All best sellers

UWB3000F27 Bi-Directional Ranging Transceiver For Precision Positioning And Ranging

DWM24071302

The UWB3000F27 adopted Qorvo's DW3000, designed with a PCB antenna and a 500mW high-power amplifier chip.  UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.

Type
$115.00
Quantity

The minimum purchase order quantity for the product is 2.

Description

UWB3000F27 adopted Qorvo's DW3000, designed with a PCB antenna and a 500mW high-power amplifier chip. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.

Features

Core chipset: DW3000

Frequency: 6489.6 MHz & 7987.2 MHz

Output Power: 500mW

positioning accuracy: Asset location to an accuracy of 10 cm

Data rates: 850 kbps and 6.8 Mbps

I15.4-2015 UWB

15.4z(BPRF mode)

Supports channels 5 & 9(6489.6 MHz & 7987.2 MHz)

Data rates of 850 kbps and 6.8 Mbps

Integrated HW AES 256

Worldwide UWB Radio

Regulatory compliance

Packet length up to 1023 bytes

Supports 2-way ranging, TDoAand PDoA location schemes

Programmable output power

Provides precision location and data transfer simultaneously

Asset location to an accuracy of 10 cm

Low power consumption for coin cell applications

Applications

Precision real-time location systems (RTLS) using two-way ranging, TDoA or PDoA schemes in a variety of markets: Healthcare\ Consumer\ Industrial\ Automotive

Location-aware wireless sensor networks

Presence detection for secure entry and secure payment

Parameters:

Parameter

Condition

Min.

Typ.

Max.

Unit

Supply Voltage

3.0

5.0

5.5

V

Operating Temperature Range

- 40

25

85

Frequency Range

CH5

6489.6

MHz

RF Data Rate

850k

6.8M

bps

Current Consumption

Sleep Mode

CH5

< 1.3

uA

Rx CH5

CH5

93

mA

Rx CH9

mA

Tx

CH5

310

mA

TX for range measurement

CH5

21

mA

Transmit parameters

Tx Power

@VCC=3.3V

0

27

dBm

Tx Bandwidth(BW)

499.2

MHz

Receive parameters

Rx Sensitivity

@850Kbps

-100

dBm

@6.8Mbps

-94

dBm

Pin Definitions:

Pin No.

Pin definition

I/O

Level

Description

1

VCC

VCC (3.0-5.5V)

2,12,13,15

GND

Ground

3

WAKEUP

DI

0-3.3v

When asserted into its active high state, the WAKEUP pin brings the DW3000 out of SLEEP or DEEPSLEEP states into operational mode.

This should be connected to ground if not used.

4

NRSTn

DIO

0-3.3v

Reset pin. Active Low Output.

May be pulled low by external open drain driver to reset the DW3000.

Must not be pulled high by external source.

5

CLK

DI

0-3.3v

SPI peripheral clock input.

6

MOSI

DI

0-3.3v

SPI peripheral data input.

7

MISO

DO

0-3.3v

SPI peripheral data output.

8

CSN

DI

0-3.3v

SPI chip select. This is an active low enable input. The high-to-low transition on SPICSn signals the start of a new SPI transaction. SPICSn can also act as a wake-up signal to bring DW3000 out of either SLEEP or DEEPSLEEP states.

9

IRQ

DI

0-3.3v

Interrupt request output from the DW3000 to the host processor. By default, IRQ is an active-high output but may be configured to be active-low if required. Correct operation in SLEEP and DEEPSLEEP modes should be configured for active high operation. This pin will float in SLEEP and DEEPSLEEP states and may cause spurious interrupts on the host unless pulled low externally (100kΩ recommended). When the IRQ functionality is not being used the pin may be reconfigured as a general-purpose I/O line2, GPIO8.

10

GPIO4

DIO

0-3.3v

GPIO4 from DW3000.

11

GPIO7

DIO

0-3.3v

GPIO7 from DW3000.

14

ANT

External 50 euro antenna

Package Include:

Start KIT

2 x UWB3000F27 Demo Board

Module

1 x UWB3000F27 Module.

Useful Link:

Datasheet

UWB DW3000 Arduino 

UWB3000FX Demo Board User Guide

Product Details
DWM24071302
100 Items
You might also like
13 other products in the same category:

Reference: DWM23051301

SA868 VHF& UHF 2W Analog Embedded Walkie Talkie Module

SA868 is a cost-effective integrated professional walkie-talkie module which include UHF band 400~480 MHz, 320-400MHz and VHF band 134~174 MHz 3 frequency bands versions built-in high-speed microcontroller, high-performance RF transceiver chip and RF power amplifier.

Price $15.00
More
In stock

Reviews

Write your review

UWB3000F27 Bi-Directional Ranging Transceiver For Precision Positioning And Ranging

The UWB3000F27 adopted Qorvo's DW3000, designed with a PCB antenna and a 500mW high-power amplifier chip.  UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.

Write your review

Follow us on Facebook