- New

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
The LoRaWAN Pyranometer sensor measures solar radiation. It is suitable to be used to monitor solar activity in solar parks, solar-dependent systems, and others.
The LoRaWAN Pyranometer sensor measures solar radiation. It is suitable to be used to monitor solar activity in solar parks, solar-dependent systems, and others. In order to reduce the ambient temperature effect, a temperature compensation circuit is built into the sensor.
The form factor of the Sensor Hub allows for multiple and/or different sensors to be connected at the same time as well as a solar panel, creating a reliable solar-powered solution.
This solution is suitable in scenarios where solar energy is preferred/needed.
The Splitter cable can connect several Sensor Probes and Probe IOs to a single Sensor Hub port to be powered by the solar power source. The distance between the Sensor Hub and Sensor Probe/Probe IO can be extended via the Extension cable.
Full LoRaWAN band support
Based on RAK4630(MCU: nRF52840, Radio Chip: SX1262)
Support Bluetooth for easy setup
Support NFC for easy setup
RUI3-based firmware
Auto-detection of the power source
Auto-detection of the Sensor Probes
Power source:
+12 VDC at 1 A (12 W) power adapter(optional)
Support 12 VDC solar panel
4 x ER18505 Li-SOCl2 batteries holder (battery not included)
Embedded antenna
1 x internal: high-gain and high-efficiency LoRa antenna (also support NB-IoT)
1 x internal: NFC antenna
1 x internal: Bluetooth antenna
High-efficiency LoRa antenna 860~930 MHz
NFC tag for power on and smart connect over BLE
Prevent theft via the hall effect sensor on the exclusive mounting bracket
External interfaces:
2 x SP11 connector (IP67) for multiple-purpose sensors
The SP11 supports a 12 V power adapter and a solar panel kit for external power
IP66-rated waterproof enclosure
Distance between the sensors can be adjusted with the extension cable(default cable length is 2.5 meter)
Sensor Hub Enclosure dimensions:120 x 80 x 39 mm
Working environment:-30° C to +60° C Suitable for outdoor and indoor use
The RK200-03 Pyranometer sensor measures solar radiation. It is suitable to be used to monitor solar activity in solar parks, solar dependent systems, and others. In order to reduce the ambient temperature effect, a temperature compensation circuit is built into the sensor.
Parameter |
Value |
Spectral range |
300~3200nm |
Range |
0~2000W/m2 |
Sensitivity > |
7-14μV*W-1*m2 |
Measuring angle |
2π solid angle |
Response time |
≤35s (99%) |
Cosine correction |
≤±7% (solar elevation angle=10° |
Temperature effect |
±2% (-10~+40℃) |
Stability |
±2%/year |
Operating temperature |
-40~+80℃ |
1 x Sensor Hub
1 x Sensor Probe IO
1 x Pyranometer solar radiation sensor
1 x Mounting kit for the sensor
1 x Power supply for the Sensor Hub
Reference: DWM20022601
LSN50-V2 Waterproof Long Range Wireless LoRa Sensor Node with external antenna,It is designed for outdoor use and powered by Li/SOCl2 battery for long term use.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22121301
RAK7248 Raspberry Pi 4 option RAM for 2G,4G and 8G Based LoRaWAN Gateway RAK WisGate Developer D4H/D4H+/D4HP RAK7248/RAK7248P/RAK7248C.
Reference: DWM22122903
The LoRaWAN Sensor Hub weather station is equipped with high-precision sensors that measure wind speed and direction, atmospheric pressure, humidity, and temperature. It is suitable for Smart Cities, Smart Farms, Smart Agricultural, environmental monitoring, and other use cases.
Reference: DWM20053103
Brand: Semtech
The DWM-RAK4600 development board allows access to all serial and GPIO ports for easy configuration. The RAK4600 core module includes nRF52832 MCU and SX1276 LoRa® chip to help you quickly and easily develop/test your firmware.
Reference: DWM19070803
RAK7258 Micro Gateway is a full 8-channel LoRa Gateway with built-in Ethernet connectivity for a straightforward setup. Additionally, there is an onboard Wi-Fi setup that allows it to be easily configured via the default Wi-Fi AP mode.
Reference: DWM20053102
Brand: Semtech
DWM-RAK4600 LPWAN Module includes an nRF52832 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 2.0uA in sleep mode, high LoRa® output power up to 20dB max in work mode, and BLE output power up to 4dBm.
Reference: ODL22062201
LoRaWAN Development kit Create IoT applications for different solutions, like environmental sensing, agriculture solutions, GPS trackers.
Reference: DWM22123001
The Raspberry Pi 4 Model B is the best single-board computer to develop your IoT project, and start your first gateway for NB-IoT/Cat-M and LoRaWAN with the RAK Pi HAT.
Reference: DWM20053101
Brand: Semtech
DWM-RAK4200 LPWAN Module includes an STM32L071 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 1.5uA in sleep mode and high LoRa® output power up to 19dBm max in work mode.
Reference: DWM23010804
RAK7434 Bridge is an analog to digital LoRaWAN® bridge designed for industrial applications. The device converts analog values received from sensors using a 0-5V signal to digital values and transmits them to the LoRaWAN network.
Reference: ODS22022502
RAK2287 /RAK5146 Pi HAT is a converter board with a Raspberry Pi form factor that enables the RAK2287 and RAK5146 LPWAN concentrator module to be mounted on the top of the Raspberry Pi.
Reference: DWM22121301
RAK7248 Raspberry Pi 4 option RAM for 2G,4G and 8G Based LoRaWAN Gateway RAK WisGate Developer D4H/D4H+/D4HP RAK7248/RAK7248P/RAK7248C.
Reference: DWM20053001
Brand: Semtech
The DWM-RAK4260 LPWAN Module is based on Microchip’s ATSAMR34J18B integrating a 32-bit ARM Cortex -M0+ MCU with a LoRa Transceive, provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM19070804
RAK7258 Micro Gateway is a full 8-channel LoRa Gateway with built-in Ethernet connectivity for a straightforward setup. Additionally, there is an onboard Wi-Fi setup that allows it to be easily configured via the default Wi-Fi AP mode.
Reference: DWM20060102
Brand: Semtech
DWM-RAK4200 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.it's utilized is of an Xbee form factor.
Reference: DWM22082504
The RAK4630 module delivers a powerful Nordic nRF52840 MCU with BLE 5.0 paired to the latest LoRa® transceivers from Semtech, the SX126x series.
Reference: DWM22101701
DWM-M702 seven-in-one sensor module is a cost-effective digital serial port output sensor module, which adopts 485/UART output mode and integrates CO2, HCHO, TVOC,PM2.5,PM10, temperature and humidity.
Reference: DWM22082505
RAK3172 based on STM32WLE5CC chip is a low-power long-range transceiver module for LoRa and LoRaWAN applications.
Reference: DWM22122905
The LoRaWANenvironmental monitoring and moving detection solution includes a combination of the Temperature and Humidity Sensor and the 3-axis Acceleration Sensor inside the Sensor Probe.
The LoRaWAN Pyranometer sensor measures solar radiation. It is suitable to be used to monitor solar activity in solar parks, solar-dependent systems, and others.