Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The SW3L-LB is a new LoRaWAN Outdoor water Flow Sensor supports BLE configure and wireless OTA update which use to detects water flow volume and uplink to IoT server via LoRaWAN network it can be used at indoor and outdoor use.
The Dragino SW3L-LB is a LoRaWAN Flow Sensor. It detects water flow volume and uplink to IoT server via LoRaWAN network. User can use this to monitor the water usage for buildings.
The SW3L-LB will send water flow volume every 20 minutes. It can also detect the water flow status and send Alarm, to avoid the waste for water usage such as broken toilet case.
SW3L-LB is designed for both indoor and outdoor use. It has a weatherproof enclosure and industrial level battery to work in low to high temperatures.
The LoRa wireless technology used in SW3L-LB allows device to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity whilst minimizing current consumption.
SW3L-LB supports BLE configure and wireless OTA update which make user easy to use.
SW3L-LB is powered by 8500mAh Li-SOCI2 battery, it is designed for long term use up to 5 years.
Each SW3L-LB is pre-load with a set of unique keys for LoRaWAN registrations, register these keys to local LoRaWAN server and it will auto connect after power on.
LoRaWAN v1.0.3 Class A protocol
Bands:CN470/EU433/KR920/US915/EU868/AS923/AU915/IN865/RU864
Ultra-low power consumption
Upload water flow volume
Monitor water waste
AT Commands to change parameters
Supports Datalog feature
Support Bluetooth v5.1 and LoRaWAN remote configure
Support wireless OTA update firmware
Uplink on periodically and open/close event
Downlink to change configure
8500mAh Battery for long term use
Supply Voltage: built in 8500mAh Li-SOCI2 battery , 2.5v ~ 3.6v
Operating Temperature: -40 ~ 85°C
Frequency Range, Band 1 (HF): 862 ~ 1020 Mhz
Max +22 dBm constant RF output vs.
RX sensitivity: down to -139 dBm.
Excellent blocking immunity
Li/SOCI2 un-chargeable battery
Capacity: 8500mAh
Self-Discharge: <1% / Year @ 25°C
Max continuously current: 130mA
Max boost current: 2A, 1 second
Sleep Mode: 5uA @ 3.3v
LoRa Transmit Mode: 125mA @ 20dBm, 82mA @ 14dBm
Flow Sensor application
Water Control
Toilet Flow Sensor
Monitor Waste water
Part Number: SW3L-LB-XXX-YYY
AS923: LoRaWAN AS923 band
AU915: LoRaWAN AU915 band
EU433: LoRaWAN EU433 band
EU868: LoRaWAN EU868 band
KR920: LoRaWAN KR920 band
US915: LoRaWAN US915 band
IN865: LoRaWAN IN865 band
CN470: LoRaWAN CN470 band
004: DW-004 Flow Sensor: diameter: G1/2” / DN15. 450 pulse = 1 L
006: DW-006 Flow Sensor: diameter: G3/4” / DN20. 390 pulse = 1 L
010: DW-010 Flow Sensor: diameter: G 1” / DN25. 64 pulse = 1 L
SW3L-LB Water Flow Sensor x 1
Reference: DWM20061501
The Dragino LSE01 is a LoRaWAN Soil Moisture & EC Sensor for IoT of Agriculture. It detects Soil Moisture, Soil Temperature and Soil Conductivity, and upload the value via wireless to LoRaWAN IoT Server.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22051801
The LHT65N is a Long Range LoRaWAN Sensor nodes with Temperature & Humidity sensor which external sensor connector can be used for more than 10 years.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM24012401
The MS48-LR is an open-source LoRaWAN To Modbus Gateway. it can connect virous LoRaWAN devices to MS48-LR, and use PLC to access these devices via Modbus network.
Reference: DWM23050802
PS-LB-NA convert the Analog Value to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway. supports BLE configure and wireless OTA update.
Reference: DWM22092201
WSS-05 is a 4 in 1 RS485 sensor which can monitor Temperature, Humidity, Illuminance and Pressure at the same time which can work with WSC1-L or WSC2-LB weather station main processor.
Reference: DWM18110901
Setting up a LoRa peer-2-peer communication by using CY8CKIT-062-BLE with Arduino Shield (Dragino LoRa, RFM95W).
Reference: DWM24022602
The PS-LS-I sensors is powered by solar power + li-on battery with an Immersion Installation Type Air Water Pressure sensor which can measure Air, Water pressure and liquid level and upload the sensor data via wireless to LoRaWAN IoT server.
Reference: DWM22051601
The DLOS8N /DLOS8N-EC25 Outdoor LoRaWAN Gateway includes 1pcs SX1302 and 2pcs SX1250 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM22082510
The Dragino LMDS200 is a LoRaWAN Microwave Radar distance sensor which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: DWM23101803
The S31-NB and S31B-NB are NB-IoT Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via NB-IoT network.
Reference: DWM19011502
The OLG01-N is an Water proof outdoor setting open source single channel LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM21010104
The LSN50v2-S31 is a LoRaWAN Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM18073001
LG02-P is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM22082512
The PG1302 is a multi-channel high performance transmitter/receiver designed to simultaneously receive several LoRa packets using random spreading factors on random channels which is fully compatible with RPi3B/3B+/4.
Reference: DWM19121101
ATmega328P LoRa Radio Node is based on SX1276/SX1278 which use the Arduino pro mini 8Mhz 3.3V bootloader, usage same as the Arduino pro mini.
Reference: DWM18112901
LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM18120402
Brand: Semtech
DWM-1278S 433MHz /470MHz sx1278 LoRa transceiver RF module compatible with RFM98W feature the LoRaTM long range module build by the semtech SX1278 chipset with the application for ARM meters.
Reference: DWM22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
The SW3L-LB is a new LoRaWAN Outdoor water Flow Sensor supports BLE configure and wireless OTA update which use to detects water flow volume and uplink to IoT server via LoRaWAN network it can be used at indoor and outdoor use.
