Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The B200 Advanced version can seamlessly replace the B200 Original version and provides dual-receive dual-transmit capability.
The B200 Advanced version can seamlessly replace the B200 Original version and provides dual-receive dual-transmit capability. As long as you use the FPGA firmware provided by our store to replace the original B210's FPGA firmware, you can achieve dual-receive dual-transmit just like the B210.
|
Data interface |
usb3.0 |
|
FPGA |
Spartan 6 XC6SLX75 |
|
Transceiver |
AD9361 dual channel RF transceiver |
|
IIP3 (at typical NF) |
-20 dBm |
|
Power Output |
> 10 dBm |
|
Receive Noise Figure |
< 8 dB |
|
ADC Sample Rate (Max.) |
61.44 MS/s |
|
ADC Resolution |
12 bits |
|
DAC Sample Rate (Max.) |
61.44 MS/s |
|
DAC Resolution |
12 bits |
|
Host Sample Rate (16b) |
61.44 MS/s |
|
Frequency Accuracy(without reference clock) |
±2.0 ppm |
|
Frequency Accuracy(with reference clock) |
±1PPB(0.001PPM) |
|
SIZE |
150MM*100MM |
|
frequency range |
70-6000Mhz |
|
tx port count |
2 |
|
rx port count |
2 |
Use the following test command to test the output power at various frequencies:
Test Command: sudo ./tx_waveforms --rate 0.5e6 --freq 470e6 --gain 90 --ampl 0.9 --wave-type SINE --wave-freq 0.1e6
| Frequency | 470M | 900M | 1800M | 2400M | 3200M | 4000M | 5000M | 5600M |
| Power output | 19dbm | 19dbm | 16dbm | 13dbm | 14dbm | 12dbm | 14dbm | 8dbm |
1x Daul channels B200 with a Black Steel Enclosure
1x USB3.0 Cable
2x 700MHz -2700MHz gain 3dBi antenna
1x Power adaptor
Reference: DWM19070301
RF Explorer - ISM WSUB1G Handheld Digital Spectrum Analyzer is a very affordable tool for work in 240 - 960 MHz ISM popular frequency bands.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM23070301
LoRaWAN Field Tester which helps to LoRaWAN network coverage it's easy to investigate whether the required area of sensor nodes is covered by gateways.
Reference: DWM24022901
The P-NUCLEO-LRWAN2 STM32 Nucleo starter pack is a development tool to learn and quickly develop low-power wide-area network (LPWAN) solutions. The pack contains both an LPWAN end-node and its related gateway.
Reference: DWM14121902
Cooperkit Button is finger-sized, which can be connected to I/O port of main board or externally disconnected to check the switch state so as to control ON/OFF of LED lamp.
Reference: DWM15110404
BeagleBone Black is an MSRP community-supported development platform for developers and hobbyists. Boot Linux in under 10 seconds and get started on development in less than 5 minutes with just a single USB cable.
Reference: DWM14121905
CooperKit Hall Sensor measures the Hall Effect with A3144, the output of the Hall sensor turns on when a magnetic field (south polarity) perpendicular to the Hall sensor exceeds the BOP threshold, and it switches low and turn off when the magnetic field disappears.
Reference: DWM18011601
RAK8211-NB iTracker combines NB-IoT+BLE+GPS+ 5 Sensors Development Board has BLE GPRS GPS three in one module perfectly solves the problem of data interaction and control in the outdoor environment and the three party platform.
Reference: DWM14121901
Cooperkit is a modular electronics platform. Each module has its own function, such as light sensing, wireless communication, etc.
Reference: DWM14121903
Cooperkit Buzzer is connected to the digital I / O port, when the output is low, buzzer will give a long sound. If it is connected to an analog pulse width modulation (PWM) output , the buzzer can produce a variety of tones, which can be made into the speaker of electronic organ.
Reference: DWM14121904
CooperKit DHT11 digital temperature & humidity sensor features a digital temperature & humidity sensor complex with a calibrated digital signal output. Its single-bus operation, extremely small size and low consumption enable it to be used in HVAC, automotive, weather stations, dehumidifier and other applications.
Reference: DWM24022901
The P-NUCLEO-LRWAN2 STM32 Nucleo starter pack is a development tool to learn and quickly develop low-power wide-area network (LPWAN) solutions. The pack contains both an LPWAN end-node and its related gateway.
Reference: DWM24030302
The USRP B210 SDR Kit is built-in with an Xilinx Spartan 6 XC6SLX150 FPGAFully Compatible with the original B210 SDR kit.
The B200 Advanced version can seamlessly replace the B200 Original version and provides dual-receive dual-transmit capability.
