Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
The Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.The LoRa Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
Compatible with 3.3v or 5v I/O Arduino Board.
Frequency Band: 915MHz /868 MHZ/433 MHZ (Pre-configure in factory)
Low power consumption
Compatible with Arduino Leonardo, Uno, Mega, DUE
External Antenna via I-Pex connector
168 dB maximum link budget.
+20 dBm - 100 mW constant RF output vs.
+14 dBm high efficiency PA.
Programmable bit rate up to 300 kbps.
High sensitivity: down to -148 dBm.
Bullet-proof front end: IIP3 = -12.5 dBm.
Excellent blocking immunity.
Low RX current of 10.3 mA, 200 nA register retention.
Fully integrated synthesizer with a resolution of 61 Hz.
FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation.
Built-in bit synchronizer for clock recovery.
Preamble detection.
127 dB Dynamic Range RSSI.
Automatic RF Sense and CAD with ultra-fast AFC.
Packet engine up to 256 bytes with CRC.
Built-in temperature sensor and low battery indicator.
1x LoRa shield board
1x LoRa Antenna
Reference: DWM14032106
The Arduino Uno Rev3 is a microcontroller board based on the ATmega328.
Reference: DWM14041802
HopeRF DK / EVB module kits with number kinds of module which will plug into the DK & EVB board.
Reference: DWM16122301
The Lora BEE is based on the SX1276/SX1278 transceiver.The Lora BEE targets professional wireless sensor network applications such as irrigation systems, smart metering, smart cities, smartphone detection,building automation.
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM23061501
The PS-LB-T or PS-LB-I sensors are LoRaWAN Pressure Sensors for the Internet of Things solution. PS-LB can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM24022601
The PS-LS-T sensors is powered by solar power + li-on battery with an Thread Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM25022702
The MDS120-NB is an NB-IoT Microwave Radar Distance Sensor that uses Microwave Radar to detect the distance between the sensor and different objects Measure Range: 15 ~ 1200cm.
Reference: DWM23021007
The LHT65S-NE117 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor use an external probe uses TI TMP117A NIST traceability temperature sensor, with 0.1°C accuracy in normal temperature range.
Reference: DWM25030203
PS-NB-T NB-IOT Thread Installation LoRaWAN Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
Reference: DWM17102702
LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM18120402
Brand: Semtech
DWM-1278S 433MHz /470MHz sx1278 LoRa transceiver RF module compatible with RFM98W feature the LoRaTM long range module build by the semtech SX1278 chipset with the application for ARM meters.
Reference: DWM22072103
LA66 is a ready-to-use module that includesLoRaWAN v1.0.4 protocol and also supports open-source peer-to-peer LoRa Protocol for the none-LoRaWAN application.
Reference: DWM22082512
The PG1302 is a multi-channel high performance transmitter/receiver designed to simultaneously receive several LoRa packets using random spreading factors on random channels which is fully compatible with RPi3B/3B+/4.
Reference: DWM23070202
S31B-LB is a LoRaWAN Temperature and Humidity Sensor with a SHT31 sensor probe based SN50v3-LB or LSN50V3 supports BLE configure and wireless OTA update.
Reference: DWM23072305
The LDS40-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor supports BLE configure and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: DWM24030102
TS01-LS is powered by a solar panel LoRaWAN Tilting Sensor for detecting large-scale equipment and supports BLE configuration and wireless OTA update.
Reference: DWM25011401
SN50v3-NB is a Long Range NB-IoT Sensor Node based on the BC660K-GL model that supports uplink methods including MQTT, MQTTs, UDP & TCP. supports BLE configuration and OTA update supports uplinks to various IoT Servers.
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: DWM22040502
WSC1-L Dragino Weather Station solution Main Process Unit can upload these sensor data to IoT server via LoRaWAN wireless protocol.
Reference: DWM23122601
SDI-12-NB is an SDI-12 to NB-IoT Converter that supports BLE configuration and OTA update and is designed for Smart Agriculture sensors and Weather Station.
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
