- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The NBSN95A is a Long Range NB-IoT Sensor Node is used the Quectel BC35-G module to rapidly deploy NB-IoT sensor node for IoT solution.
The NBSN95A is a substitude version of Dragino NBSN95 due to IC shortage version. NBSN95A and NBSN95 has the same hardware performance and use the same image.
NBSN95A is a Long Range NB-IoT Sensor Node. It is designed for outdoor data logging and powered by 8500mAh Li/SOCl2 battery for long term use and secure data transmission. System Integrator can use NBSN95A to rapidly deploy NB-IoT sensor node for their IoT solution.NBSN95A is easy to program, create and connect things everywhere.
NarrowBand-Internet of Things (NB-IoT) is a standards-based low power wide area (LPWA) technology developed to enable a wide range of new IoT devices and services. NB-IoT significantly improves the power consumption of user devices, system capacity and spectrum efficiency, especially in deep coverage.
To use NBSN95A, user needs to check if there is NB-IoT coverage in local area and with the bands NBSN95A supports. If the local operate support it, user needs to get a NB-IoT SIM card from local operator and install NBSN95 to get NB-IoT network connection.
NBSN95A is an open source project. It is based on the STM32L072CZT6 ultra-low-power ARM® Cortex®-M0+ micro controller. Developers can get completely software and hardware design files and adapter for their projects.
STM32L072CZT6 MCU
NB-IoT Bands: B1/B3/B8/B5/B20/B28 @H-FDD
Pre-load bootloader on USART1/USART2
MDK-ARM Version 5.24a IDE
I2C, LPUSART1, USB, SPI2
3x12bit ADC, 1x12bit DAC
20xDigital I/O
Open source hardware / software
IP66 Waterproof Enclosure
Ultra Low Power consumption
AT Commands to change parameters
Micro SIM card slot for NB-IoT SIM
8.5 Ah Battery for long term use
Wireless Alarm and Security Systems
Home and Building Automation
Automated Meter Reading
Industrial Monitoring and Control
Long range Irrigation Systems,etc.
STOP Mode: 10 μA @ 3.3v
See Power Analyze Document for more.
Li/SOCI2 unchargable battery
Capacity: 8500mAh
Self Discharge: <1% / Year @ 25°C
Max continuously current: 500mA
Max boost current: 2A, 1 second
1 x NBSN95A NB-IoT Sensor Node
1 x External NB-IoT antenna
Device Size: Device Size: 10 x 4.0 x 4.2 cm
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM20072901
The DLOS8 Outdoor LoRaWAN Gateway includes 1pcs SX1301 and 2pcs SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20090102
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
Reference: DWM22071401
The LPS8v2 is an open-source Debian system LoRaWAN Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi , Ethernet and also with 4G Cellular Network capability.
Reference: DWM22122901
The LWL03A is a LoRaWAN Water Leak Controller use a Water Leak Cable on the ground to detect water leakage. The water leak cable is sensitivity, when there is water over the leak cable.
Reference: DWM22040501
The LPS8N is an open-source LoRaWAN Gateway which includes a SX1302/03 LoRa concentrator and has an optional cellular version that can provide 3G/4G connectivity to the internet.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM18072401
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM23021007
The LHT65S-NE117 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor use an external probe uses TI TMP117A NIST traceability temperature sensor, with 0.1°C accuracy in normal temperature range.
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM18120401
Brand: Semtech
DWM-LJ1295 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: DWM23072306
The DS03A-LB is an Open/Close LoRaWAN Door Sensor that supports BLE configure and wireless OTA update. It detects door open/close status and uplinks to IoT server via LoRaWAN network. user can see the door status, open duration, open counts in the IoT Server.
Reference: DWM18011503
LGT-92 LoRaWAN GPS Tracker with 9-axis accelerometer is an open source GPS tracker base on Ultra Low Power STM32L072 MCU and SX1276/1278 LoRa Module.
Reference: DWM22100701
Dragino LoRa IoT Kit v3 is designed to facilitate beginners and developers to quickly learn and demonstrate LoRa/LoRaWAN and IoT technology. It helps users to turn the idea into a practical application and make the Internet of Things a reality.
Reference: DWM23050802
PS-LB-NA convert the Analog Value to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway. supports BLE configure and wireless OTA update.
Reference: DWM15091402
Brand: Semtech
The RFM92W /RFM95W transceivers with 868 MHz and 915 MHz feature the LoRa TM long range rf module which core chipset are the semtech serice LoRa chipset,usually build for the ARM application.
Reference: DWM25021501
The D22-LS is a solar-powered LoRaWAN Temperature Sensor designed for waterproofing/Outdoor use The temperature sensor used in D22-LS can measure -55°C ~125°C with accuracy ±0.5°C (max ±2.0 °C).
Reference: DWM22082510
The Dragino LMDS200 is a LoRaWAN Microwave Radar distance sensor which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: DWM25011501
The D20-NB and D20S-NB NB-IoT Temperature Sensors uplink methods including MQTT, MQTTs, UDP & TCP support BLE configure and OTA update, convert the Temperature reading to upload the sensor data sent to the IoT platform via the NB-IoT network.
The NBSN95A is a Long Range NB-IoT Sensor Node is used the Quectel BC35-G module to rapidly deploy NB-IoT sensor node for IoT solution.