Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The ZED-F9P development board is suitable for various industry applications such as research and development projects, drones, unmanned boats, autonomous driving, robots, driving schools, surveying and mapping, precision agriculture, ext.
The ZED-F9P development board is suitable for various industry applications such as research and development projects, drones, unmanned boats, autonomous driving, robots, driving schools, surveying and mapping, precision agriculture, mountain landslide monitoring, mining monitoring, vehicle navigation, walkie-talkies, differential base stations, and more. Default shipping configuration: It uses the ZED-F9P-01B-01 GNSS chip with dual-frequency multi-mode signal output, a 4-pin terminal (1.0) interface, UART TTL level, 5V power supply, baud rate of 38400, update rate of 1Hz, and NMEA-0183 protocol output.
| Item | Description | |
| Spec of chip | Chip | U-BLOX ZED-F9P-01B-0 |
| Receiving mode | GPS,GLONASS,BDS,GALILEO,QZSS | |
| Frequency | GPS L1C/AL2C,GLO L1OF L2OF,GALE1B/C E5b, BDS B1I B2I,QZSS L1C/AL1S L2C,SBAS L1C/A |
|
| Channels | 184-Channels | |
| Sensitivity | Tracking | -167dBm |
| Reacquisition | -160dBm | |
| Cold start | -148dBm | |
| Hot start | -157dBm | |
| Accuracy | RTK horizontal accuracy | RTK 0.01m+1ppm CEP |
| RTK vertical accuracy | RTK 0.01m+1ppm CEP | |
| horizontal accuracy | 1.5m CEP | |
| vertical accuracy | 1.5m CEP | |
| Velocity | 0.05m/s | |
| Heading accuracy | 0.4 deg(When the antenna baseline length is 1m) | |
| Dynamic heading accuracy | 0.3 deg | |
| Pulse signal timing | RMS 30ns 99% 60ns | |
| Acquisition | Cold start | 24s |
| Warm start | 2s | |
| Hot start | 2s | |
| Convergence time |
RTK | <10 sec |
| Data output | Baud rate | 4800bps to 921600bps,Default 38400bps |
| Output level | TTL level | |
| Output protocol | NMEA-0183 | |
| Update rate | 1Hz to 20Hz,Default 1 Hz | |
| Flash | 4M Flash, store the configuration permanently | |
| Timepulse | Configurable:0.25Hz to 10MHz | |
| RAWX | Support Multi-GNSS Raw Measurement data output | |
| Operational limits |
Dynamics | ≤4g |
| Altitude | ≤50000m | |
| Velocity | ≤500m/s | |
| Power Consumption |
Voltage | DC Voltage 3.6V~6.0V,Typical:5.0V |
| Current | 80mA/5.0V | |
| Physical Parameters |
Size | 35mm*26mm*13mm |
| Weight | 8g | |
| Connector | 2 PCS 1.0mm spacing 4pins connector | |
| Output protocol | NMEA, UBX binary. RTCM v.3.3 |
NMEA:GNRMC,GNVTG,GNGGA,GNGSA,GPGSA,GLGSV, GAGSV, GBGSV, GPGLL |
| Environment | Operating temperature | -40℃ to +85℃ |
| Storage temperature | -40°℃ to+105℃ | |
| Port | Pin | Name | Description |
| Port1 1-4pin | 1 | RX1 | UART serial data input.TTL level |
| 2 | TX1 | UART serial data output.TTL level | |
| 3 | GND1 | Ground | |
| 4 | VCC1 | Main power supply,3.3V-5V DC voltage input,5V recommended | |
| Port2 1-4pin | 1 | RX2 | UART serial data input.TTL level |
| 2 | TX2 | UART serial data output.TTL level | |
| 3 | GND2 | Ground | |
| 4 | VCC2 | Main power supply,3.3V-5V DC voltage input,5V recommended | |
|
Description: LED Indicater: 1. Red LED: Power LED, will always be on when there is a voltage input. 2. Green LED: 1PPS LED, not bright when not fixed, and flashing when the 3D fixed. 3. Blue LED: RTK LED, The mobile terminal does not enter RTK mode and the light is off; enters RTK Float mode, the blue light flashes; enter RTK Fixed mode, the blue light is always on. The base station is not lit regardless of any status. 4. Orange LED: GEO LED, customer-defined, unnecessary, temporarily reserved, and not open
|
|||
1pcs ZED-F9P Development Module.
1pcs Cable
1pcs ZED-F9P Development Module.
1pcs Cable
1pcs GNSS high-precision positioning antenna
1pcs ZED-F9P Development Module.
1pcs Cable
1pcs Three-system seven-frequency external measurement antenna
Reference: DWM17110902
L80-R is an ultra compact GPS POT (Patch on Top) module with an embedded 15.0mm × 15.0mm × 4.0mm patch antenna.
Reference: DWM23081801
GPS01 is a GPS module that supports BDS B1/GPS L1/GLONASS L1 frequency point (two out of three) dual-mode navigation. It provides high sensitivity, high positioning accuracy, low power consumption and low cost positioning and navigation solutions.
Reference: DWM23082001
GPS01-ZK module is a tri-mode Mini GPS module that supports BDS/GPS/GLONASS/QZSS/SBAS and fully supports BeiDou B3, which can provide users with high quality, strong anti-jamming and low-power positioning and navigation solutions.
Reference: DWM23082002
GPS02-TD module is a quad-mode GPS module that supports BDS/GPS/GLONASS/Galileo/QZSS/ SBAS and fully supports BeiDou B3, which can provide users with high quality, strong anti-jamming and low-power positioning and navigation solutions.
Reference: DWM24060301
1.2/ 1.3GHz 100mW wireless audio and video transmitter receiver module with the wire connector interface Red: Power Supply (3.7-5V). Black: GND. Yellow: Video. White: Audio (5.5M).
Reference: DWM24052901
IKUN20 DJI 03 AIR UNIT HD VTX Drone is equipped with an ELRS 2.4GHz Receiver for easy installation and maintenance. With a stable stack featuring 11066000KV + D51 -5, it ensures flight stability and a smoother experience.
The ZED-F9P development board is suitable for various industry applications such as research and development projects, drones, unmanned boats, autonomous driving, robots, driving schools, surveying and mapping, precision agriculture, ext.
