Connecting USB AVRISP XPII to the target board
(Click on the image to enlarge)

AT AVRISP mkII compliant
- Compatible with AT AVR ISP, easy to use, stable and reliable

Based on AT AVRISP mkII firmware
- Identified as AVRISP mkII in AVRStudio, high speed programming

Upgradable firmware
- Firmware is upgradable to Support Future Devices
- Automatic Upgrade

Supported software
- AVR Studio 4/5/6 or WINAVR(GCC) is used as front-end software
- Supports the program files generated by IAR, ICCAVR, CVAVR

Device Support
- USB AVRISP XPII supports all AVR devices with ISP and PDI Interface. Support for new devices will be added with new versions of AVR Studio.
- Supports AT86RF401/AT89S51/AT89S52

Refer to AVR Studio 5, the following devices are supported:

Supports all the different voltages and speed grade versions of the devices listed in the table above.
Check more supported devices : UC3, Mega, SAM , Tiny, Xmega

Performance
- High speed programs FLASH , EEPROM, Fuses, and Lock Bit
- It takes only 2.5S to program a 12K program file with verification (programming speed was set to 1M while the Max speed could be up to 8M)

Connects to PC
- Uses a USB interface for communication with the front-end software (Probably AVR Studio)
- Using PDIUSBD12, USB 1.1 (USB 2.0 Full Speed) 12Mbits/second
- Each USB AVRISP XPII has a unique ID, a PC could connects to several Devices at the same time

Figure 1. 10-pin ISP Connector

Figure 2. 6-pin ISP Connector