Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM17111002
LoRa Antenna-433MHz High Gain internal aerial piamater FPC Antenna with IPEX connctor.
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
The Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.The LoRa Shield allows the user to send data and reach extremely long ranges at low data-rates.It provides ultra-long range spread spectrum communication and high interference immunity whilst minimising current consumption.
Compatible with 3.3v or 5v I/O Arduino Board.
Frequency Band: 915MHz /868 MHZ/433 MHZ (Pre-configure in factory)
Low power consumption
Compatible with Arduino Leonardo, Uno, Mega, DUE
External Antenna via I-Pex connector
168 dB maximum link budget.
+20 dBm - 100 mW constant RF output vs.
+14 dBm high efficiency PA.
Programmable bit rate up to 300 kbps.
High sensitivity: down to -148 dBm.
Bullet-proof front end: IIP3 = -12.5 dBm.
Excellent blocking immunity.
Low RX current of 10.3 mA, 200 nA register retention.
Fully integrated synthesizer with a resolution of 61 Hz.
FSK, GFSK, MSK, GMSK, LoRa™ and OOK modulation.
Built-in bit synchronizer for clock recovery.
Preamble detection.
127 dB Dynamic Range RSSI.
Automatic RF Sense and CAD with ultra-fast AFC.
Packet engine up to 256 bytes with CRC.
Built-in temperature sensor and low battery indicator.
1x LoRa shield board
1x LoRa Antenna
Reference: DWM14032106
The Arduino Uno Rev3 is a microcontroller board based on the ATmega328.
Reference: DWM14041802
HopeRF DK / EVB module kits with number kinds of module which will plug into the DK & EVB board.
Reference: DWM16122301
The Lora BEE is based on the SX1276/SX1278 transceiver.The Lora BEE targets professional wireless sensor network applications such as irrigation systems, smart metering, smart cities, smartphone detection,building automation.
Reference: DWM16122302
The Lora/GPS Arduino Shield is with 433MHz /868MHz /915MHz Versions is a expension board of LoRa™/GPS for use with the arduino.This product is intended for those interested in developing LoRa™/GPS solutions.
Reference: DWM18022201
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: DWM21010101
LBT1 is a Long Range / low power consumption LoRaWAN Bluetooth tracker. LBT1 scans and find the nearest i-Beacon info and send to IoT server via LoRaWAN wireless network.
Reference: DWM23030701
MH-Z19E NDIR infrared gas module Built-in temperature compensation; and it has UART output and PWM output It uses the principle of non-dispersive infrared (NDIR) to detect CO2 in the air and has good selectivity. No oxygen dependence, long life, etc.
Reference: DWM17110902
L80-R is an ultra compact GPS POT (Patch on Top) module with an embedded 15.0mm × 15.0mm × 4.0mm patch antenna.
Reference: DWM22071401
The LPS8v2 is an open-source Debian system LoRaWAN Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi , Ethernet and also with 4G Cellular Network capability.
Reference: DWM23021003
The NMDS200 is a NB-IoT Microwave Radar distance sensor. It uses 24Ghz Microwave to detect the distance between sensor and different objects. It can sense correct distance even there is water or thick dust on top of the sensor.
Reference: DWM23122601
SDI-12-NB is a SDI-12 to NB-IoT Converter supports BLE configure and OTA update and designed for Smart Agriculture sensor and Weather Station.
Reference: DWM21051603
The LSNPK01 is a LoRaWAN Soil NPK Sensor for IoT of Agriculturebase. detects soil's Nitrogen, Phosphorus, and Potassium use TDR method, and uploads these values via wireless to LoRaWAN IoT Server.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM24011201
The LDS12-NB is a NB-IoT LiDAR ToF (Time of Flight) Distance Sensor It is capable to measure the distance to an object as close as 10 centimeters (+/- 5cm up to 6m) and as far as 12 meters (+/-1% starting at 6m) can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection,...
Reference: DWM23072305
The LDS40-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor supports BLE configure and wireless OTA update can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: DWM18101201
The OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM21010102
BCN01 is designed for the use together with LBT1 LoRaWAN Indoor Position Solution base on NORDIC NRF52832 IC and support Bluetooth 4.2 protocol.
Reference: DWM18110501
LG308 8 Channels Indoor LoRaWAN Pico Gateway is an open source LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: DWM24012401
The MS48-LR is an open-source LoRaWAN To Modbus Gateway. it can connect virous LoRaWAN devices to MS48-LR, and use PLC to access these devices via Modbus network.
Reference: DWM22091403
ES-261520 3.6V 8500mAh Li/ SOCI2 Battery for Dragino IOT sensor nodes like the LSN50-V2, LSN50v2-D20, LDDS75, LSE01,20, LSN50-V2-S31.
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
