Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The UWB3000F00 adopted Qorvo's DW3000, designed with PCB Antenna. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.
The UWB3000F00 adopted Qorvo's DW3000, designed with PCB Antenna. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.
Core chipset: DW3000
Frequency: 6489.6 MHz & 7987.2 MHz
positioning accuracy: Asset location to an accuracy of 10 cm
Data rates: 850 kbps and 6.8 Mbps
I15.4-2015 UWB
15.4z(BPRF mode)
Supports channels 5 & 9(6489.6 MHz & 7987.2 MHz)
Data rates of 850 kbps and 6.8 Mbps
Integrated HW AES 256
Worldwide UWB Radio
Regulatory compliance
Packet length up to 1023 bytes
Supports 2-way ranging, TDoAand PDoA location schemes
Programmable output power
Provides precision location and data transfer simultaneously
Asset location to an accuracy of 10 cm
Low power consumption for coin cell applications
Precision real-time location systems (RTLS) using two-way ranging, TDoA or PDoA schemes in a variety of markets: Healthcare\ Consumer\ Industrial\ Automotive
Location-aware wireless sensor networks
Presence detection for secure entry and secure payment
|
Parameter |
Condition |
Min. |
Typ. |
Max. |
Unit |
|
Supply Voltage |
2.4 |
3.3 |
3.6 |
V |
|
|
Operating Temperature Range |
- 40 |
25 |
85 |
℃ |
|
|
Frequency Range |
CH5 |
6489.6 |
MHz |
||
|
CH9 |
7987.2 |
MHz |
|||
|
RF Data Rate |
850k |
6.8M |
bps |
||
|
Current Consumption |
|||||
|
Sleep Mode |
< 1 |
uA |
|||
|
Rx CH5 |
72 |
mA |
|||
|
Rx CH9 |
88 |
mA |
|||
|
Tx |
69 |
mA |
|||
|
TX for range measurement |
21 |
mA |
|||
|
Transmit parameters |
|||||
|
Tx Power |
@VCC=3.3V |
-30 |
0 |
dBm |
|
|
Tx Bandwidth（BW) |
499.2 |
MHz |
|||
|
Receive parameters |
|||||
|
Rx Sensitivity |
@850Kbps |
-100 |
dBm |
||
|
@6.8Mbps |
-94 |
dBm |
|||
|
Pin No. |
Pin definition |
I/O |
Description |
|
1,2,3,7 |
GND |
Ground |
|
|
4,5,6 |
VCC |
VCC (2.4-3.6v) |
|
|
8 |
EXTON |
DO |
External device enable. Asserted during the wake-up process and held active until the device enters sleep mode. Can be used to control external DC-DC converters or other circuits that are not required when the device is in sleep mode so as to minimize power consumption. |
|
9 |
WAKEUP |
DI |
When asserted into its active high state, the WAKEUP pin brings the DW3000 out of SLEEP or DEEPSLEEP states into operational mode. This should be connected to the ground if not used. |
|
10 |
NRSTn |
DIO |
Reset pin. Active Low Output. May be pulled low by an external open drain driver to reset the DW3000. Must not be pulled high by an external source. |
|
11 |
CLK |
DI |
SPI peripheral clock input. |
|
12 |
MOST |
DI |
SPI peripheral data input. |
|
13 |
MISO |
DO |
SPI peripheral data output. |
|
14 |
CSN |
DI |
SPI chip select. This is an active low enable input. The high-to-low transition on SPICSn signals the start of a new SPI transaction. SPICSn can also act as a wake-up signal to bring DW3000 out of either SLEEP or DEEPSLEEP states. |
|
15 |
IRAQ |
DI |
Interrupt request output from the DW3000 to the host processor. By default, IRQ is an active-high output but may be configured to be active low if required. Correct operation in SLEEP and DEEPSLEEP modes should be configured for active high operation. This pin will float in SLEEP and DEEPSLEEP states and may cause spurious interrupts on the host unless pulled low externally (100kΩ recommended). When the IRQ functionality is not being used the pin may be reconfigured as a general-purpose I/O line2, GPIO8. |
|
16 |
GPIO0 |
DIO |
GPIO0 from DW3000. |
|
17 |
GPIO1 |
DIO |
GPIO1 from DW3000. |
|
18 |
GPIO2 |
DIO |
GPIO2 from DW3000. |
|
19 |
GPIO3 |
DIO |
GPIO3 from DW3000. |
|
20 |
GPIO4 |
DIO |
GPIO4 from DW3000. |
|
21 |
GPIO5 |
DIO |
GPIO5 from DW3000. |
|
22 |
GPIO6 |
DIO |
GPIO6 from DW3000. |
2 x UWB3000F00 Demo Board
1 x UWB3000F00 Module.
