Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
LoRa32u4 is a light and low consumption board based on the Atmega32u4 and 433MHz LoRA module RA02 from AI-Thinker and an USB battery charging circuit. Ideal for creating long range wireless networks that can exceed 2.4 GHz 802.15.4 and similar, it is more flexible than Bluetooth LE, does not require high power unlike WiFi and offers long range.
The RA02 LoRa module is fitted with an U.FL (IPX) external antenna connector.
The ATmega32u4 is clocked at 8 MHz and 3.3 V. This chip has 32 K of flash, 2 K of RAM and built-in USB to Serial communication, debugging and programming capabilities without the need for an external FTDI chip, it can also act as an HID device (mouse, keyboard, USB MIDI device, etc).
This board is also equipped with a LiPo and Liion charging circuit and a standard battery interface. It is fully compatible with Arduino. A white user led is tied to pin 13. An orange LED is used for charging status.
ATmega32u4 @ 8MHz with 3.3V logic/power
3.3V regulator with 500mA peak current output
USB native support, comes with USB bootloader and serial port debugging
20 GPIOs
Hardware Serial, hardware I2C, hardware SPI support
Built in 100mA lipoly charger with charging status indicator LED
Power/enable pin
4 mounting holes
Reset button
SX1278 RA02 LoRa® based module with SPI interface
8 x PWM pins
10 x analog inputs
Packet radio with ready-to-go Arduino libraries
License-free ISM bands (ITU "Europe" @ 433MHz)
+5 to +20 dBm up to 100 mW Power Output Capability (selectable in software)
~300uA during full sleep
~120mA peak during +20dBm transmit
~40mA during active radio listening.
U.FL (IP) antenna connector
Datasheet MPC73831
Datasheet RA02
Datasheet SX1278
Arduino code link
Package includes:
1 X LoRa32U4
Reference: DWM16011801
Brand: Semtech
LoRa1276 Wireless Transceiver Module adopts Semtech RF transceiver chip SX1276 which LOS transmission distance can reach to 4km~6km Long Distance.
Reference: DWM16092701
RFM98PW/ RFM95PW which are Enhanced Power Long Range Transceiver Module.the available versions is RFM98PW 433MHz, and 868MHz,915MHz for RFM95PW.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM17110904
Spring-Antenna 433MHz /470MHz 3dbi Gain with IPEX Connector extension cable
Reference: DWM17120401
LoRa32u4 II is a light and low consumption board based on the Atmega32u4 and SX1276 868MHZ /915MHz LoRA module.
Reference: DWM18122301
Brand: Semtech
Free Shipping DWM-LJ1295 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: DWM21051607
The Dragino RS485-BL is an RS485 / UART to LoRaWAN Converter. It converts the RS-485 and UART devices into a LoRaWAN wireless network, simplifying the IoT installation and reducing the installation/maintenance cost.
Reference: DWM17120404
0.96 OLED Display ESP32 WIFI Bluetooth SX1278 433MHz Lora IOT Development Board for Arduino Smart Home.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
Reference: DWM21051602
The LDS02 is a LoRaWAN Door Sensor. It detects door open/close status build in a sx1262 Lora chipset and 2 x AAA batteries and target for long time use.
Reference: DWM22071801
The LSN50v2-D22 is a LoRaWAN Temperature Sensor nodes with two sensor cable which are waterproof, moisture-proof and anti-rust for long-term usage . It can be used to measure the temperature of air, liquid or object.
Reference: DWM21010101
LBT1 is a Long Range / low power consumption LoRaWAN Bluetooth tracker. LBT1 scans and find the nearest i-Beacon info and send to IoT server via LoRaWAN wireless network.
Reference: DWM22102601
DWM-S90S series is based on SX1301+SX1255 chip combination, supports LoRaWAN standard protocol Class A/B/C equipment, has 8 uplink channels,1 downlink channel, the maximum transmit power is +27dBm, and the maximum receiving sensitivity is -140dbm.
Reference: DWM21051606
The LTC2 Industrial LoRaWAN PT100 Temperature Transmitter Sensor Nodes base on LSN50-V2. It use to supports to read PT100 probe and convert the value to temperature and uplink to IoT server.
Reference: DWM22082504
The RAK4630 module delivers a powerful Nordic nRF52840 MCU with BLE 5.0 paired to the latest LoRa® transceivers from Semtech, the SX126x series.
Reference: DWM20072901
The DLOS8 Outdoor LoRaWAN Gateway includes 1pcs SX1301 and 2pcs SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM21031103
SenseCAP IoT LoRaWAN Wireless Soil Moisture and Temperature Sensor node built-in LoRa transmitter based on SX1276 chipset for smart agriculture, precision farming, and smart city outdoor used IoT application.
Reference: DWM23060101
The D20-LB is a LoRaWAN Temperature Sensor for an Internet of Things solution. D20S-LB is designed for use in Soil or Road. D20-LB/ D20S-LB will convert the Temperature reading to LoRaWAN wireless data and send it to the IoT platform via the LoRaWAN gateway.
Reference: DWM18122306
Free Shipping The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM22051301
LT-W208 LoraWAN Soil NPK Sensor node is Suitable for applications with obstacles. Products are widely used in the field of smart agriculture which is based on LoraWAN global free wireless radio frequency.
LoRa32u4 RA02 is a light and low consumption board based on the Atmega32u4 and SX1278 433MHz LoRA module.
