Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
| RF Parameter | Value |
Remark |
| Working frequency |
410~931 MHz |
Default: 433MHz/868MHz/915MHz (32MHz oscillator) |
| Transmitting power | 30 dBm |
Max. Power (1W) |
| Receiving sensitivity | -148 dBm |
Air data rate: 0.3kbps |
| Air data rate | 0.018k~37.5kbps |
Default: 0.3kbps |
| Test distance | 10000m |
In open and clear air, with maximum power, 5dBi antenna gain, height of 2m, air data rate: 0.3kbps |
| Hardware Parameter | Value |
Remark |
|
Size |
25 * 37 mm |
|
|
Antenna type |
Stamp hole |
|
|
Communication interface |
SPI |
|
|
Package |
SMD |
|
| Electronic parameter | Min. | Typ. | Max. | Unit | Condition |
| Power supply |
3.3 | 5.0 | 5.5 | V | |
| Communication level | 1.8 | 3.3 | 3.6 | V | |
| Transmitting current |
570 | 630 | 690 | mA | 30dBm（1W） |
| Receiving current |
18 |
20 | 22 | mA | |
| Sleep current |
1.5 |
3.0 | 4.5 | μA | |
| Operating temperature |
-40 | 20 |
+85 | ℃ | |
| Operating humidity |
10 | 60 |
90 | % | |
| Storage temperature |
-40 | 20 |
+125 | ℃ |
| Pin No |
Pin item | Pin direction | Pin application |
| 1 | GND |
- |
Ground electrode, connected to the power reference ground. |
| 2 | DIO5 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 3 | DIO4 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 4 | DIO3 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 5 | DIO2 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 6 | DIO1 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 7 | DIO0 | Input/Output |
Configurable IO port（Please find more on SX1276-7-8-9 Datasheet）. |
| 8 | RST | Input |
Reset |
| 9 | GND | - |
Ground electrode, connected to the power reference ground. |
| 10 | GND | - |
Ground electrode, connected to the power reference ground. |
| 11 | VCC | - |
Power supply: 4.75~5.5V (Ceramic filter capacitoris advised to add) |
| 12 | SCK | Input |
SPI clock |
| 13 | MISO | Output |
SPI clock |
| 14 | MOSI | Input |
SPI clock |
| 15 | NSS | Input |
Chip select |
| 16 | TXEN | Input |
Radio frequency switch control, make sure the TXEN pinis in high level, RXEN pin is in low level when transmitting. |
| 17 | RXEN | Input |
Radio frequency switch control, make sure the TXEN pinis in high level, RXEN pin is in low level when transmitting. |
| 18 | GND | - |
Ground electrode, connected to the power reference ground |
| 19 | ANT | - |
Antenna |
| 20 | GND | - |
Ground electrode, connected to the power reference ground |
| 21 | GND | - |
Ground electrode, connected to the power reference ground |
| 22 | GND | - |
Ground electrode, connected to the power reference ground |
Reference: DWM14073001
Brand: Semtech
APC340 LoRa series rf module is built in RFIC sx1278 and sx1276 which can work on 433MHz,470MHz ,868MHz,915MHz 20dBm Ultra Long Range Transceiver Module with LoRa spread spectrum modulation.
Reference: DWM15123001
Brand: Semtech
HM-TRLR-S series are operating at 433MHz, 868MHz, 915MHz low cost, high performance transparent transceiver with LoRa/FSK/ GFSK/OOK modulation variety.It's mainly use for uav controller and drone data link.
Reference: DWM16092701
RFM98PW/ RFM95PW which are Enhanced Power Long Range Transceiver Module.the available versions is RFM98PW 433MHz, and 868MHz,915MHz for RFM95PW.
Reference: DWM16112801
DWM-LoRa1276F30 is a 500W high power wireless transceiver module, which integrates SemtechRF transceiver chip SX1276. There are 868MHz and 915MHz for avaialble options.
Reference: DWM19091702
RAK2247 LoRa Gateway mPCIE Board-RAK833 Concentrator Module is the evolution of RAK833 is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM17092902
$10.5/pcs MOQ100pcs RFM98PW / RFM95PW which are Enhanced Power Long Range Transceiver Module.the available versions is RFM98PW 433MHz, and 868MHz,915MHz for RFM95PW.
Reference: DWM21031001
Brand: Semtech
The RFM95W transceivers with 868 MHz and 915 MHz feature the LoRa TM long range rf module which core chipset are the semtech Sx1276 LoRa chipset good for building the for IoT end sensor nodes.
Reference: DWM19022803
DWM-RAK2245 Pi HAT Raspberry Pi 3B Lora tracker start kit is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM18021806
M5Stack Battery Module for Arduino ESP32 Core Development Kit Capacity700mAh Stackable IoT Development Board.
Reference: DWM18022201
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: DWM23091501
YTX1276/YTX1278 which is based on the SX1276 and SX1278 LoRa chipset which can be option for the different center frequency with 433MHz/ 868MHz/ 915MHz a LoRa Wireless module.
Reference: DWM25030701
The nRFLR1262 module integrates the Nordic nRF52840 microcontroller and the Semtech SX1262 LoRa transceiver chip supports Bluetooth 5.3 and low-power Bluetooth and complies with the A, B, and C classes of the LoRaWAN 1.0.3 specification. It also supports the LoRa point-to-point (P2P) communication mode.
Reference: DWM22102601
DWM-S90S series is based on SX1301+SX1255 chip combination, supports LoRaWAN standard protocol Class A/B/C equipment, has 8 uplink channels,1 downlink channel, the maximum transmit power is +27dBm, and the maximum receiving sensitivity is -140dbm.
Reference: DWM20030702
Brand: Semtech
The E22-M22S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1268(433MHz) and SX1262(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
Reference: DWM17080502
Brand: Semtech
RFM95TW 868MHz /915MHz with High Stability TCXO LoRa transceiver RF module feature the LoRa TM long range rf module,build by the semtech chipset with the application for LowWAN and ARM meters.
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM20053104
Brand: Semtech
DWM-RAK4260 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.
Reference: DWM19051701
Brand: Semtech
DWM-LoRa1280 /LoRa1281 is built with Semtech SX1280 and SX1281 Chipset it's measure the range between the transmitter and receiver.
Reference: DWM20052801
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.
The E19-M30S 433MHz /868MHz /915MHz SPI +30dBm Enhanced Power LoRa Transceiver Module is based on original imported RFIC SX1278(433MHz) and SX1276(868MHz/915MHz) from SEMTECH, adopts LoRa spread spectrum technology.
