Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
GPS01 is a GPS module that supports BDS B1/GPS L1/GLONASS L1 frequency point (two out of three) dual-mode navigation. It provides high sensitivity, high positioning accuracy, low power consumption and low cost positioning and navigation solutions.
GPS01 is a GPS module that supports BDS B1/GPS L1/GLONASS L1 frequency point (two out of three) dual-mode navigation. It provides high sensitivity, high positioning accuracy, low power consumption and low cost positioning and navigation solutions for the manufacture of navigation and positioning terminal products such as vehicle, shipborne, handheld and wearable.
Support BDS B1/GPS L1/GLONASS L1 frequency point
With backup power input interface
Support hot start
Support external reset
The following six working modes are supported, and they can be switched through commands:
1） Single BDS B1 working mode
2） Single GPS L1 working mode
3） Single GLONASS L1 working mode
4） BDS B1/GPS L1 dual-mode working mode (default mode)
5） GLONASS L1/BDS B1 dual-mode working mode
6） GLONASS L1/GPS L1 dual mode working mode
Personal positioning and navigation products
Vehicle, ship positioning and navigation
Internet of Things
Handheld portable device
The Connector with NONE is the GPS01 module.
The Connector with the IPEX is the start kit with the GPS01 module with IPEX as the Antenna connector.
The Connector with the SMA is the start kit with the GPS01 module with SMA as the Antenna connector.
| Parameter | Description | Minimum | Typical | Maximum | Unit | Condition |
| Operating conditions | ||||||
| Operating voltage range | VCC | 3.0 | 3.3 | 3.5 | V | |
| V_BCKP | 2.5 | 3.3 | 3.5 | V | ||
| Temperature | Work | -40 | 85 | ℃ | ||
| Storage | -40 | 125 | ℃ | |||
| Current consumption | ||||||
| Receive current | < 30 | mA | VCC=3.3V, V_BCKP=3.3V | |||
| Sleep current | < 20 | uA | VCC=0V, V_BCKP=3.3V | |||
| Radio frequency parameters | ||||||
| Positioning accuracy | Level | < 3 | m | @Open land | ||
| Elevation | < 4.5 | m | ||||
| Sensitivity | capture | -147 | dBm | |||
| track | -163 | dBm | ||||
| External antenna gain | 30 | dB | ||||
| Speed measurement accuracy | < 0.1 | m/s | ||||
| First fix time TTFF | Cold start | < 28 | s | |||
| Hot Start | 1 | s | ||||
| Recapture | 1 | s | ||||
| Serial port parameters | ||||||
| Serial port baud rate | 4800 | 9600 | 230400 | bps | Default 9600bps | |
| Data update rate (Single system) | BDS/GPS /GLONASS | 1 | Hz | |||
| Data update rate (Dual system) | BDS+GPS | 1 | Hz | |||
| BDS+GLONASS | 1 | Hz | ||||
| GPS+GLONASS | 1 | Hz | ||||
|
Pin number |
Pin definition |
I/O |
Level standard |
Description |
|
1、10、12 |
GND |
— |
|
Power ground |
|
2 |
TXD |
O |
0-3.5 V |
Data output, status output |
|
3 |
RXD |
I |
0-3.5 V |
Control command reception |
|
4 |
1PPS |
O |
0-3.5 V |
Second pulse output |
|
5 |
EXT_INT0 |
I |
0-3.5 V |
reserved port |
|
6 |
V_BCKP |
I |
2.5-3.5 V |
Backup power input |
|
7 |
VCC_IO |
— |
3.0-3.5 V |
IO power input |
|
8 |
VCC |
— |
3.0-3.5 V |
Main power input |
|
9 |
nRESET |
I |
0-3.5 V |
External reset, active low. The reset pin can not be connected to the ground capacitor outside the module. |
|
11 |
RF_IN |
I |
|
Antenna input |
|
13 |
ANT_ON |
O |
0-3.5 V |
Built-in IC GPIO, function reserved |
|
14 |
VCC_RF |
O |
VCC |
3.3V output, the antenna is powered by the module, and the antenna working current is recommended not to exceed 20mA |
|
15、18 |
NC |
— |
|
|
|
16 |
SDA |
I/O |
0-3.5 V |
Data signal of two-wire DDC interface |
|
17 |
SCL |
I |
0-3.5 V |
Clock signal of two-wire DDC interface |
Reference: DWM16092702
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM16122102
NEO-6M-0-001 GPS Shield board is a cost-efficient and field-programmable gadget armed with a NEO-6M-0-001 and serial communication configuration.
Reference: DWM17110902
L80-R is an ultra compact GPS POT (Patch on Top) module with an embedded 15.0mm × 15.0mm × 4.0mm patch antenna.
Reference: DWM23010801
RAK2171 is RAK latest LoRaWAN GPS tracking device. It comes in a small form factor with rechargeable battery and tracking and configuration application, available for iOS and Android devices.
Reference: DWM17110902
L80-R is an ultra compact GPS POT (Patch on Top) module with an embedded 15.0mm × 15.0mm × 4.0mm patch antenna.
Reference: DWM19091601
RAK7205 LoRa Tracker built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM15101201
UBLOX module / GPS module / CT-1612UB / 12x16mm / G6010.
Reference: DWM23082002
GPS02-TD module is a quad-mode GPS module that supports BDS/GPS/GLONASS/Galileo/QZSS/ SBAS and fully supports BeiDou B3, which can provide users with high quality, strong anti-jamming and low-power positioning and navigation solutions.
Reference: DWM23082003
GPS02-UBX GPS module features the u-blox M10 standard precision GNSS platform and provides exceptional sensitivity and acquisition times for all L1 GNSS signals Supports concurrent reception of up to four GNSS (GPS, GLONASS, Galileo, and BDS)
Reference: DWM23082001
GPS01-ZK module is a tri-mode Mini GPS module that supports BDS/GPS/GLONASS/QZSS/SBAS and fully supports BeiDou B3, which can provide users with high quality, strong anti-jamming and low-power positioning and navigation solutions.
Reference: DWM23081901
GPS01-TD module is a quad-mode Mini GPS module that supports BDS/GPS/GLONASS/Galileo/QZSS/SBAS and fully supports BeiDou B3, which can provide users with high quality, strong anti-jamming and low-power positioning and navigation solutions.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products,allowing users to conveniently link to the LoRaWAN network.
GPS01 is a GPS module that supports BDS B1/GPS L1/GLONASS L1 frequency point (two out of three) dual-mode navigation. It provides high sensitivity, high positioning accuracy, low power consumption and low cost positioning and navigation solutions.
