- -$0.50
- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n has rich interface such as Ethernet, USB, UART and plenty of GPIOs and use small outline package, it is used widely in mini routers and IoT projects.
Pin Number | Pin Name | Pin Description |
1 |
VDD33
|
DC 3.3V
|
2 | VDD33 |
DC 3.3V
|
3 | GND | Ground |
4 | GND | Ground |
5 |
GPIO26
|
standard GPIO Port |
6 |
GPIO12
|
standard GPIO Port |
7 | GPIO27 | standard GPIO Port , SYSTEM LED |
8 |
GPIO11
|
Internal 10K drop-down resistor to ground, default WIRELESS LED function, high-level effective |
9 |
GPIO17
|
Internal 10K pull-up resistor to 2.6 v, default to Wan LED function, low level effective |
10 |
GPIO16
|
Internal 10K pull-down resistor to ground, standard GPIO Port |
11 | GND | Ground |
12 |
GPIO15
|
INTERNAL 10K drop-down resistance to ground, default RESET/FACTORY NEW KEY function, high-level effective |
13 | GPIO14 | Internal 10K pull-down resistor to ground, standard GPIO Port |
14 |
GPIO13
|
Internal 10K pull-up resistor to 2.6 v, default LAN1 LED function, low-level effective. |
15 |
GPIO01
|
Internal 10K pull-up resistor to 2.6 v, standard GPIO Port |
16 |
GPIO00
|
INTERNAL 10K drop-down resistance to ground, standard GPIO Port |
17 | GND | Ground |
18 |
UART_RX
|
Serial RX (for general debugging) |
19 | UART_TX | Serial TX (for general debugging) |
20 |
GPIO20
|
Standard GPIO Port or I2S SD pin function, default to GPIO |
21 | GPIO19 | Standard GPIO Port or I2S WS pin function, default to GPIO |
22 | GPIO18 | Standard GPIO Port or I2S CK pin function, default to GPIO |
23 | GPIO21 | Standard GPIO Port or I2S MCK pin function, default to GPIO |
24 | GPIO22 | Standard GPIO Port or I2S MICIN pin function, default to GPIO |
25 | GND | Ground |
26 | RX4_P | Ethernet port 4 receiving positive end |
27 |
RX4_N
|
Ethernet port 4 receiving negative end |
28 |
TX4_P
|
Ethernet port 4 transmitting positive end |
29 |
TX4_N
|
Ethernet port 4 transmitting negative end |
30 |
VDD20
|
Ethernet Power supply |
31 |
RX0_P
|
Ethernet port 0 receiving positive end |
32 |
RX0_N
|
Ethernet port 0 receiving negative end |
33 |
TX0_P
|
Ethernet port 0 transmitting positive end |
34 |
TX0_N
|
Ethernet port 0 transmitting negative end |
35 | GND | Ground |
36 |
USB_N
|
USB negative port |
37 |
USB_P
|
USB positive port |
38 | GND | Ground |
Reference: DWM15041601
2.4ghz PCB built-in antenna with ipx/ufl connector for WIFI antenna , Blue tooth antenna and Zigbee Antenna.
Reference: DWM15100701
High quality IPEX to SMA Male RG178 Type RF Cable Assemblies Pigtails RF Jumper Cables.
Reference: DWM19060502
The Dual Band Intel 9260AC 2.4G/5Ghz Wi-fi Bluetooth 5.0 moule for Laptop Windows 10 1.73Gbps Wireless 9260NGW NGFF Network Wifi Card For Intel ac 9260 2.4G/5Ghz 802.11ac Wi-fi Bluetooth 5.0 for Laptop Windows 10.
Reference: DWM21030902
The WT-01E module core processor ESP8285 integrates the industry-leading Tensilica L106 ultra-low-power 32-bit micro MCU.
Reference: DWM14060501
HLK-RM10 is a new low-cost embedded UART-ETH-WIFI module (serial port - Ethernet -Wireless network) .
Reference: DWM20030402
EasyESP-1 WiFi-enabled ESP8266 microcontroller is a rapid prototyping and development board for the low-cost, specially designed for beginners.
Reference: DWM14072601
Serial to WiFi/Serial to RJ45/RJ45 to WiFi/WiFi Router StartKit.
Reference: DWM15080504
Low Price ESP-12E ESP8266 Serial Wi-Fi Wireless Transceiver Module for Arduino / RPi Built-in Antenna.it's for Arduino,Raspberry Pi , AVR and widely used in networking, smart home,wifi router.
Reference: DWM21031003
WT32-ETH01 embedded WIFI serial port to Ethernet module based on ESP32 series module integrates an optimized TCP/IP protocol stack, which is convenient for users to easily complete the networking functions of embedded devices.
Reference: DWM14120901
Low cost ESP8266 ESP-01 Serial to WIFI Wireless Transceiver Module it's for Arduino,Raspberry Pi , AVR and ARM DK.
Reference: DWM17082406
WT51822-S4AT nRF5182 BLE 4.1 Low Energy Bluetooth Module with PCB antenna high performance ,low power radio transmit and receive system module use Nordic BLE 4.1 nRF51822-QFAA as the controller chips.
Reference: DWM23090801
The AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM19062801
ESP32-WROOM-32D and ESP32-WROOM-32U are powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding.
Reference: DWM14110207
Low cost DWM-NRF24L01+ 2.4GHz Wireless Transceiver Arduino Compatible module.
Reference: DWM15092501
HI-Link HLK-SW16 16 Channel Android/Smart Phone CWiFi Relay /WiFi Relay Module with P2P Function.
Reference: DWM15081902
Low cost DWM-ESP8266 ESP-05 Serial to WIFI wireless transceiver module with IPEX external antenna connector and chip anetnna it's for Arduino,Raspberry Pi , AVR and widely used in networking, smart home project when it is connected to the wifi router.
Reference: DWM18103005
USD74/pcs MOQ100 The OLG01 is an Water proof outdoor setting open source single channel LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM25042501
PCIE-M.2 WiFi6 AX210N Module for WLAN/ Bluetooth, which can work with the RAK7391 IOT LoRaWAN Gateway Carrier Board MiniPCIe Slot #3.
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.