Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
WSS-03 is a RS485 Air Quality sensor. It can monitor CO2, PM2.5 and PM10 at the same time by RS485 interface to WSC1-L which can detect and upload the environment CO2, PM2.5 and PM10 to the IoT Server via wireless LoRaWAN protocol.
WSS-03 is an RS-485 air Quality sensor. It can monitor CO2, PM2.5, and PM10 at the same time.
WSS-03 uses a weatherproof shield that can make sure the sensors are well protected against UV & radiation.
WSS-03 is designed to support the Dragino Weather Station solution.
Users only need to connect the WSS-03 RS485 interface to WSC1-L, WSC2-LB. The weather station's main processor, WSC1-L, can detect and upload the environment's CO2, PM2.5, and PM10 to the IoT Server via the wireless LoRaWAN protocol.
RS485 CO2, PM2.5, PM10 sensor
NDIR to measure CO2 with Internal Temperature Compensation
Laser Beam Scattering to PM2.5 and PM10
CO2 Range:0～5000ppm, accuracy:±3%F•S（25℃）
CO2 resolution: 1ppm
PM2.5/PM10 Range:0～1000μg/m3, accuracy ±3%F•S（25℃）
PM2.5/PM10 resolution:1μg/m3
Input Power: DC 7~24V
Preheat time: 3min
Interface: RS-485
Working Temperature: CO2: 0℃～50℃; PM2.5/PM10:-30~50℃
Working Humidity: PM2.5/PM10:15～80%RH (no dewing); CO2:0～95%RH
Power Consumption: 50mA@ 12v.
Weather Station
User Manual Based on the WSC1-L
User Manual Based on the WSC2-LB
Reference: DWM22040502
WSC1-L Dragino Weather Station solution Main Process Unit can upload these sensor data to IoT server via LoRaWAN wireless protocol.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22091602
WSS-02 is a RS485 wind speed and wind direction monitor designed for weather station solution.
Reference: DWM22092201
WSS-05 is a 4 in 1 RS485 sensor which can monitor Temperature, Humidity, Illuminance and Pressure at the same time which can work with WSC1-L or WSC2-LB weather station main processor.
Reference: DWM18073001
LG02-P is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM18110902
Getting started with LoRaWAN for Cypress PSoC 6 MCU based on LMiC to access to LoRaWAN TTN (The Things Network) using Dragino LoRa gateway, RFM95W.
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM23072207
The MDS200-LB is a LoRaWAN Microwave Radar distance sensor supports BLE configure and wireless OTA update which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: DWM22100701
Dragino LoRa IoT Kit v3 is designed to facilitate beginners and developers to quickly learn and demonstrate LoRa/LoRaWAN and IoT technology. It helps users to turn the idea into a practical application and make the Internet of Things a reality.
Reference: DWM23072202
WL03A-LB is a New LoRaWAN Water Leak Controller which supports BLE configure and wireless OTA update use a sensitivity Water Leak Cable on the ground to detect water leakage.
Reference: DWM19062701
Yun Shield v1.1.6 runs Open Source OpenWrt system solve the Internet connectivity and storage issue for Arduino Board.
Reference: DWM19090403
The PG1301 build by SX1301 and SX1257 which is The 10 channels - LoRaWAN GPS Concentrator for Raspberry Pi can connect to 5000 nodes.
Reference: DWM22110601
The CPN01 is an NB-IoT Dry Contact Sensor. It detects open/close status and uplinks the info to IoT server via NB-IoT network. User can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22072103
LA66 is a ready-to-use module that includesLoRaWAN v1.0.4 protocol and also supports open-source peer-to-peer LoRa Protocol for the none-LoRaWAN application.
Reference: DWM22100802
AN-102D LoRaWAN smoke detector sensor node with high-precision, the device emits red light when it detects a fire alarm. The device sends alarm data to the platform to remind relevant personnel on the site to deal solve it.
Reference: DWM23070204
UV254-LB is a LoRaWAN UVC Radiation Sensor is designed for detecting the intensity of ultraviolet lamps UVC is harmful to human health and to know UVC lamp is operate efficacy and make sure it won't work in unexpected time.
Reference: DWM23021006
The LHT65S-E5 Temperature, Humidity & Illuminance sensor is a Long Range LoRaWAN Sensor. It includes a built-in Temperature & Humidity sensor and has an external Illuminance sensor.
Reference: DWM23050802
PS-LB-NA convert the Analog Value to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway. supports BLE configure and wireless OTA update.
WSS-03 is a RS485 Air Quality sensor. It can monitor CO2, PM2.5 and PM10 at the same time by RS485 interface to WSC1-L which can detect and upload the environment CO2, PM2.5 and PM10 to the IoT Server via wireless LoRaWAN protocol.
