- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
0.96 OLED Display ESP32 WIFI Bluetooth SX1278 433MHz Lora IOT Development Board for Arduino Smart Home.
0.96 OLED Display ESP32 WIFI Bluetooth Lora Development Board Transceiver SX1278 433MHZ IOT for Arduino Smart Home.
Description:
Main chip: espressif esp32 and SX1278
Operating voltage: 3.3V to 7V
Operating temperature range: -40 ° C to + 90 ° C
Supports Sniffer, Station, softAP and Wi-Fi Direct modes
Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g, 11 Mbps @ 11b
Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n
Receiver sensitivity up to - 98 dBm
UDP continues to throughput by 135 Mbps
Drive
Package Includes:
1 X ESP32 Lora OLED development board
2 X Pin header
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM17120402
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
Reference: DWM17120403
0.96 OLED Display ESP32 WIFI Bluetooth Lora iot Development Board Transceiver SX1276 868MHZ 915MHZ IOT for Arduino Smart Home.
Reference: DWM22091301
The TrackerD is built-in with GPS, Wi-Fi, BLE, Temperature, Humidity, Motion Detection, and Buzzer which can use Arduino IDE to customize the software for IoT solution.
Reference: DWM16112802
DWM-LoRa1278F30 is a 500W high power wireless transceiver module, which integrates SemtechRF transceiver chip SX1278. There are 433MHz and 470MHz for avaialble options.
Reference: DWM21031501
LAQ4 is a LoRaWAN end sensor nodes designed to measure the surrounding environment parameters include: TVOC(Total Volatile Organic Compound), eCO2(equivalent CO2), temperature and relative air humidity.
Reference: DWM21031101
The SenseCAP LoRaWAN Air Temperature and Humidity Sensor node built-in LoRa transmitter based on SX1276 chipset for smart agriculture, precision farming, and smart city outdoor used IoT application.
Reference: DWM20053102
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: DWM18101201
The OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM14102902
Low cost SIMCOM SIM900 Quad-band GSM GPRS Shield Development Board for Arduino.
Reference: DWM16092702
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM21031104
SenseCAP IoT LoRaWAN Wireless Light Intensity Sensor node built-in LoRa transmitter based on SX1276 chipset for smart agriculture, precision farming, and smart city outdoor used IoT application.
Reference: DWM22090706
SenseCAP S2103 Wireless LoRaWAN CO2, Temperature, and Humidity Sensor for Outdoor&Indoor Air Quality, CO2 Meter, Carbon Emission.
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM23050801
SN50V3-LB is the 3rd generation of the LSN50 series generic sensor node built with BLE support, OTA upgrade, and private LoRa protocol for easy maintenance.
Reference: DWM22090703
The SenseCAP S2100 Data Logger connects the sensor, collects the Data, and uploads it to the LoRaWAN gateway. It can support up to 100+ industrial sensors and 100+ grove sensors including various sensor types such as Analog/RS485/GPIO.
Reference: DWM21051602
The LDS02 is a LoRaWAN Door Sensor. It detects door open/close status build in a sx1262 Lora chipset and 2 x AAA batteries and target for long time use.
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM19090601
The LM502 use the newest LoRa Modem SX1262 which provide high transmit power for ultra long range, ultra low power communication for LPWAN application.
0.96 OLED Display ESP32 WIFI Bluetooth SX1278 433MHz Lora IOT Development Board for Arduino Smart Home.