Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Free Shipping The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
The Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.The LoRa Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
Compatible with 3.3v or 5v I/O Arduino Board.
Frequency Band: 915MHz /868 MHZ/433 MHZ (Pre-configure in factory)
Low power consumption
Compatible with Arduino Leonardo, Uno, Mega, DUE
External Antenna via I-Pex connector
168 dB maximum link budget.
+20 dBm - 100 mW constant RF output vs.
+14 dBm high efficiency PA.
Programmable bit rate up to 300 kbps.
High sensitivity: down to -148 dBm.
Bullet-proof front end: IIP3 = -12.5 dBm.
Excellent blocking immunity.
Low RX current of 10.3 mA, 200 nA register retention.
Fully integrated synthesizer with a resolution of 61 Hz.
FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation.
Built-in bit synchronizer for clock recovery.
Preamble detection.
127 dB Dynamic Range RSSI.
Automatic RF Sense and CAD with ultra-fast AFC.
Packet engine up to 256 bytes with CRC.
Built-in temperature sensor and low battery indicator.
Reference: DWM14032106
The Arduino Uno Rev3 is a microcontroller board based on the ATmega328.
Reference: DWM14041802
HopeRF DK / EVB module kits with number kinds of module which will plug into the DK & EVB board.
Reference: DWM16122301
The Lora BEE is based on the SX1276/SX1278 transceiver.The Lora BEE targets professional wireless sensor network applications such as irrigation systems, smart metering, smart cities, smartphone detection,building automation.
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM21061001
TheLLDS12 LoRaWAN LiDAR ToF Distance Sensor for distance measurement be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: DWM19011502
The OLG01-N is an Water proof outdoor setting open source single channel LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM21051606
The LTC2 Industrial LoRaWAN PT100 Temperature Transmitter Sensor Nodes base on LSN50-V2. It use to supports to read PT100 probe and convert the value to temperature and uplink to IoT server.
Reference: DWM22082504
The RAK4630 module delivers a powerful Nordic nRF52840 MCU with BLE 5.0 paired to the latest LoRa® transceivers from Semtech, the SX126x series.
Reference: DWM16011801
Brand: Semtech
LoRa1276 Wireless Transceiver Module adopts Semtech RF transceiver chip SX1276 which LOS transmission distance can reach to 4km~6km Long Distance.
Reference: DWM18110502
LT-33222-L is The Dragino LT series I/O Modules are Long Range LoRa I/O Controller designed to simplify the installation of I/O monitoring.
Reference: DWM19121101
ATmega328P LoRa Radio Node is based on SX1276/SX1278 which use the Arduino pro mini 8Mhz 3.3V bootloader, usage same as the Arduino pro mini.
Reference: DWM20061502
The LWL01 is a LoRaWAN Water Leak Sensor. It detects the water leak status and will send periodically data every day as well as for water leak event. It also count the water leak event times and also calculate last water leak duration.
Reference: DWM22051301
LT-W208 LoraWAN Soil NPK Sensor node is Suitable for applications with obstacles. Products are widely used in the field of smart agriculture which is based on LoraWAN global free wireless radio frequency.
Reference: DWM22110601
The CPN01 is an NB-IoT Dry Contact Sensor. It detects open/close status and uplinks the info to IoT server via NB-IoT network. User can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM22090701
TTGO Meshtastic T-Beam V1.1 ESP32 LoRa Development Board 433MHz 868MHz 915MHz 923MHz with WiFi Bluetooth GPS and 0.96 OLED Display.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22090801
SenseCAP S2104 - LoRaWAN Wireless Soil Moisture and Temperature Sensor can help in automatic irrigation systems, greenhouse control, fine agriculture, soil monitoring, and other scenarios.
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM19062801
ESP32-WROOM-32D and ESP32-WROOM-32U are powerful, generic Wi-Fi+BT+BLE MCU modules that target a wide variety of applications, ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streaming and MP3 decoding.
Reference: DWM18011601
RAK8211-NB iTracker combines NB-IoT+BLE+GPS+ 5 Sensors Development Board has BLE GPRS GPS three in one module perfectly solves the problem of data interaction and control in the outdoor environment and the three party platform.
Free Shipping The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
