEDs, one power supply/charging indicator LED, and a reset button.
1pc WisBlock Base (RAK19007)
1pc WisBlock Core (RAK4631) - Select your frequency band before ordering
1pc LoRa Antenna
1pc BLE Antenna
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22090701
TTGO Meshtastic T-Beam V1.1 ESP32 LoRa Development Board 433MHz 868MHz 915MHz 923MHz with WiFi Bluetooth GPS and 0.96 OLED Display.
Reference: DWM22091301
The TrackerD is built-in with GPS, Wi-Fi, BLE, Temperature, Humidity, Motion Detection, and Buzzer which can use Arduino IDE to customize the software for IoT solution.
Reference: DWM23010901
RAK7268V2 8 channels WisGate Edge Lite 2 LoRaWAN Indoor Gateway OpenWRT software supports Can integrate with both private (ChirpStack) and public (TTN) network servers.
Reference: DWM23080608
The LoRaWAN Smart Home Office Security Kit includes a range of sensors and intrusion detection sensors include PIR, radar, and ultrasonic sensors. The access control modules include fingerprint, NFC, and barcode sensors that provide secure and convenient access to your home or office.
Reference: DWM22062301
The LoRaWAN GNSS GPS Tracker is with a sensor to detect location change every set time interval and with solar panel built-in on the enclosure Use this kit for tracking and monitoring cargo, vehicles, and marine vessels.
Reference: DWM22082602
The new A-fix Bracket Kit will help you easily install and optimally position your antennas for any use case scenario, to ensure the best coverage possible
Reference: DWM22101701
DWM-M702 seven-in-one sensor module is a cost-effective digital serial port output sensor module, which adopts 485/UART output mode and integrates CO2, HCHO, TVOC,PM2.5,PM10, temperature and humidity.
Reference: DWM23051902
The RAK3172-E is a Evaluation Board for RAK3172 Module It is based on RAK3372 WisBlock Core PCB which is compatible to the RAK19007 base board.
Reference: DWM23080607
The Smart Home Office Security Kit with RAK13101 GSM module Quectel MC20CE includes a range of sensors and intrusion detection sensors include PIR, radar, and ultrasonic sensors. The access control modules include fingerprint, NFC, and barcode sensors that provide secure and convenient access to your home or office.
Reference: DWM24011501
The Raspberry Pi 4 LoRaWAN Kit is Based on RAK2287 Concentrator and Raspberry Pi 4 Model B use it to Build your developer gateway for LoRaWAN application.
Reference: DWM20092102
DWM-RAK7240 8 channels OpenWRT OS DIY Enterprise LoRa Gateway Builtin OpenWRT OS support 16 channels LoRa/4G/WIFI/GPS .
Reference: DWM20053102
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM23100902
RAK7289V2 WisGate Edge Pro Version 2 is an ideal product for IoT commercial deployment. With its industrial-grade components, it achieves a high standard of reliability.Supports 16 LoRa channels, multi backhaul with Ethernet, Wi-Fi, and Cellular connectivity.
Reference: DWM23080401
The RAK Agriculture Kit includes a range of sensors designed specifically for agriculture, including soil, light, and environmental sensors, as well as common interfaces like SDI-12, 4-20 mA, and RS485, providing a versatile platform for monitoring and controlling agricultural conditions.
Reference: DWM23080408
RAK Industrial IO and Communication Kit with RAK13101 GSM module Quectel MC20CE which is including LIN, CAN, SDI-12, 4-20 mA, RS485, Ethernet, Analog, and Relay for data acquisition and control.
Reference: DWM21031002
Brand: Semtech
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM22082505
RAK3172 based on STM32WLE5CC chip is a low-power long-range transceiver module for LoRa and LoRaWAN applications.
Reference: DWM23080405
Environment Air Quality Sensor Kit with RAK13101 GSM module Quectel MC20CE It features sensors for temperature, humidity, pressure, UV, CO2, Particulate Matter, VOC, and IAQ. Additionally, it supports different connectivity options like LoRaWAN, BLE, LTE-M, and NB-IoT.
Reference: DWM23080507
The IOT Movement Detection Kit with RAK5860 NB-IOT module Quectel BG77 this kit includes a variety of contact and non-contact motion sensors, including an accelerometer, gyroscope, PIR (Passive Infrared) sensor, and radar sensor.
The Meshtastic starter Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
