Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
LoRa32u4 is a light and low consumption board based on the Atmega32u4 and 433MHz LoRA module RA02 from AI-Thinker and an USB battery charging circuit. Ideal for creating long range wireless networks that can exceed 2.4 GHz 802.15.4 and similar, it is more flexible than Bluetooth LE, does not require high power unlike WiFi and offers long range.
The RA02 LoRa module is fitted with an U.FL (IPX) external antenna connector.
The ATmega32u4 is clocked at 8 MHz and 3.3 V. This chip has 32 K of flash, 2 K of RAM and built-in USB to Serial communication, debugging and programming capabilities without the need for an external FTDI chip, it can also act as an HID device (mouse, keyboard, USB MIDI device, etc).
This board is also equipped with a LiPo and Liion charging circuit and a standard battery interface. It is fully compatible with Arduino. A white user led is tied to pin 13. An orange LED is used for charging status.
ATmega32u4 @ 8MHz with 3.3V logic/power
3.3V regulator with 500mA peak current output
USB native support, comes with USB bootloader and serial port debugging
20 GPIOs
Hardware Serial, hardware I2C, hardware SPI support
Built in 100mA lipoly charger with charging status indicator LED
Power/enable pin
4 mounting holes
Reset button
SX1278 RA02 LoRa® based module with SPI interface
8 x PWM pins
10 x analog inputs
Packet radio with ready-to-go Arduino libraries
License-free ISM bands (ITU "Europe" @ 433MHz)
+5 to +20 dBm up to 100 mW Power Output Capability (selectable in software)
~300uA during full sleep
~120mA peak during +20dBm transmit
~40mA during active radio listening.
U.FL (IP) antenna connector
Datasheet MPC73831
Datasheet RA02
Datasheet SX1278
Arduino code link
Package includes:
1 X LoRa32U4
Reference: DWM16011801
Brand: Semtech
LoRa1276 Wireless Transceiver Module adopts Semtech RF transceiver chip SX1276 which LOS transmission distance can reach to 4km~6km Long Distance.
Reference: DWM16092701
RFM98PW/ RFM95PW which are Enhanced Power Long Range Transceiver Module.the available versions is RFM98PW 433MHz, and 868MHz,915MHz for RFM95PW.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM17110904
Spring-Antenna 433MHz /470MHz 3dbi Gain with IPEX Connector extension cable
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM17120403
0.96 OLED Display ESP32 WIFI Bluetooth Lora iot Development Board Transceiver SX1276 868MHZ 915MHZ IOT for Arduino Smart Home.
Reference: DWM23070201
S31-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM21010102
BCN01 is designed for the use together with LBT1 LoRaWAN Indoor Position Solution base on NORDIC NRF52832 IC and support Bluetooth 4.2 protocol.
Reference: DWM20072902
The LDDS75 LoRaWAN Distance Detection Sensor node is a distance detection sensor that uses ultrasonic sensing technology for distance measurement, and temperature compensation is performed internally to improve the reliability of data.
Reference: DWM18011503
LGT-92 LoRaWAN GPS Tracker with 9-axis accelerometer is an open source GPS tracker base on Ultra Low Power STM32L072 MCU and SX1276/1278 LoRa Module.
Reference: DWM22062201
LoRaWAN Development kit Create IoT applications for different solutions, like environmental sensing, agriculture solutions, GPS trackers.
Reference: DWM23102502
DWM-DE53LR is an external open-close transformer rail-type multifunctional anti-backflow meter based on Sub-1G(LoRaWAN Default) wireless transmission which is suitable for power monitoring of distributed photovoltaic grid-connected cabinets, power demand side management and other applications.
Reference: DWM18122304
Free Shipping The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM22071802
The LSN50v2-D23 is a LoRaWAN Temperature Sensor nodes with two sensor cable which are waterproof, moisture-proof and anti-rust for long-term usage . It can be used to measure the temperature of air, liquid or object.
Reference: DWM18122302
Brand: Semtech
Free Shipping DWM-1278S 433MHz /470MHz sx1278 LoRa transceiver RF module compatible with RFM98W feature the LoRaTM long range module build by the semtech SX1278 chipset with the application for ARM meters.
Reference: DWM23090801
The AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM18122305
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM18122301
Brand: Semtech
Free Shipping DWM-LJ1295 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