Reference: DWM20101401
The DWM1000 is an IEEE802.15.4-2011 UWB compliant wireless transceiver module based on Decawave’s DW1000 IC. This module enables the location of objects in real time location systems (RTLS) .
Reference: DWM20101403
DWM1001 integrates DWM1000 UWB and nRF52832 Bluetooth module for RTLS system with with a motion sensor.
Reference: DWM24071302
The UWB3000F27 adopted Qorvo's DW3000, designed with a PCB antenna and a 500mW high-power amplifier chip. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.
Reference: DWM24071303
The UWB650 module is based on Ultra Wide Band (UWB) technology and compliant with the IEEE 802.15.4-2020 Standard protocol. Users can easily utilize these functions through the UART interface on the module without the need for additional design and development.
Reference: DWM15121801
2sets Sa828 All-in-oneV band,134 -- 174MHz, U band, 400 -- 480MHz,3.5-5Km communication distance Walkie Talkie Voice Module for Pocket /handheld devices tytera radios /trunking radio module. .
Reference: DWM24071302
The UWB3000F27 adopted Qorvo's DW3000, designed with a PCB antenna and a 500mW high-power amplifier chip. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.
Reference: DWM24071303
The UWB650 module is based on Ultra Wide Band (UWB) technology and compliant with the IEEE 802.15.4-2020 Standard protocol. Users can easily utilize these functions through the UART interface on the module without the need for additional design and development.
Reference: DWM16050203
DWM-SV6202 433MHz /470MHz 2W High Power 5Km Long Distance Wireless Transceiver modem which adopts the high performance Si4432,It has 3 optional Interface TTL, 232, 485,40 channels.
Reference: DWM16050202
DWM-SV6300 which adopts the Si4432 3 Watt 8km Ultra-long Range Network Repeater Module,It has 3 optional Interface TTL, 232, 485,40 channels,430MHz,470MHz transceiver.
Reference: DWM23082101
This kit based on the RF125-TX and RF125-RA which built with a RF125-RX module.the kit will allow the user to develop their application required Wireless Air Wake-Up before the data transmission.
Reference: DWM14071902
DWM-SA828 V band,134 -- 174MHz, U band, 400 -- 480MHz,3.5-5Km communication distance high-integrated Embedded walkie talkie module for Pocket /handheld device tytera radios or trunking radio module.
Reference: DWM16022502
SV611 is an Industrial class & highly-integrated RF transceiver module,Core chipset is Si4432 with TTL / 232 /485 user interface.
Reference: DWM23051301
SA868 is a cost-effective integrated professional walkie-talkie module which include UHF band 400~480 MHz, 320-400MHz and VHF band 134~174 MHz 3 frequency bands versions built-in high-speed microcontroller, high-performance RF transceiver chip and RF power amplifier.
Reference: DWM24062802
SA628F22 22dBm full duplex wireless voice module with mesh network. Easy setup, high-quality voice, LoRa technology, OTA upgrades, and eco-friendly production.
Reference: DWM14071901
DWM-SA818 V band,134 -- 174MHz, U band, 400 -- 480MHz,3.5-5Km communication distance high-integrated Embedded walkie talkie module.
Reference: DWM24062801
SA628F30 1W full duplex wireless voice module with mesh network. Easy setup, high-quality voice, LoRa technology, OTA upgrades, and eco-friendly production.
Reference: DWM16050201
DWM-SV6500 which adopts the Si4432 5 Watt 8km Ultra-long Range Network Repeater Module,It has 3 optional Interface TTL, 232, 485,40 channels,430MHz,470MHz transceiver.
The UWB3000F00 adopted Qorvo's DW3000, designed with PCB Antenna. UWB3000 is in line with IEEE802.15.4-2015 and IEEE802.15.4z (BPRF mode). It can be used for two-way ranging, TDOA, and PDOA systems, with a positioning accuracy of 10 cm.
