Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
0.96 OLED Display ESP32 WIFI Bluetooth Lora iot Development Board Transceiver SX1276 868MHZ 915MHZ IOT for Arduino Smart Home.
0.96 OLED Display ESP32 WIFI Bluetooth Lora Development Board Transceiver SX1276 868MHZ 915MHZ IOT for Arduino Smart Home.
Main chip: espressif esp32 and SX1276
Operating voltage: 3.3V to 7V
Flash:32M-Bits
Main Frequency:240MHZ
Support frequency:868-915MHZ
Lora chip:SX1276
Distance: about 2.8KM in open place
Computing power: 600DMIPS
Dual-mode Bluetooth: traditional Bluetooth and BLE low-power Bluetooth
Development environment: support arduino
USB adapter chip: cp2102
Operating temperature range: -40 ° C to + 90 ° C
Support modes: Sniffer, Station, softAP and Wi-Fi Direct
Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g, 11 Mbps @ 11b
Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n
Receiver sensitivity up to - 98 dBm
UDP continues to throughput by 135 Mbps
user name and password is diymall
Package Includes:
1 X ESP32 Lora OLED development board
2 X Pin header
2 X Pin header stickers
Reference: DWM15091402
Brand: Semtech
The RFM92W /RFM95W transceivers with 868 MHz and 915 MHz feature the LoRa TM long range rf module which core chipset are the semtech serice LoRa chipset,usually build for the ARM application.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM17120402
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
Reference: DWM20061502
The LWL01 is a LoRaWAN Water Leak Sensor. It detects the water leak status and will send periodically data every day as well as for water leak event. It also count the water leak event times and also calculate last water leak duration.
Reference: DWM21010102
BCN01 is designed for the use together with LBT1 LoRaWAN Indoor Position Solution base on NORDIC NRF52832 IC and support Bluetooth 4.2 protocol.
Reference: DWM19090403
The PG1301 build by SX1301 and SX1257 which is The 10 channels - LoRaWAN GPS Concentrator for Raspberry Pi can connect to 5000 nodes.
Reference: DWM22092201
WSS-05 is a 4 in 1 RS485 sensor which can monitor Temperature, Humidity, Illuminance and Pressure at the same time which can work with WSC1-L or WSC2-LB weather station main processor.
Reference: DWM22091301
The TrackerD is built-in with GPS, Wi-Fi, BLE, Temperature, Humidity, Motion Detection, and Buzzer which can use Arduino IDE to customize the software for IoT solution.
Reference: DWM14102902
Low cost SIMCOM SIM900 Quad-band GSM GPRS Shield Development Board for Arduino.
Reference: DWM21031103
SenseCAP IoT LoRaWAN Wireless Soil Moisture and Temperature Sensor node built-in LoRa transmitter based on SX1276 chipset for smart agriculture, precision farming, and smart city outdoor used IoT application.
Reference: DWM19062701
Yun Shield v1.1.6 runs Open Source OpenWrt system solve the Internet connectivity and storage issue for Arduino Board.
Reference: DWM20031101
Brand: Semtech
DWM-SL1276 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM21010103
The LSN50v2-D20 is a LoRaWAN Temperature Sensor for Internet of Things solution. It can be used to measure the temperature of air, liquid or object, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM20072902
The LDDS75 LoRaWAN Distance Detection Sensor node is a distance detection sensor that uses ultrasonic sensing technology for distance measurement, and temperature compensation is performed internally to improve the reliability of data.
Reference: DWM18051403
HPD13AP /HPD14AP +30dBm Enhanced Power LoRa Long Range Transceiver Modulethe available versions are 433MHz, 470MHz, 868MHz,915MHz .
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM21072702
The N95S31B SHT31 NB-IoT Outdoor Temperature and Humidity Sensor be used to measure the surrounding environment temperature and relative air humidity for IoT solution.
0.96 OLED Display ESP32 WIFI Bluetooth Lora iot Development Board Transceiver SX1276 868MHZ 915MHZ IOT for Arduino Smart Home.
