Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The LWL02 is a LoRaWAN Water Leak Sensor. It build in SX1262 can indicates a water leak event and uplink to IoT server via LoRaWAN network 2 x AAA batteries which can work in 2 ~ 10 years battery life.
The LWL02 is a LoRaWAN Water Sensor. When there is water between the two metal probes, LWL02 indicates a water leak event and uplink to IoT server via LoRaWAN network.
LWL02 is powered by 2 x AAA batteries and target for long time use, these two batteries can provide about 16,000 ~ 70,000 uplink packets, which result in 2 ~ 10 years battery life. After battery running out, user can easily open the enclosure and replace with 2 common AAA batteries.
The LWL02 will send periodically data every day as well as for each water leak event. It also counts the water leak times and calculate last water leak duration. User can also disable the uplink for each water leak event, instead, device can count each event and uplink periodically.
Each LWL02 is pre-load with a set of unique keys for LoRaWAN registration, register these keys to LoRaWAN server and it will auto connect after power on.
LoRaWAN v1.0.3 Class A
SX1262 LoRa Core
Water Leak detect
2 x AAA batteries
Bands: CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865
AT Commands to change parameters
Uplink on periodically and water leak event
Water Leak analyze
Downlink to change configure
1x LWL02 Water Leak Sensor
Device Size & Dimension
Size: 40 x 15 x 15 mm
Weight: 85g
LWL02-XXX
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Reference: DWM18110501
LG308 8 Channels Indoor LoRaWAN Pico Gateway is an open source LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM20061502
The LWL01 is a LoRaWAN Water Leak Sensor. It detects the water leak status and will send periodically data every day as well as for water leak event. It also count the water leak event times and also calculate last water leak duration.
Reference: DWM22092702
ASR6601SE is a general LPWAN Wireless Communication SoC, with integrated RF Transceiver, Modem and a 32-bit RISC MCU. The MCU uses ARM Cortex M4, with 48 MHz operation frequency.
Reference: DWM24011902
The AQS01-L is an Indoor LoRaWAN Air Quality Sensor is designed to measure the surrounding environment parameters include: CO2, Temperature , Relative Air Humidity and Air pressure, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM23070202
S31B-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
Reference: DWM23090801
The AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM22092201
WSS-05 is a 4 in 1 RS485 sensor which can monitor Temperature, Humidity, Illuminance and Pressure at the same time which can work with WSC1-L or WSC2-LB weather station main processor.
Reference: DWM21051602
The LDS02 is a LoRaWAN Door Sensor. It detects door open/close status build in a sx1262 Lora chipset and 2 x AAA batteries and target for long time use.
Reference: DWM22110603
Recharge PCB Kit is Li-Ion Battery Charger which can be used for LSN50v2 & RS485-BL to replace the default one time battery and connect to solar panel.
Reference: DWM22091602
WSS-02 is a RS485 wind speed and wind direction monitor designed for weather station solution.
Reference: DWM22040502
WSC1-L Dragino Weather Station solution Main Process Unit can upload these sensor data to IoT server via LoRaWAN wireless protocol.
Reference: DWM19090403
The PG1301 build by SX1301 and SX1257 which is The 10 channels - LoRaWAN GPS Concentrator for Raspberry Pi can connect to 5000 nodes.
Reference: DWM23021005
The LMDS120 can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection, intelligent trash can management system, robot obstacle avoidance, automatic control, sewer, etc.
Reference: DWM23070102
D23-LB is a LoRaWAN Temperature Sensor with 3 x DS18B20 supports BLE configure and wireless OTA update.
Reference: DWM20022602
The Dragino RS485-LN is a RS485 to LoRaWAN Converter. It converts the RS485 devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
The LWL02 is a LoRaWAN Water Leak Sensor. It build in SX1262 can indicates a water leak event and uplink to IoT server via LoRaWAN network 2 x AAA batteries which can work in 2 ~ 10 years battery life.
