Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
HELTEC LoRa32 V3.1 can install the Meshtastic firmware as a development board which is a highly integrated product based on ESP32(including WiFI and BLE), Li-Po battery management system,0.96” OLED also included.
HELTEC LoRa32 V3.1 can install the Meshtastic firmware as a development board which is a highly integrated product based on ESP32(including WiFI and BLE), Li-Po battery management system,0.96” OLED also included.
ESP32-S3FN8 (WiFi & Bluetooth)
Semtech SX1262
Frequency Options:
433 MHz
470 - 510 MHz
863 - 870 MHz
902 - 928 MHz
USB-C
Dedicated 2.4 GHz metal spring antenna for WiFi/Bluetooth
U.FL/IPEX antenna connector for LoRa
Built in 0.96 inch OLED display
User and Reset Buttons
No GPS
SDA: GPIO41
SCL: GPIO42
| Parameters | Description |
|---|---|
| Master Chip | ESP32-S3FN8(Xtensa®32-bit lx7 dual core processor) |
| USB to Serial Chip | CP2102 |
| WiFi | 802.11 b/g/n, up to 150Mbps |
| Bluetooth LE | Bluetooth 5, Bluetooth mesh |
| Hardware Resource | 7*ADC1+2*ADC2; 7*Touch; 3*UART; 2*I2C; 2*SPI, etc. |
| Memory | 384KB ROM; 512KB SRAM; 16KB RTC SRAM; 8MB SiP Flash |
| Interface | Type-C USB; 2*1.25 lithium battery interface; 2*18*2.54 Header Pin |
| Battery | 3.7V lithium battery power supply and charging |
| Power Consumption | Deep Sleep 10uA |
| Operating Temperature | -20~70℃ |
| Dimensions | 50.2 * 25.5* 10.2 mm |
x1 - Heltec WiFi LoRa 32 (V3) Pre-flashed with Meshtastic
x1 - LoRa Antenna
x1 - SH1.25×2 Battery Connector
x2 - Pin Headers
Reference: DWM22090701
TTGO Meshtastic T-Beam V1.1 ESP32 LoRa Development Board 433MHz 868MHz 915MHz 923MHz with WiFi Bluetooth GPS and 0.96 OLED Display.
Reference: DWM22091502
TTGO T-Echo SoftRF LoRa SX1262 Wireless Module 433/868/915MHz NRF52840 1.54 E-Paper GPS RTC NFC for Arduino.
Reference: DWM22123004
WiFi LoRa 32 is a classic IoT dev-board designed & produced by Heltec Automation. The newly launched V3 version has the same pin sequence as the V2 version and retains Wi-Fi, BLE, LoRa, OLED display, and other functions.
Reference: DWM24012601
The Meshtastic starter Kit includes a WisBlock Base board and the RAK4631 WisBlock Core module, already flashed with the Meshtastic firmware. Power the boards up and start sending messages immediately.
Reference: DWM23010504
ESP32-S3 SX1262 WIFI BLE LoRa/ LoRaWAN Wireless Stick-V3 provides Wi-Fi, BLE, and LoRa solutions, which perfectly support Arduino®。 Users can easily carry out secondary development and application.
Reference: DWM22022801
HT-M2808 HNT Miner Helium Full Hotspot is as an efficient miner for a new cryptocurrency, Helium (HNT) which can provides a WiFi configuration interface via the device's BLE services.
Reference: DWM20101001
DWM-HTCC-AC02 is based on ASR6501 and SX1262 support Arduino®, can run the LoRaWAN 1.0.2 protocol can easily connect batteries and solar panels sensor node.
Reference: DWM22051404
LoRaWAN Helium HNT miner Indoor networking antenna available with 433MHz,868MHz and 915MHz.
Reference: DWM20111002
DWM-HTCC-1/2AA is based on ASR6502 and SX1262 support Arduino®, can run the LoRaWAN 1.0.2 protocol can easily connect batteries end sensor node.
Reference: DWM20101002
DWM-HTCC-AC01 is based on ASR6501 and SX1262 support Arduino®, can run the LoRaWAN 1.0.3 protocol can easily connect batteries and solar panels sensor node.
Reference: DWM23010501
HT-CT62 is a Low cost WIFI LoRa/ LoRaWAN module for long range wireless communication for smart cities, smart farms, smart homes, and IoT makers. Support the Arduino development environment.
Reference: DWM22092703
he ATECC608B is a secure element from the Microchip CryptoAuthenticationTM portfolio with advanced Elliptic Curve Cryptography (ECC) capabilities.
Reference: DWM23010502
HTIT-Wsh ESP32-S3 SX1262 WIFI BLE LoRa/ LoRaWAN Wireless Shell-V3 provides Wi-Fi, BLE, and LoRa solutions, which perfectly support Arduino development environment.
Reference: DWM20101301
DWM-HT-M01 SX1308 Baseband Mini LoRaWAN gateway support both SPI and USB interface can work with Windows® (7, 8, 10 or higher) or Linux (Raspberry Pi®).
Reference: DWM23010503
ESP32-LoRa Dev Backplane Compatible with HTIT-Wsh and HT-CT62.
Reference: DWM22123004
WiFi LoRa 32 is a classic IoT dev-board designed & produced by Heltec Automation. The newly launched V3 version has the same pin sequence as the V2 version and retains Wi-Fi, BLE, LoRa, OLED display, and other functions.
Reference: DWM20101101
DWM-HT-M00 dual-channel LoRaWAN gateway Drive SX1276 chip by ESP32 low-cost , with Type-C interface.
Reference: DWM24061702
HELTEC Stick Lite V3 can install the Meshtastic firmware as a development board which is a highly integrated product based on ESP32(including WiFI and BLE), Li-Po battery management system.
Reference: DWM22123004
HT-M02 design strictly with industrial standards for the industrial environment, Integrated Linux Operating System (4.19 Kernel, Debian Stretch10).Support DC power supply and PoE power supply, support 4G(cat.1, cat.4），WiFi / Bluetooth，it is convenient for users to apply in different scenarios.
Reference: DWM24061801
HELTEC Wireless Tracker can install the Meshtastic firmware as a development board which is based on ESP32-S3FN8. It integrates both SX1262 and UC6580 to provide fast GNSS solution for IoT.
HELTEC LoRa32 V3.1 can install the Meshtastic firmware as a development board which is a highly integrated product based on ESP32(including WiFI and BLE), Li-Po battery management system,0.96” OLED also included.
