Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
| RF Parameter | Value |
Remark |
| Working frequency |
410~931 MHz |
Default: 433MHz/868MHz/915MHz (32MHz oscillator) |
| Transmitting power | 30 dBm |
Max. Power (1W) |
| Receiving sensitivity | -148 dBm |
Air data rate: 0.3kbps |
| Air data rate | 0.018k~37.5kbps |
Default: 0.3kbps |
| Test distance | 10000m |
In open and clear air, with maximum power, 5dBi antenna gain, height of 2m, air data rate: 0.3kbps |
| Hardware Parameter | Value |
Remark |
|
Size |
25 * 37 mm |
|
|
Antenna type |
Stamp hole |
|
|
Communication interface |
SPI |
|
|
Package |
SMD |
|
| Electronic parameter | Min. | Typ. | Max. | Unit | Condition |
| Power supply |
3.3 | 5.0 | 5.5 | V | |
| Communication level | 1.8 | 3.3 | 3.6 | V | |
| Transmitting current |
570 | 630 | 690 | mA | 30dBm（1W） |
| Receiving current |
18 |
20 | 22 | mA | |
| Sleep current |
1.5 |
3.0 | 4.5 | μA | |
| Operating temperature |
-40 | 20 |
+85 | ℃ | |
| Operating humidity |
10 | 60 |
90 | % | |
| Storage temperature |
-40 | 20 |
+125 | ℃ |
| Pin No |
Pin item | Pin direction | Pin application |
| 1 | GND |
- |
Ground electrode, connected to the power reference ground. |
| 2 | DIO5 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 3 | DIO4 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 4 | DIO3 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 5 | DIO2 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 6 | DIO1 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 7 | DIO0 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 8 | RST | Input |
Reset |
| 9 | GND | - |
Ground electrode, connected to the power reference ground. |
| 10 | GND | - |
Ground electrode, connected to the power reference ground. |
| 11 | VCC | - |
Power supply: 4.75~5.5V (Ceramic filter capacitoris advised to add) |
| 12 | SCK | Input |
SPI clock |
| 13 | MISO | Output |
SPI clock |
| 14 | MOSI | Input |
SPI clock |
| 15 | NSS | Input |
Chip select |
| 16 | TXEN | Input |
Radio frequency switch control, make sure the TXEN pinis in high level, RXEN pin is in low level when transmitting. |
| 17 | RXEN | Input |
Radio frequency switch control, make sure the TXEN pinis in high level, RXEN pin is in low level when transmitting. |
| 18 | GND | - |
Ground electrode, connected to the power reference ground |
| 19 | ANT | - |
Antenna |
| 20 | GND | - |
Ground electrode, connected to the power reference ground |
| 21 | GND | - |
Ground electrode, connected to the power reference ground |
| 22 | GND | - |
Ground electrode, connected to the power reference ground |
Reference: DWM14073001
Brand: Semtech
APC340 LoRa series rf module is built in RFIC sx1278 and sx1276 which can work on 433MHz,470MHz ,868MHz,915MHz 20dBm Ultra Long Range Transceiver Module with LoRa spread spectrum modulation.
Reference: DWM15123001
Brand: Semtech
HM-TRLR-S series are operating at 433MHz, 868MHz, 915MHz low cost, high performance transparent transceiver with LoRa/FSK/ GFSK/OOK modulation variety.It's mainly use for uav controller and drone data link.
Reference: DWM16092701
RFM98PW/ RFM95PW which are Enhanced Power Long Range Transceiver Module.the available versions is RFM98PW 433MHz, and 868MHz,915MHz for RFM95PW.
Reference: DWM16112801
DWM-LoRa1276F30 is a 500W high power wireless transceiver module, which integrates SemtechRF transceiver chip SX1276. There are 868MHz and 915MHz for avaialble options.
Reference: DWM20053103
Brand: Semtech
The DWM-RAK4600 development board allows access to all serial and GPIO ports for easy configuration. The RAK4600 core module includes nRF52832 MCU and SX1276 LoRa® chip to help you quickly and easily develop/test your firmware.
Reference: DWM19022803
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora tracker start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM21031002
Brand: Semtech
The DWM-RAK4270 LPWAN Module is based on STM32L071 MCU and an SX1262 LoRa chip integrating a 32-bit ARM Cortex -M0+ MCU provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM20031101
Brand: Semtech
DWM-SL1276 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: DWM23072703
E22-XXXT22U are the new generation of LoRa wireless spread spectrum modules using USB standard package, convenient for user development and use.
Reference: DWM24070901
T-Deck LoRa is a pocket-sized gadget with an SX1262 LoRa module, a 2.8-inch, 320 x 240 pixel IPS LCD, a mini keyboard, and an ESP32 dual-core processor.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM18110601
Brand: Semtech
RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech SX1278 chipset with the application for ARM meters.
Reference: DWM20030701
Brand: Semtech
The E22-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1268(433MHz) and SX1262(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
Reference: DWM18051401
Brand: Semtech
HPD13A Sx1276 868MHz /915MHz LoRa transceiver RF module feature the LoRa TM long range rf module which core chipset are the semtech serice LoRa chipset,usually build for the ARM application.
Reference: DWM23091501
YTX1276/YTX1278 which is based on the SX1276 and SX1278 LoRa chipset which can be option for the different center frequency with 433MHz/ 868MHz/ 915MHz a LoRa Wireless module.
Reference: DWM18011702
RAK811 Development Kit WisDuo LoRa Module is a combination of the RAK811 chipset and the RAK811 Breakout Board.
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM22072103
LA66 is a ready-to-use module that includesLoRaWAN v1.0.4 protocol and also supports open-source peer-to-peer LoRa Protocol for the none-LoRaWAN application.
Reference: DWM18051402
Brand: Semtech
HPD14A SX1278 433MHz /470MHz LoRa Wireless transceiver module feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM16011801
Brand: Semtech
LoRa1276 Wireless Transceiver Module adopts Semtech RF transceiver chip SX1276 which LOS transmission distance can reach to 4km~6km Long Distance.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
