Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.It is designed to measure the soil moisture of saline-alkali soil and loamy soil. The soil sensor uses FDR method to calculate the soil moisture with the compensation from soil temperature and conductivity. It also has been calibrated in factory for Mineral soil type.
The LoRa wireless technology used in LSE01 allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
LSE01 is powered by 4000mA Li-SOCI2 battery, It is designed for long term use up to 10 years.
Each LES01 is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
Features:
* LoRaWAN 1.0.3 Class A
* Ultro low power consumption
* Monitor Soil Moisture
* Monitor Soil Temperature
* Monitor Soil Conductivity Temperature Compensation
* AT Commands to change parameters
* Uplink on periodically
* Downlink to change configure
* IP66 Waterproof Enclosure
* 4000mAh Battery for long term use
Package Content:
* LSE01 Soil Moisture & EC Sensor
Dimension and Weight:
Package:
Size: 195 x 125 x 55 mm
Weight: 420g
LSE01-XXX
XXX: the default frequency band
EU433: Default frequency band EU433
CN470: Default frequency band CN470
EU868: Default frequency band EU868
IN865: Default frequency band IN865
KR920: Default frequency band KR920
AS923: Default frequency band AS923
AU915: Default frequency band AU915
US915: Default frequency band US915
Reference: DWM21051603
The LSNPK01 is a LoRaWAN Soil NPK Sensor for IoT of Agriculturebase. detects soil's Nitrogen, Phosphorus, and Potassium use TDR method, and uploads these values via wireless to LoRaWAN IoT Server.
Reference: DWM21051604
The LLMS01 LoRaWAN Leaf Moisture Sensor for IoT of Agriculture it is designed to measure the leaf moisture and temperature to analyze the leaf status such as : watering, moisturizing, dew, frozen.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM21051601
The LWL02 is a LoRaWAN Water Leak Sensor. It build in SX1262 can indicates a water leak event and uplink to IoT server via LoRaWAN network 2 x AAA batteries which can work in 2 ~ 10 years battery life.
Reference: DWM18110502
LT-33222-L is The Dragino LT series I/O Modules are Long Range LoRa I/O Controller designed to simplify the installation of I/O monitoring.
Reference: DWM23072201
The SW3L-LB is a new LoRaWAN Outdoor water Flow Sensor that supports BLE configuration and wireless OTA update which is used to detect water flow volume and uplink to the IoT server via the LoRaWAN network it can be used for indoor and outdoor use.
Reference: DWM20060201
The IoT Wireless ear tag sensor build by BDDBTECH offers a completed solution for the dairy farm Management system.
Reference: DWM21030101
LIG16 Indoor LoRaWAN Gateway Build in SX1302 and SX1250 LoRa Tranceiver this gateway with lower current consumption and higher amount of traffic than preceding devices.
Reference: DWM23030701
MH-Z19E NDIR infrared gas module Built-in temperature compensation; and it has UART output and PWM output It uses the principle of non-dispersive infrared (NDIR) to detect CO2 in the air and has good selectivity. No oxygen dependence, long life, etc.
Reference: DWM23050801
SN50V3-LB is the 3rd generation of the LSN50 series generic sensor node built-in BLE support OTA upgrade private LoRa protocol for easy maintenance.
Reference: DWM20022602
The Dragino RS485-LN is a RS485 to LoRaWAN Converter. It converts the RS485 devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM18110801
Build your own LoRaWAN "The Things Network" packet-forwarding gateway on Windows 10 IoT Core in native .NET code.
Reference: DWM14033102
Brand: Semtech
The RFM96W / RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM23072301
The CPL03-LB is a LoRaWAN Contact Sensor supports BLE configure and wireless OTA update. It detects open/close status and uplinks to IoT server via LoRaWAN network. user can see the dry contact status, open time, open counts in the IoT Server.
Reference: DWM22051403
HP0D is Outdoor LoRaWAN gateway it supports the miner feature from Helium and has a built-in ATECC608 encryption chip. It can be used as a Helium Full Hotspot for the project.
Reference: DWM23072205
DDS20-LB is a LoRaWAN Ultrasonic liquid level sensor supports BLE configure and wireless OTA update uses none-contact method to measure the height of liquid in a container without opening the container, and send the value via LoRaWAN network to IoT Server.
Reference: DWM22110601
The CPN01 is an NB-IoT Dry Contact Sensor. It detects open/close status and uplinks the info to IoT server via NB-IoT network. User can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM18121802
DWM-WWR Spot new weather station wind speed sensor wind direction and rainfall Internet of things Secondary development .
Reference: DWM22082508
Ultrasonic Sensors A01A-15,A02-15,A13-15,A16-15 for LDDS04 LoRaWAN 4 channels sensor node.
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
