- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
TheLLDS12 LoRaWAN LiDAR ToF Distance Sensor for distance measurement be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
The Dragino LLDS12 is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor for Internet of Things solution. It is capable to measure the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m)!. The LiDAR probe uses laser induction technology for distance measurement.
The LLDS12 can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
It detects the distance between the measured object and the sensor, and uploads the value via wireless to LoRaWAN IoT Server.
The LoRa wireless technology used in LLDS12 allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
LLDS12 is powered by 8500mAh Li-SOCI2 battery, it is designed for long term use up to 5 years.
Each LLDS12 is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN 1.0.3 Class A
Ultra-low power consumption
Laser technology for distance detection
Operating Range - 0.1m~12m①
Accuracy - ±5cm@(0.1-6m), ±1%@(6m-12m)
Monitor Battery Level
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
AT Commands to change parameters
Uplink on periodically
Downlink to change configure
8500mAh Battery for long term use
Horizontal distance measurement
Parking management syste
Object proximity and presence detection
Intelligent trash can management system
Robot obstacle avoidance
Automatic control
Sewer
LLDS12-XXX
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Reference: DWM18110501
LG308 8 Channels Indoor LoRaWAN Pico Gateway is an open source LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM20072901
The DLOS8 Outdoor LoRaWAN Gateway includes 1pcs SX1301 and 2pcs SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM18072401
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM20041401
ER14250+SPC1520 Super Pulse Cap 1200mAh Li/SOCI2 unchargable battery for IOT Sensor nodes.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM21010104
The LSN50v2-S31 is a LoRaWAN Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM20060201
The IoT Wireless ear tag sensor build by BDDBTECH offers a completed solution for the dairy farm Management system.
Reference: DWM19011502
The OLG01-N is an Water proof outdoor setting open source single channel LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM17102701
RF Explorer - ISM Combo Handheld Digital Spectrum Analyzer is a very affordable tool for work in all ISM popular frequency bands.
Reference: DWM22091602
WSS-02 is a RS485 wind speed and wind direction monitor designed for weather station solution.
Reference: DWM20090102
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
Reference: DWM18022201
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: DWM18110801
Build your own LoRaWAN "The Things Network" packet-forwarding gateway on Windows 10 IoT Core in native .NET code.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM20090101
LoRa Antenna-BLG-AN-040-868MHz /915MHz Glass Fiber antenna for LoRaWAN Gateway LoRa IoT Application.
Reference: DWM22071802
The LSN50v2-D23 is a LoRaWAN Temperature Sensor nodes with two sensor cable which are waterproof, moisture-proof and anti-rust for long-term usage . It can be used to measure the temperature of air, liquid or object.
Reference: DWM22071401
The LPS8v2 is an open-source Debian system LoRaWAN Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi , Ethernet and also with 4G Cellular Network capability.
Reference: DWM22092802
WSS-03 is a RS485 Air Quality sensor. It can monitor CO2, PM2.5 and PM10 at the same time by RS485 interface to WSC1-L which can detect and upload the environment CO2, PM2.5 and PM10 to the IoT Server via wireless LoRaWAN protocol.
TheLLDS12 LoRaWAN LiDAR ToF Distance Sensor for distance measurement be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.